doc: remove references to make from Linux guide

[dpdk.git] / doc / guides / linux_gsg / enable_func.rst

diff --git a/doc/guides/linux_gsg/enable_func.rst b/doc/guides/linux_gsg/enable_func.rst
index b2bda80..06c17e4 100644 (file)
--- a/doc/guides/linux_gsg/enable_func.rst
+++ b/doc/guides/linux_gsg/enable_func.rst
@@ -41,7 +41,9 @@ Enabling HPET in the DPDK
 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 
 By default, HPET support is disabled in the DPDK build configuration files.
-To use HPET, the ``CONFIG_RTE_LIBEAL_USE_HPET`` setting should be changed to ``y``, which will enable the HPET settings at compile time.
+To use HPET, use the following meson build option which will enable the HPET settings at compile time::
+
+   meson configure -Duse_hpet=true
 
 For an application to use the ``rte_get_hpet_cycles()`` and ``rte_get_hpet_hz()`` API calls,
 and optionally to make the HPET the default time source for the rte_timer library,
@@ -128,13 +130,10 @@ Loading the DPDK KNI Kernel Module
 ----------------------------------
 
 To run the DPDK Kernel NIC Interface (KNI) sample application, an extra kernel module (the kni module) must be loaded into the running kernel.
-The module is found in the kmod sub-directory of the DPDK target directory.
-Similar to the loading of the ``igb_uio`` module, this module should be loaded using the insmod command as shown below
-(assuming that the current directory is the DPDK target directory):
-
-.. code-block:: console
+The module is found in the kernel/linux sub-directory of the DPDK build directory.
+It should be loaded using the insmod command::
 
-   insmod kmod/rte_kni.ko
+   insmod <build_dir>/kernel/linux/kni/rte_kni.ko
 
 .. note::