-.. BSD LICENSE
+.. SPDX-License-Identifier: BSD-3-Clause
Copyright (c) 2017, Cisco Systems, Inc.
All rights reserved.
- Redistribution and use in source and binary forms, with or without
- modification, are permitted provided that the following conditions
- are met:
-
- 1. Redistributions of source code must retain the above copyright
- notice, this list of conditions and the following disclaimer.
-
- 2. Redistributions in binary form must reproduce the above copyright
- notice, this list of conditions and the following disclaimer in
- the documentation and/or other materials provided with the
- distribution.
-
- THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
- "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
- LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS
- FOR A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE
- COPYRIGHT HOLDER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT,
- INCIDENTAL, SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING,
- BUT NOT LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES;
- LOSS OF USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER
- CAUSED AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
- LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN
- ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
- POSSIBILITY OF SUCH DAMAGE.
-
ENIC Poll Mode Driver
=====================
--------------------------------------
ENIC PMD support is integrated into the DPDK suite. dpdk-<version>.tar.gz
-should be downloaded from http://dpdk.org
+should be downloaded from http://core.dpdk.org/download/
Configuration information
- Selectors: 'is', 'spec' and 'mask'. 'last' is not supported
- In total, up to 64 bytes of mask is allowed across all headers
+- **1400 and later series VICS with advanced filters enabled**
+
+ All the above plus:
+
+ - Action: count
+
More features may be added in future firmware and new versions of the VIC.
Please refer to the release notes.
-w 12:00.0,disable-overlay=1
+By default, the NIC uses 4789 as the VXLAN port. The user may change
+it through ``rte_eth_dev_udp_tunnel_port_{add,delete}``. However, as
+the current NIC has a single VXLAN port number, the user cannot
+configure multiple port numbers.
+
+Ingress VLAN Rewrite
+--------------------
+
+VIC adapters can tag, untag, or modify the VLAN headers of ingress
+packets. The ingress VLAN rewrite mode controls this behavior. By
+default, it is set to pass-through, where the NIC does not modify the
+VLAN header in any way so that the application can see the original
+header. This mode is sufficient for many applications, but may not be
+suitable for others. Such applications may change the mode by setting
+``devargs`` parameter ``ig-vlan-rewrite`` to one of the following.
+
+- ``pass``: Pass-through mode. The NIC does not modify the VLAN
+ header. This is the default mode.
+
+- ``priority``: Priority-tag default VLAN mode. If the ingress packet
+ is tagged with the default VLAN, the NIC replaces its VLAN header
+ with the priority tag (VLAN ID 0).
+
+- ``trunk``: Default trunk mode. The NIC tags untagged ingress packets
+ with the default VLAN. Tagged ingress packets are not modified. To
+ the application, every packet appears as tagged.
+
+- ``untag``: Untag default VLAN mode. If the ingress packet is tagged
+ with the default VLAN, the NIC removes or untags its VLAN header so
+ that the application sees an untagged packet. As a result, the
+ default VLAN becomes `untagged`. This mode can be useful for
+ applications such as OVS-DPDK performance benchmarks that utilize
+ only the default VLAN and want to see only untagged packets.
+
+
+Vectorized Rx Handler
+---------------------
+
+ENIC PMD includes a version of the receive handler that is vectorized using
+AVX2 SIMD instructions. It is meant for bulk, throughput oriented workloads
+where reducing cycles/packet in PMD is a priority. In order to use the
+vectorized handler, take the following steps.
+
+- Use a recent version of gcc, icc, or clang and build 64-bit DPDK. If
+ the compiler is known to support AVX2, DPDK build system
+ automatically compiles the vectorized handler. Otherwise, the
+ handler is not available.
+
+- Set ``devargs`` parameter ``enable-avx2-rx=1`` to explicitly request that
+ PMD consider the vectorized handler when selecting the receive handler.
+ For example::
+
+ -w 12:00.0,enable-avx2-rx=1
+
+ As the current implementation is intended for field trials, by default, the
+ vectorized handler is not considered (``enable-avx2-rx=0``).
+
+- Run on a UCS M4 or later server with CPUs that support AVX2.
+
+PMD selects the vectorized handler when the handler is compiled into
+the driver, the user requests its use via ``enable-avx2-rx=1``, CPU
+supports AVX2, and scatter Rx is not used. To verify that the
+vectorized handler is selected, enable debug logging
+(``--log-level=pmd,debug``) and check the following message.
+
+.. code-block:: console
+
+ enic_use_vector_rx_handler use the non-scatter avx2 Rx handler
+
.. _enic_limitations:
Limitations
In test setups where an Ethernet port of a Cisco adapter in TRUNK mode is
connected point-to-point to another adapter port or connected though a router
instead of a switch, all ingress packets will be VLAN tagged. Programs such
- as l3fwd which do not account for VLAN tags in packets will misbehave. The
- solution is to enable VLAN stripping on ingress. The following code fragment is
- an example of how to accomplish this:
+ as l3fwd may not account for VLAN tags in packets and may misbehave. One
+ solution is to enable VLAN stripping on ingress so the VLAN tag is removed
+ from the packet and put into the mbuf->vlan_tci field. Here is an example
+ of how to accomplish this:
.. code-block:: console
vlan_offload |= ETH_VLAN_STRIP_OFFLOAD;
rte_eth_dev_set_vlan_offload(port, vlan_offload);
+Another alternative is modify the adapter's ingress VLAN rewrite mode so that
+packets with the default VLAN tag are stripped by the adapter and presented to
+DPDK as untagged packets. In this case mbuf->vlan_tci and the PKT_RX_VLAN and
+PKT_RX_VLAN_STRIPPED mbuf flags would not be set. This mode is enabled with the
+``devargs`` parameter ``ig-vlan-rewrite=untag``. For example::
+
+ -w 12:00.0,ig-vlan-rewrite=untag
+
- Limited flow director support on 1200 series and 1300 series Cisco VIC
adapters with old firmware. Please see :ref:`enic-flow-director`.
- ``rx_good_bytes`` (ibytes) always includes VLAN header (4B) and CRC bytes (4B).
This behavior applies to 1300 and older series VIC adapters.
+ 1400 series VICs do not count CRC bytes, and count VLAN header only when VLAN
+ stripping is disabled.
- When the NIC drops a packet because the Rx queue has no free buffers,
``rx_good_bytes`` still increments by 4B if the packet is not VLAN tagged or
VLAN stripping is disabled, or by 8B if the packet is VLAN tagged and stripping
- is enabled. This behavior applies to 1300 and older series VIC adapters.
+ is enabled.
+ This behavior applies to 1300 and older series VIC adapters. 1400 series VICs
+ do not increment this byte counter when packets are dropped.
- **RSS Hashing**
- VIC 1200 series
- VIC 1300 series
+- VIC 1400 series
Supported Operating Systems
---------------------------
- VLAN filtering (supported via UCSM/CIMC only)
- Execution of application by unprivileged system users
- IPV4, IPV6 and TCP RSS hashing
-- UDP RSS hashing (support for upcoming adapters)
+- UDP RSS hashing (1400 series and later adapters)
- Scattered Rx
- MTU update
- SR-IOV on UCS managed servers connected to Fabric Interconnects
maintainers:
- John Daley <johndale@cisco.com>
-- Nelson Escobar <neescoba@cisco.com>
+- Hyong Youb Kim <hyonkim@cisco.com>
git.droids-corp.org / dpdk.git / blobdiff