-/*-
- * BSD LICENSE
- *
- * Copyright(c) 2010-2014 Intel Corporation. All rights reserved.
- * All rights reserved.
- *
- * Redistribution and use in source and binary forms, with or without
- * modification, are permitted provided that the following conditions
- * are met:
- *
- * * Redistributions of source code must retain the above copyright
- * notice, this list of conditions and the following disclaimer.
- * * Redistributions in binary form must reproduce the above copyright
- * notice, this list of conditions and the following disclaimer in
- * the documentation and/or other materials provided with the
- * distribution.
- * * Neither the name of Intel Corporation nor the names of its
- * contributors may be used to endorse or promote products derived
- * from this software without specific prior written permission.
- *
- * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
- * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
- * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
- * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
- * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
- * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
- * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
- * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
- * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
- * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
- * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+/* SPDX-License-Identifier: BSD-3-Clause
+ * Copyright(c) 2010-2014 Intel Corporation
*/
#include <stdio.h>
#include <rte_log.h>
#include <rte_memory.h>
#include <rte_memcpy.h>
-#include <rte_memzone.h>
#include <rte_eal.h>
#include <rte_per_lcore.h>
#include <rte_launch.h>
#include <rte_lcore.h>
#include <rte_branch_prediction.h>
#include <rte_interrupts.h>
-#include <rte_pci.h>
+#include <rte_bus_pci.h>
#include <rte_debug.h>
#include <rte_ether.h>
#include <rte_ethdev.h>
/* Options for configuring ethernet port */
static struct rte_eth_conf port_conf = {
.rxmode = {
- .header_split = 0, /* Header Split disabled */
- .hw_ip_checksum = 0, /* IP checksum offload disabled */
- .hw_vlan_filter = 0, /* VLAN filtering disabled */
- .jumbo_frame = 0, /* Jumbo Frame Support disabled */
- .hw_strip_crc = 1, /* CRC stripped by hardware */
+ .ignore_offload_bitfield = 1,
+ .offloads = DEV_RX_OFFLOAD_CRC_STRIP,
},
.txmode = {
.mq_mode = ETH_MQ_TX_NONE,
/* Initialise a single port on an Ethernet device */
static void
-init_port(uint8_t port)
+init_port(uint16_t port)
{
int ret;
uint16_t nb_rxd = NB_RXD;
uint16_t nb_txd = NB_TXD;
+ struct rte_eth_dev_info dev_info;
+ struct rte_eth_rxconf rxq_conf;
+ struct rte_eth_txconf txq_conf;
+ struct rte_eth_conf local_port_conf = port_conf;
/* Initialise device and RX/TX queues */
RTE_LOG(INFO, APP, "Initialising port %u ...\n", (unsigned)port);
fflush(stdout);
- ret = rte_eth_dev_configure(port, 1, 1, &port_conf);
+ rte_eth_dev_info_get(port, &dev_info);
+ if (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_MBUF_FAST_FREE)
+ local_port_conf.txmode.offloads |=
+ DEV_TX_OFFLOAD_MBUF_FAST_FREE;
+ ret = rte_eth_dev_configure(port, 1, 1, &local_port_conf);
if (ret < 0)
rte_exit(EXIT_FAILURE, "Could not configure port%u (%d)\n",
(unsigned)port, ret);
rte_exit(EXIT_FAILURE, "Could not adjust number of descriptors "
"for port%u (%d)\n", (unsigned)port, ret);
+ rxq_conf = dev_info.default_rxconf;
+ rxq_conf.offloads = local_port_conf.rxmode.offloads;
ret = rte_eth_rx_queue_setup(port, 0, nb_rxd,
- rte_eth_dev_socket_id(port), NULL, pktmbuf_pool);
+ rte_eth_dev_socket_id(port), &rxq_conf, pktmbuf_pool);
if (ret < 0)
rte_exit(EXIT_FAILURE, "Could not setup up RX queue for "
"port%u (%d)\n", (unsigned)port, ret);
+ txq_conf = dev_info.default_txconf;
+ txq_conf.txq_flags = ETH_TXQ_FLAGS_IGNORE;
+ txq_conf.offloads = local_port_conf.txmode.offloads;
ret = rte_eth_tx_queue_setup(port, 0, nb_txd,
- rte_eth_dev_socket_id(port), NULL);
+ rte_eth_dev_socket_id(port), &txq_conf);
if (ret < 0)
rte_exit(EXIT_FAILURE, "Could not setup up TX queue for "
"port%u (%d)\n", (unsigned)port, ret);
/* Check the link status of all ports in up to 9s, and print them finally */
static void
-check_all_ports_link_status(uint8_t port_num, uint32_t port_mask)
+check_all_ports_link_status(uint16_t port_num, uint32_t port_mask)
{
#define CHECK_INTERVAL 100 /* 100ms */
#define MAX_CHECK_TIME 90 /* 9s (90 * 100ms) in total */
- uint8_t portid, count, all_ports_up, print_flag = 0;
+ uint16_t portid;
+ uint8_t count, all_ports_up, print_flag = 0;
struct rte_eth_link link;
printf("\nChecking link status\n");
/* print link status if flag set */
if (print_flag == 1) {
if (link.link_status)
- printf("Port %d Link Up - speed %u "
- "Mbps - %s\n", (uint8_t)portid,
- (unsigned)link.link_speed,
+ printf(
+ "Port%d Link Up - speed %uMbps - %s\n",
+ portid, link.link_speed,
(link.link_duplex == ETH_LINK_FULL_DUPLEX) ?
("full-duplex") : ("half-duplex\n"));
else
- printf("Port %d Link Down\n",
- (uint8_t)portid);
+ printf("Port %d Link Down\n", portid);
continue;
}
/* clear all_ports_up flag if any link down */
kni_change_mtu(uint16_t port_id, unsigned int new_mtu)
{
int ret;
+ uint16_t nb_rxd = NB_RXD;
struct rte_eth_conf conf;
+ struct rte_eth_dev_info dev_info;
+ struct rte_eth_rxconf rxq_conf;
if (port_id >= rte_eth_dev_count()) {
RTE_LOG(ERR, APP, "Invalid port id %d\n", port_id);
memcpy(&conf, &port_conf, sizeof(conf));
/* Set new MTU */
if (new_mtu > ETHER_MAX_LEN)
- conf.rxmode.jumbo_frame = 1;
+ conf.rxmode.offloads |= DEV_RX_OFFLOAD_JUMBO_FRAME;
else
- conf.rxmode.jumbo_frame = 0;
+ conf.rxmode.offloads &= ~DEV_RX_OFFLOAD_JUMBO_FRAME;
/* mtu + length of header + length of FCS = max pkt length */
conf.rxmode.max_rx_pkt_len = new_mtu + KNI_ENET_HEADER_SIZE +
return ret;
}
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(port_id, &nb_rxd, NULL);
+ if (ret < 0)
+ rte_exit(EXIT_FAILURE, "Could not adjust number of descriptors "
+ "for port%u (%d)\n", (unsigned int)port_id,
+ ret);
+
+ rte_eth_dev_info_get(port_id, &dev_info);
+ rxq_conf = dev_info.default_rxconf;
+ rxq_conf.offloads = conf.rxmode.offloads;
+ ret = rte_eth_rx_queue_setup(port_id, 0, nb_rxd,
+ rte_eth_dev_socket_id(port_id), &rxq_conf, pktmbuf_pool);
+ if (ret < 0) {
+ RTE_LOG(ERR, APP, "Fail to setup Rx queue of port %d\n",
+ port_id);
+ return ret;
+ }
+
/* Restart specific port */
ret = rte_eth_dev_start(port_id);
if (ret < 0) {
memset(&dev_info, 0, sizeof(dev_info));
rte_eth_dev_info_get(port_id, &dev_info);
- conf.addr = dev_info.pci_dev->addr;
- conf.id = dev_info.pci_dev->id;
+
+ if (dev_info.pci_dev) {
+ conf.addr = dev_info.pci_dev->addr;
+ conf.id = dev_info.pci_dev->id;
+ }
memset(&ops, 0, sizeof(ops));
ops.port_id = port_id;
git.droids-corp.org / dpdk.git / blobdiff