-/*-
- * BSD LICENSE
- *
- * Copyright(c) 2010-2014 Intel Corporation. All rights reserved.
- * All rights reserved.
- *
- * Redistribution and use in source and binary forms, with or without
- * modification, are permitted provided that the following conditions
- * are met:
- *
- * * Redistributions of source code must retain the above copyright
- * notice, this list of conditions and the following disclaimer.
- * * Redistributions in binary form must reproduce the above copyright
- * notice, this list of conditions and the following disclaimer in
- * the documentation and/or other materials provided with the
- * distribution.
- * * Neither the name of Intel Corporation nor the names of its
- * contributors may be used to endorse or promote products derived
- * from this software without specific prior written permission.
- *
- * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
- * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
- * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
- * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
- * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
- * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
- * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
- * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
- * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
- * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
- * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+/* SPDX-License-Identifier: BSD-3-Clause
+ * Copyright(c) 2010-2014 Intel Corporation
*/
#include <stdio.h>
#include <rte_log.h>
#include <rte_memory.h>
#include <rte_memcpy.h>
-#include <rte_memzone.h>
-#include <rte_tailq.h>
#include <rte_eal.h>
-#include <rte_per_lcore.h>
#include <rte_launch.h>
#include <rte_atomic.h>
#include <rte_cycles.h>
#include <rte_per_lcore.h>
#include <rte_branch_prediction.h>
#include <rte_interrupts.h>
-#include <rte_pci.h>
#include <rte_random.h>
#include <rte_debug.h>
#include <rte_ether.h>
.rxmode = {
.mq_mode = ETH_MQ_RX_RSS,
.split_hdr_size = 0,
- .header_split = 0, /**< Header Split disabled */
- .hw_ip_checksum = 1, /**< IP checksum offload enabled */
- .hw_vlan_filter = 0, /**< VLAN filtering disabled */
- .jumbo_frame = 0, /**< Jumbo Frame Support disabled */
- .hw_strip_crc = 0, /**< CRC stripped by hardware */
+ .ignore_offload_bitfield = 1,
+ .offloads = (DEV_RX_OFFLOAD_CHECKSUM |
+ DEV_RX_OFFLOAD_CRC_STRIP),
},
.rx_adv_conf = {
.rss_conf = {
},
};
-static struct rte_eth_rxconf rx_conf = {
- .rx_thresh = {
- .pthresh = APP_DEFAULT_NIC_RX_PTHRESH,
- .hthresh = APP_DEFAULT_NIC_RX_HTHRESH,
- .wthresh = APP_DEFAULT_NIC_RX_WTHRESH,
- },
- .rx_free_thresh = APP_DEFAULT_NIC_RX_FREE_THRESH,
- .rx_drop_en = APP_DEFAULT_NIC_RX_DROP_EN,
-};
-
-static struct rte_eth_txconf tx_conf = {
- .tx_thresh = {
- .pthresh = APP_DEFAULT_NIC_TX_PTHRESH,
- .hthresh = APP_DEFAULT_NIC_TX_HTHRESH,
- .wthresh = APP_DEFAULT_NIC_TX_WTHRESH,
- },
- .tx_free_thresh = APP_DEFAULT_NIC_TX_FREE_THRESH,
- .tx_rs_thresh = APP_DEFAULT_NIC_TX_RS_THRESH,
-};
-
static void
app_assign_worker_ids(void)
{
snprintf(name, sizeof(name), "mbuf_pool_%u", socket);
printf("Creating the mbuf pool for socket %u ...\n", socket);
- app.pools[socket] = rte_mempool_create(
- name,
- APP_DEFAULT_MEMPOOL_BUFFERS,
- APP_DEFAULT_MBUF_SIZE,
+ app.pools[socket] = rte_pktmbuf_pool_create(
+ name, APP_DEFAULT_MEMPOOL_BUFFERS,
APP_DEFAULT_MEMPOOL_CACHE_SIZE,
- sizeof(struct rte_pktmbuf_pool_private),
- rte_pktmbuf_pool_init, NULL,
- rte_pktmbuf_init, NULL,
- socket,
- 0);
+ 0, APP_DEFAULT_MBUF_DATA_SIZE, socket);
if (app.pools[socket] == NULL) {
rte_panic("Cannot create mbuf pool on socket %u\n", socket);
}
continue;
}
+ struct rte_lpm_config lpm_config;
+
+ lpm_config.max_rules = APP_MAX_LPM_RULES;
+ lpm_config.number_tbl8s = 256;
+ lpm_config.flags = 0;
snprintf(name, sizeof(name), "lpm_table_%u", socket);
printf("Creating the LPM table for socket %u ...\n", socket);
app.lpm_tables[socket] = rte_lpm_create(
name,
socket,
- APP_MAX_LPM_RULES,
- 0);
+ &lpm_config);
if (app.lpm_tables[socket] == NULL) {
rte_panic("Unable to create LPM table on socket %u\n", socket);
}
continue;
}
- if (app_get_lcore_for_nic_tx((uint8_t) port, &lcore_io) < 0) {
+ if (app_get_lcore_for_nic_tx(port, &lcore_io) < 0) {
rte_panic("Algorithmic error (no I/O core to handle TX of port %u)\n",
port);
}
/* Check the link status of all ports in up to 9s, and print them finally */
static void
-check_all_ports_link_status(uint8_t port_num, uint32_t port_mask)
+check_all_ports_link_status(uint16_t port_num, uint32_t port_mask)
{
#define CHECK_INTERVAL 100 /* 100ms */
#define MAX_CHECK_TIME 90 /* 9s (90 * 100ms) in total */
- uint8_t portid, count, all_ports_up, print_flag = 0;
+ uint16_t portid;
+ uint8_t count, all_ports_up, print_flag = 0;
struct rte_eth_link link;
uint32_t n_rx_queues, n_tx_queues;
/* print link status if flag set */
if (print_flag == 1) {
if (link.link_status)
- printf("Port %d Link Up - speed %u "
- "Mbps - %s\n", (uint8_t)portid,
- (unsigned)link.link_speed,
+ printf(
+ "Port%d Link Up - speed %uMbps - %s\n",
+ portid, link.link_speed,
(link.link_duplex == ETH_LINK_FULL_DUPLEX) ?
("full-duplex") : ("half-duplex\n"));
else
- printf("Port %d Link Down\n",
- (uint8_t)portid);
+ printf("Port %d Link Down\n", portid);
continue;
}
/* clear all_ports_up flag if any link down */
- if (link.link_status == 0) {
+ if (link.link_status == ETH_LINK_DOWN) {
all_ports_up = 0;
break;
}
{
unsigned socket;
uint32_t lcore;
- uint8_t port, queue;
+ uint16_t port;
+ uint8_t queue;
int ret;
uint32_t n_rx_queues, n_tx_queues;
- if (rte_eal_pci_probe() < 0) {
- rte_panic("Cannot probe PCI\n");
- }
-
/* Init NIC ports and queues, then start the ports */
for (port = 0; port < APP_MAX_NIC_PORTS; port ++) {
struct rte_mempool *pool;
+ uint16_t nic_rx_ring_size;
+ uint16_t nic_tx_ring_size;
+ struct rte_eth_rxconf rxq_conf;
+ struct rte_eth_txconf txq_conf;
+ struct rte_eth_dev_info dev_info;
+ struct rte_eth_conf local_port_conf = port_conf;
n_rx_queues = app_get_nic_rx_queues_per_port(port);
n_tx_queues = app.nic_tx_port_mask[port];
}
/* Init port */
- printf("Initializing NIC port %u ...\n", (unsigned) port);
+ printf("Initializing NIC port %u ...\n", port);
+ rte_eth_dev_info_get(port, &dev_info);
+ if (dev_info.tx_offload_capa & DEV_TX_OFFLOAD_MBUF_FAST_FREE)
+ local_port_conf.txmode.offloads |=
+ DEV_TX_OFFLOAD_MBUF_FAST_FREE;
ret = rte_eth_dev_configure(
port,
(uint8_t) n_rx_queues,
(uint8_t) n_tx_queues,
- &port_conf);
+ &local_port_conf);
if (ret < 0) {
- rte_panic("Cannot init NIC port %u (%d)\n", (unsigned) port, ret);
+ rte_panic("Cannot init NIC port %u (%d)\n", port, ret);
}
rte_eth_promiscuous_enable(port);
+ nic_rx_ring_size = app.nic_rx_ring_size;
+ nic_tx_ring_size = app.nic_tx_ring_size;
+ ret = rte_eth_dev_adjust_nb_rx_tx_desc(
+ port, &nic_rx_ring_size, &nic_tx_ring_size);
+ if (ret < 0) {
+ rte_panic("Cannot adjust number of descriptors for port %u (%d)\n",
+ port, ret);
+ }
+ app.nic_rx_ring_size = nic_rx_ring_size;
+ app.nic_tx_ring_size = nic_tx_ring_size;
+
+ rxq_conf = dev_info.default_rxconf;
+ rxq_conf.offloads = local_port_conf.rxmode.offloads;
/* Init RX queues */
for (queue = 0; queue < APP_MAX_RX_QUEUES_PER_NIC_PORT; queue ++) {
if (app.nic_rx_queue_mask[port][queue] == 0) {
pool = app.lcore_params[lcore].pool;
printf("Initializing NIC port %u RX queue %u ...\n",
- (unsigned) port,
- (unsigned) queue);
+ port, queue);
ret = rte_eth_rx_queue_setup(
port,
queue,
(uint16_t) app.nic_rx_ring_size,
socket,
- &rx_conf,
+ &rxq_conf,
pool);
if (ret < 0) {
rte_panic("Cannot init RX queue %u for port %u (%d)\n",
- (unsigned) queue,
- (unsigned) port,
- ret);
+ queue, port, ret);
}
}
+ txq_conf = dev_info.default_txconf;
+ txq_conf.txq_flags = ETH_TXQ_FLAGS_IGNORE;
+ txq_conf.offloads = local_port_conf.txmode.offloads;
/* Init TX queues */
if (app.nic_tx_port_mask[port] == 1) {
app_get_lcore_for_nic_tx(port, &lcore);
socket = rte_lcore_to_socket_id(lcore);
printf("Initializing NIC port %u TX queue 0 ...\n",
- (unsigned) port);
+ port);
ret = rte_eth_tx_queue_setup(
port,
0,
(uint16_t) app.nic_tx_ring_size,
socket,
- &tx_conf);
+ &txq_conf);
if (ret < 0) {
rte_panic("Cannot init TX queue 0 for port %d (%d)\n",
port,
git.droids-corp.org / dpdk.git / blobdiff