* same order as on the wire.
*/
struct rte_flow_item_eth {
- struct ether_addr dst; /**< Destination MAC. */
- struct ether_addr src; /**< Source MAC. */
+ struct rte_ether_addr dst; /**< Destination MAC. */
+ struct rte_ether_addr src; /**< Source MAC. */
rte_be16_t type; /**< EtherType or TPID. */
};
* Matches an 802.1Q/ad VLAN tag.
*
* The corresponding standard outer EtherType (TPID) values are
- * ETHER_TYPE_VLAN or ETHER_TYPE_QINQ. It can be overridden by the preceding
- * pattern item.
+ * RTE_ETHER_TYPE_VLAN or RTE_ETHER_TYPE_QINQ. It can be overridden by
+ * the preceding pattern item.
*/
struct rte_flow_item_vlan {
rte_be16_t tci; /**< Tag control information. */
* Matches a E-tag header.
*
* The corresponding standard outer EtherType (TPID) value is
- * ETHER_TYPE_ETAG. It can be overridden by the preceding pattern item.
+ * RTE_ETHER_TYPE_ETAG. It can be overridden by the preceding pattern item.
*/
struct rte_flow_item_e_tag {
/**
* Matches an ESP header.
*/
struct rte_flow_item_esp {
- struct esp_hdr hdr; /**< ESP header definition. */
+ struct rte_esp_hdr hdr; /**< ESP header definition. */
};
/** Default mask for RTE_FLOW_ITEM_TYPE_ESP. */
uint8_t hln; /**< Hardware address length, normally 6. */
uint8_t pln; /**< Protocol address length, normally 4. */
rte_be16_t op; /**< Opcode (1 for request, 2 for reply). */
- struct ether_addr sha; /**< Sender hardware address. */
+ struct rte_ether_addr sha; /**< Sender hardware address. */
rte_be32_t spa; /**< Sender IPv4 address. */
- struct ether_addr tha; /**< Target hardware address. */
+ struct rte_ether_addr tha; /**< Target hardware address. */
rte_be32_t tpa; /**< Target IPv4 address. */
};
struct rte_flow_item_icmp6_nd_opt_sla_eth {
uint8_t type; /**< ND option type, normally 1. */
uint8_t length; /**< ND option length, normally 1. */
- struct ether_addr sla; /**< Source Ethernet LLA. */
+ struct rte_ether_addr sla; /**< Source Ethernet LLA. */
};
/** Default mask for RTE_FLOW_ITEM_TYPE_ICMP6_ND_OPT_SLA_ETH. */
struct rte_flow_item_icmp6_nd_opt_tla_eth {
uint8_t type; /**< ND option type, normally 2. */
uint8_t length; /**< ND option length, normally 1. */
- struct ether_addr tla; /**< Target Ethernet LLA. */
+ struct rte_ether_addr tla; /**< Target Ethernet LLA. */
};
/** Default mask for RTE_FLOW_ITEM_TYPE_ICMP6_ND_OPT_TLA_ETH. */
* Set MAC address from the matched flow
*/
struct rte_flow_action_set_mac {
- uint8_t mac_addr[ETHER_ADDR_LEN];
+ uint8_t mac_addr[RTE_ETHER_ADDR_LEN];
};
/*