AXGBE_MDIO_MODE_CL45,
};
+struct axgbe_phy {
+ uint32_t supported;
+ uint32_t advertising;
+ uint32_t lp_advertising;
+
+ int address;
+
+ int autoneg;
+ int speed;
+ int duplex;
+
+ int link;
+
+ int pause_autoneg;
+ int tx_pause;
+ int rx_pause;
+};
+
+enum axgbe_i2c_cmd {
+ AXGBE_I2C_CMD_READ = 0,
+ AXGBE_I2C_CMD_WRITE,
+};
+
+struct axgbe_i2c_op {
+ enum axgbe_i2c_cmd cmd;
+
+ unsigned int target;
+
+ uint8_t *buf;
+ unsigned int len;
+};
+
+struct axgbe_i2c_op_state {
+ struct axgbe_i2c_op *op;
+
+ unsigned int tx_len;
+ unsigned char *tx_buf;
+
+ unsigned int rx_len;
+ unsigned char *rx_buf;
+
+ unsigned int tx_abort_source;
+
+ int ret;
+};
+
+struct axgbe_i2c {
+ unsigned int started;
+ unsigned int max_speed_mode;
+ unsigned int rx_fifo_size;
+ unsigned int tx_fifo_size;
+
+ struct axgbe_i2c_op_state op_state;
+};
+
struct axgbe_hw_if {
void (*config_flow_control)(struct axgbe_port *);
int (*config_rx_mode)(struct axgbe_port *);
int (*exit)(struct axgbe_port *);
};
+/* This structure represents implementation specific routines for an
+ * implementation of a PHY. All routines are required unless noted below.
+ * Optional routines:
+ * kr_training_pre, kr_training_post
+ */
+struct axgbe_phy_impl_if {
+ /* Perform Setup/teardown actions */
+ int (*init)(struct axgbe_port *);
+ void (*exit)(struct axgbe_port *);
+
+ /* Perform start/stop specific actions */
+ int (*reset)(struct axgbe_port *);
+ int (*start)(struct axgbe_port *);
+ void (*stop)(struct axgbe_port *);
+
+ /* Return the link status */
+ int (*link_status)(struct axgbe_port *, int *);
+
+ /* Indicate if a particular speed is valid */
+ int (*valid_speed)(struct axgbe_port *, int);
+
+ /* Check if the specified mode can/should be used */
+ bool (*use_mode)(struct axgbe_port *, enum axgbe_mode);
+ /* Switch the PHY into various modes */
+ void (*set_mode)(struct axgbe_port *, enum axgbe_mode);
+ /* Retrieve mode needed for a specific speed */
+ enum axgbe_mode (*get_mode)(struct axgbe_port *, int);
+ /* Retrieve new/next mode when trying to auto-negotiate */
+ enum axgbe_mode (*switch_mode)(struct axgbe_port *);
+ /* Retrieve current mode */
+ enum axgbe_mode (*cur_mode)(struct axgbe_port *);
+
+ /* Retrieve current auto-negotiation mode */
+ enum axgbe_an_mode (*an_mode)(struct axgbe_port *);
+
+ /* Configure auto-negotiation settings */
+ int (*an_config)(struct axgbe_port *);
+
+ /* Set/override auto-negotiation advertisement settings */
+ unsigned int (*an_advertising)(struct axgbe_port *port);
+
+ /* Process results of auto-negotiation */
+ enum axgbe_mode (*an_outcome)(struct axgbe_port *);
+
+ /* Pre/Post KR training enablement support */
+ void (*kr_training_pre)(struct axgbe_port *);
+ void (*kr_training_post)(struct axgbe_port *);
+};
+
+struct axgbe_phy_if {
+ /* For PHY setup/teardown */
+ int (*phy_init)(struct axgbe_port *);
+ void (*phy_exit)(struct axgbe_port *);
+
+ /* For PHY support when setting device up/down */
+ int (*phy_reset)(struct axgbe_port *);
+ int (*phy_start)(struct axgbe_port *);
+ void (*phy_stop)(struct axgbe_port *);
+
+ /* For PHY support while device is up */
+ void (*phy_status)(struct axgbe_port *);
+ int (*phy_config_aneg)(struct axgbe_port *);
+
+ /* For PHY settings validation */
+ int (*phy_valid_speed)(struct axgbe_port *, int);
+ /* For single interrupt support */
+ void (*an_isr)(struct axgbe_port *);
+ /* PHY implementation specific services */
+ struct axgbe_phy_impl_if phy_impl;
+};
+
+struct axgbe_i2c_if {
+ /* For initial I2C setup */
+ int (*i2c_init)(struct axgbe_port *);
+
+ /* For I2C support when setting device up/down */
+ int (*i2c_start)(struct axgbe_port *);
+ void (*i2c_stop)(struct axgbe_port *);
+
+ /* For performing I2C operations */
+ int (*i2c_xfer)(struct axgbe_port *, struct axgbe_i2c_op *);
+};
+
/* This structure contains flags that indicate what hardware features
* or configurations are present in the device.
*/
};
struct axgbe_version_data {
+ void (*init_function_ptrs_phy_impl)(struct axgbe_phy_if *);
enum axgbe_xpcs_access xpcs_access;
unsigned int mmc_64bit;
unsigned int tx_max_fifo_size;
unsigned long dev_state;
struct axgbe_hw_if hw_if;
+ struct axgbe_phy_if phy_if;
+ struct axgbe_i2c_if i2c_if;
/* AXI DMA settings */
unsigned int coherent;
struct axgbe_hw_features hw_feat;
struct ether_addr mac_addr;
+
+ /* MDIO/PHY related settings */
+ unsigned int phy_started;
+ void *phy_data;
+ struct axgbe_phy phy;
+ int mdio_mmd;
+ unsigned long link_check;
+ volatile int mdio_completion;
+
+ unsigned int kr_redrv;
+
+ /* Auto-negotiation atate machine support */
+ unsigned int an_int;
+ unsigned int an_status;
+ enum axgbe_an an_result;
+ enum axgbe_an an_state;
+ enum axgbe_rx kr_state;
+ enum axgbe_rx kx_state;
+ unsigned int an_supported;
+ unsigned int parallel_detect;
+ unsigned int fec_ability;
+ unsigned long an_start;
+ enum axgbe_an_mode an_mode;
+
+ /* I2C support */
+ struct axgbe_i2c i2c;
+ volatile int i2c_complete;
};
void axgbe_init_function_ptrs_dev(struct axgbe_hw_if *hw_if);
+void axgbe_init_function_ptrs_phy(struct axgbe_phy_if *phy_if);
+void axgbe_init_function_ptrs_phy_v2(struct axgbe_phy_if *phy_if);
+void axgbe_init_function_ptrs_i2c(struct axgbe_i2c_if *i2c_if);
+
#endif /* RTE_ETH_AXGBE_H_ */
git.droids-corp.org / dpdk.git / blobdiff