#include "../common/i2c_commands.h"
#include "main.h"
+#include "robotsim.h"
#include "ax12_user.h"
#include "strat.h"
#include "cmdline.h"
#include "sensor.h"
#include "actuator.h"
#include "cs.h"
+#include "strat_base.h"
#include "i2c_protocol.h"
/* 0 means "programmed"
struct cobboard cobboard;
struct ballboard ballboard;
+#ifndef HOST_VERSION
/***********************/
void bootloader(void)
if ((cpt & 0x3) == 0)
scheduler_interrupt();
}
+#endif
int main(void)
{
- uint16_t seconds;
-
+#ifndef HOST_VERSION
/* brake */
BRAKE_DDR();
BRAKE_OFF();
LED2_OFF();
LED3_OFF();
LED4_OFF();
+#endif
memset(&gen, 0, sizeof(gen));
memset(&mainboard, 0, sizeof(mainboard));
/* UART */
uart_init();
+ uart_register_rx_event(CMDLINE_UART, emergency);
+#ifndef HOST_VERSION
#if CMDLINE_UART == 3
fdevopen(uart3_dev_send, uart3_dev_recv);
- uart_register_rx_event(3, emergency);
#elif CMDLINE_UART == 1
fdevopen(uart1_dev_send, uart1_dev_recv);
- uart_register_rx_event(1, emergency);
-#else
-# error not supported
#endif
- eeprom_write_byte(EEPROM_MAGIC_ADDRESS, EEPROM_MAGIC_MAINBOARD);
+ //eeprom_write_byte(EEPROM_MAGIC_ADDRESS, EEPROM_MAGIC_MAINBOARD);
/* check eeprom to avoid to run the bad program */
if (eeprom_read_byte(EEPROM_MAGIC_ADDRESS) !=
EEPROM_MAGIC_MAINBOARD) {
printf_P(PSTR("Bad eeprom value\r\n"));
while(1);
}
+#endif /* ! HOST_VERSION */
/* LOGS */
error_register_emerg(mylog);
error_register_notice(mylog);
error_register_debug(mylog);
+#ifndef HOST_VERSION
/* SPI + ENCODERS */
encoders_spi_init(); /* this will also init spi hardware */
PWM_NG_INIT16(&gen.servo4, 5, C, 10, PWM_NG_MODE_NORMAL,
NULL, 0);
support_balls_deploy(); /* init pwm for servos */
+#endif /* !HOST_VERSION */
/* SCHEDULER */
scheduler_init();
+#ifdef HOST_VERSION
+ hostsim_init();
+ robotsim_init();
+#endif
+#ifndef HOST_VERSION
scheduler_add_periodical_event_priority(do_led_blink, NULL,
100000L / SCHEDULER_UNIT,
LED_PRIO);
+#endif /* !HOST_VERSION */
+
/* all cs management */
microb_cs_init();
+#ifndef HOST_VERSION
/* sensors, will also init hardware adc */
sensor_init();
/* start i2c slave polling */
scheduler_add_periodical_event_priority(i2c_poll_slaves, NULL,
8000L / SCHEDULER_UNIT, I2C_POLL_PRIO);
+#endif /* !HOST_VERSION */
/* strat */
gen.logs[0] = E_USER_STRAT;
25000L / SCHEDULER_UNIT,
STRAT_PRIO);
+#ifndef HOST_VERSION
/* eeprom time monitor */
scheduler_add_periodical_event_priority(do_time_monitor, NULL,
1000000L / SCHEDULER_UNIT,
EEPROM_TIME_PRIO);
+#endif /* !HOST_VERSION */
sei();
printf_P(PSTR("\r\n"));
printf_P(PSTR("Respect et robustesse.\r\n"));
- seconds = eeprom_read_word(EEPROM_TIME_ADDRESS);
- printf_P(PSTR("Running since %d mn %d\r\n"), seconds/60, seconds%60);
+#ifndef HOST_VERSION
+ {
+ uint16_t seconds;
+ seconds = eeprom_read_word(EEPROM_TIME_ADDRESS);
+ printf_P(PSTR("Running since %d mn %d\r\n"), seconds/60, seconds%60);
+ }
+#endif
+
+#ifdef HOST_VERSION
+ strat_reset_pos(1000, 1000, -90);
+#endif
+
cmdline_interact();
return 0;