X-Git-Url: http://git.droids-corp.org/?a=blobdiff_plain;f=drivers%2Fnet%2Fhns3%2Fhns3_ethdev.h;h=f3cc88f43e9aa9a63531094e16c0cb326f7de392;hb=11f99cfc886fff5e7c60218c50d993227871460f;hp=fa08fadc94970cc5657bc6aad6ae55db36aba143;hpb=2fc3e696a7f1925b20664b9de15f2430b9b68208;p=dpdk.git

diff --git a/drivers/net/hns3/hns3_ethdev.h b/drivers/net/hns3/hns3_ethdev.h
index fa08fadc94..f3cc88f43e 100644
--- a/drivers/net/hns3/hns3_ethdev.h
+++ b/drivers/net/hns3/hns3_ethdev.h
@@ -190,10 +190,10 @@ struct hns3_mac {
 	uint8_t mac_addr[RTE_ETHER_ADDR_LEN];
 	uint8_t media_type;
 	uint8_t phy_addr;
-	uint8_t link_duplex  : 1; /* ETH_LINK_[HALF/FULL]_DUPLEX */
-	uint8_t link_autoneg : 1; /* ETH_LINK_[AUTONEG/FIXED] */
-	uint8_t link_status  : 1; /* ETH_LINK_[DOWN/UP] */
-	uint32_t link_speed;      /* ETH_SPEED_NUM_ */
+	uint8_t link_duplex  : 1; /* RTE_ETH_LINK_[HALF/FULL]_DUPLEX */
+	uint8_t link_autoneg : 1; /* RTE_ETH_LINK_[AUTONEG/FIXED] */
+	uint8_t link_status  : 1; /* RTE_ETH_LINK_[DOWN/UP] */
+	uint32_t link_speed;      /* RTE_ETH_SPEED_NUM_ */
 	/*
 	 * Some firmware versions support only the SFP speed query. In addition
 	 * to the SFP speed query, some firmware supports the query of the speed
@@ -428,6 +428,17 @@ struct hns3_reset_data {
 	struct hns3_wait_data *wait_data;
 };
 
+struct hns3_hw_ops {
+	int (*add_mc_mac_addr)(struct hns3_hw *hw,
+				struct rte_ether_addr *mac_addr);
+	int (*del_mc_mac_addr)(struct hns3_hw *hw,
+				struct rte_ether_addr *mac_addr);
+	int (*add_uc_mac_addr)(struct hns3_hw *hw,
+				struct rte_ether_addr *mac_addr);
+	int (*del_uc_mac_addr)(struct hns3_hw *hw,
+				struct rte_ether_addr *mac_addr);
+};
+
 #define HNS3_INTR_MAPPING_VEC_RSV_ONE		0
 #define HNS3_INTR_MAPPING_VEC_ALL		1
 
@@ -622,7 +633,7 @@ struct hns3_hw {
 	 *  - HNS3_SPECIAL_PORT_SW_CKSUM_MODE
 	 *     In this mode, HW can not do checksum for special UDP port like
 	 *     4789, 4790, 6081 for non-tunnel UDP packets and UDP tunnel
-	 *     packets without the PKT_TX_TUNEL_MASK in the mbuf. So, PMD need
+	 *     packets without the RTE_MBUF_F_TX_TUNEL_MASK in the mbuf. So, PMD need
 	 *     do the checksum for these packets to avoid a checksum error.
 	 *
 	 *  - HNS3_SPECIAL_PORT_HW_CKSUM_MODE
@@ -638,6 +649,8 @@ struct hns3_hw {
 	struct hns3_rss_filter_list flow_rss_list; /* flow RSS rule list */
 	struct hns3_flow_mem_list flow_list;
 
+	struct hns3_hw_ops ops;
+
 	/*
 	 * PMD setup and configuration is not thread safe. Since it is not
 	 * performance sensitive, it is better to guarantee thread-safety
@@ -1048,6 +1061,14 @@ void hns3vf_update_link_status(struct hns3_hw *hw, uint8_t link_status,
 			  uint32_t link_speed, uint8_t link_duplex);
 void hns3_parse_devargs(struct rte_eth_dev *dev);
 void hns3vf_update_push_lsc_cap(struct hns3_hw *hw, bool supported);
+int hns3_configure_all_mc_mac_addr(struct hns3_adapter *hns, bool del);
+int hns3_configure_all_mac_addr(struct hns3_adapter *hns, bool del);
+int hns3_add_mac_addr(struct rte_eth_dev *dev, struct rte_ether_addr *mac_addr,
+		__rte_unused uint32_t idx, __rte_unused uint32_t pool);
+void hns3_remove_mac_addr(struct rte_eth_dev *dev, uint32_t idx);
+int hns3_set_mc_mac_addr_list(struct rte_eth_dev *dev,
+			struct rte_ether_addr *mc_addr_set,
+							uint32_t nb_mc_addr);
 int hns3_restore_ptp(struct hns3_adapter *hns);
 int hns3_mbuf_dyn_rx_timestamp_register(struct rte_eth_dev *dev,
 				    struct rte_eth_conf *conf);
@@ -1079,9 +1100,9 @@ static inline uint64_t
 hns3_txvlan_cap_get(struct hns3_hw *hw)
 {
 	if (hw->port_base_vlan_cfg.state)
-		return DEV_TX_OFFLOAD_VLAN_INSERT;
+		return RTE_ETH_TX_OFFLOAD_VLAN_INSERT;
 	else
-		return DEV_TX_OFFLOAD_VLAN_INSERT | DEV_TX_OFFLOAD_QINQ_INSERT;
+		return RTE_ETH_TX_OFFLOAD_VLAN_INSERT | RTE_ETH_TX_OFFLOAD_QINQ_INSERT;
 }
 
 #endif /* _HNS3_ETHDEV_H_ */