-/*-
- * BSD LICENSE
- *
- * Copyright(c) 2010-2014 Intel Corporation. All rights reserved.
- * All rights reserved.
- *
- * Redistribution and use in source and binary forms, with or without
- * modification, are permitted provided that the following conditions
- * are met:
- *
- * * Redistributions of source code must retain the above copyright
- * notice, this list of conditions and the following disclaimer.
- * * Redistributions in binary form must reproduce the above copyright
- * notice, this list of conditions and the following disclaimer in
- * the documentation and/or other materials provided with the
- * distribution.
- * * Neither the name of Intel Corporation nor the names of its
- * contributors may be used to endorse or promote products derived
- * from this software without specific prior written permission.
- *
- * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
- * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
- * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
- * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
- * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
- * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
- * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
- * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
- * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
- * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
- * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+/* SPDX-License-Identifier: BSD-3-Clause
+ * Copyright(c) 2010-2014 Intel Corporation
*/
#include <stdint.h>
int mp_size = NB_MBUF;
struct flow_conf qos_conf[MAX_DATA_STREAMS];
-static const struct rte_eth_conf port_conf = {
+static struct rte_eth_conf port_conf = {
.rxmode = {
- .max_rx_pkt_len = ETHER_MAX_LEN,
+ .max_rx_pkt_len = RTE_ETHER_MAX_LEN,
.split_hdr_size = 0,
- .header_split = 0, /**< Header Split disabled */
- .hw_ip_checksum = 0, /**< IP checksum offload disabled */
- .hw_vlan_filter = 0, /**< VLAN filtering disabled */
- .jumbo_frame = 0, /**< Jumbo Frame Support disabled */
- .hw_strip_crc = 1, /**< CRC stripped by hardware */
},
.txmode = {
.mq_mode = ETH_DCB_NONE,
{
int ret;
struct rte_eth_link link;
+ struct rte_eth_dev_info dev_info;
struct rte_eth_rxconf rx_conf;
struct rte_eth_txconf tx_conf;
uint16_t rx_size;
uint16_t tx_size;
+ struct rte_eth_conf local_port_conf = port_conf;
/* check if port already initialized (multistream configuration) */
if (app_inited_port_mask & (1u << portid))
rx_conf.rx_thresh.wthresh = rx_thresh.wthresh;
rx_conf.rx_free_thresh = 32;
rx_conf.rx_drop_en = 0;
+ rx_conf.rx_deferred_start = 0;
tx_conf.tx_thresh.pthresh = tx_thresh.pthresh;
tx_conf.tx_thresh.hthresh = tx_thresh.hthresh;
tx_conf.tx_thresh.wthresh = tx_thresh.wthresh;
tx_conf.tx_free_thresh = 0;
tx_conf.tx_rs_thresh = 0;
- tx_conf.txq_flags = ETH_TXQ_FLAGS_NOMULTSEGS | ETH_TXQ_FLAGS_NOOFFLOADS;
+ tx_conf.tx_deferred_start = 0;
/* init port */
RTE_LOG(INFO, APP, "Initializing port %"PRIu16"... ", portid);
fflush(stdout);
- ret = rte_eth_dev_configure(portid, 1, 1, &port_conf);
+ rte_eth_dev_info_get(portid, &dev_info);
+ if (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_MBUF_FAST_FREE)
+ local_port_conf.txmode.offloads |=
+ DEV_TX_OFFLOAD_MBUF_FAST_FREE;
+ ret = rte_eth_dev_configure(portid, 1, 1, &local_port_conf);
if (ret < 0)
rte_exit(EXIT_FAILURE,
"Cannot configure device: err=%d, port=%u\n",
/* init one RX queue */
fflush(stdout);
+ rx_conf.offloads = local_port_conf.rxmode.offloads;
ret = rte_eth_rx_queue_setup(portid, 0, (uint16_t)ring_conf.rx_size,
rte_eth_dev_socket_id(portid), &rx_conf, mp);
if (ret < 0)
/* init one TX queue */
fflush(stdout);
+ tx_conf.offloads = local_port_conf.txmode.offloads;
ret = rte_eth_tx_queue_setup(portid, 0,
(uint16_t)ring_conf.tx_size, rte_eth_dev_socket_id(portid), &tx_conf);
if (ret < 0)
char ring_name[MAX_NAME_LEN];
char pool_name[MAX_NAME_LEN];
- if (rte_eth_dev_count() == 0)
+ if (rte_eth_dev_count_avail() == 0)
rte_exit(EXIT_FAILURE, "No Ethernet port - bye\n");
/* load configuration profile */