From: Shy Shyman Date: Mon, 8 Jun 2020 14:17:47 +0000 (+0300) Subject: app/testpmd: fix error detection in MTU command X-Git-Url: http://git.droids-corp.org/?a=commitdiff_plain;h=3b931ddb5e1fe8b29caafbad53738005ee9fef0c;p=dpdk.git app/testpmd: fix error detection in MTU command MTU is used in testpmd to set the maximum payload size for packets. According to testpmd, the setting influence RX only. In rte_ethdev there's no relation between MTU setting and JUMBO offload or rx_max_pkt_len. The previous fix in patch referenced below was meant to update the correlated variables of max_pkt_len and JUMBO offload, but by doing so it assumes that MTU setting can only exist when JUMBO offload supported in the device. For example fail-safe device does supports set MTU and doesn't support JUMBO offload, and in this case, though set MTU succeeds, an error message is still printed since the JUMBO packet offload is disabled. The fix separates the two conditions to make sure the error triggers only in case the set_mtu action actually failed. Fixes: 150c9ac2df13 ("app/testpmd: update Rx offload after setting MTU") Cc: stable@dpdk.org Signed-off-by: Shy Shyman Reviewed-by: Ferruh Yigit Reviewed-by: Phil Yang --- diff --git a/app/test-pmd/config.c b/app/test-pmd/config.c index 016bcb09c4..a7112c998b 100644 --- a/app/test-pmd/config.c +++ b/app/test-pmd/config.c @@ -1281,8 +1281,9 @@ port_mtu_set(portid_t port_id, uint16_t mtu) return; } diag = rte_eth_dev_set_mtu(port_id, mtu); - if (diag == 0 && - dev_info.rx_offload_capa & DEV_RX_OFFLOAD_JUMBO_FRAME) { + if (diag) + printf("Set MTU failed. diag=%d\n", diag); + else if (dev_info.rx_offload_capa & DEV_RX_OFFLOAD_JUMBO_FRAME) { /* * Ether overhead in driver is equal to the difference of * max_rx_pktlen and max_mtu in rte_eth_dev_info when the @@ -1297,10 +1298,7 @@ port_mtu_set(portid_t port_id, uint16_t mtu) } else rte_port->dev_conf.rxmode.offloads &= ~DEV_RX_OFFLOAD_JUMBO_FRAME; - - return; } - printf("Set MTU failed. diag=%d\n", diag); } /* Generic flow management functions. */