/**< Total of RX packets dropped by the HW,
* because there are no available mbufs (i.e. RX queues are full).
*/
- uint64_t ibadcrc __rte_deprecated;
- /**< Deprecated; Total of RX packets with CRC error. */
- uint64_t ibadlen __rte_deprecated;
- /**< Deprecated; Total of RX packets with bad length. */
uint64_t ierrors; /**< Total number of erroneous received packets. */
uint64_t oerrors; /**< Total number of failed transmitted packets. */
- uint64_t imcasts;
- /**< Deprecated; Total number of multicast received packets. */
uint64_t rx_nombuf; /**< Total number of RX mbuf allocation failures. */
- uint64_t fdirmatch __rte_deprecated;
- /**< Deprecated; Total number of RX packets matching a filter. */
- uint64_t fdirmiss __rte_deprecated;
- /**< Deprecated; Total number of RX packets not matching any filter. */
- uint64_t tx_pause_xon __rte_deprecated;
- /**< Deprecated; Total nb. of XON pause frame sent. */
- uint64_t rx_pause_xon __rte_deprecated;
- /**< Deprecated; Total nb. of XON pause frame received. */
- uint64_t tx_pause_xoff __rte_deprecated;
- /**< Deprecated; Total nb. of XOFF pause frame sent. */
- uint64_t rx_pause_xoff __rte_deprecated;
- /**< Deprecated; Total nb. of XOFF pause frame received. */
uint64_t q_ipackets[RTE_ETHDEV_QUEUE_STAT_CNTRS];
/**< Total number of queue RX packets. */
uint64_t q_opackets[RTE_ETHDEV_QUEUE_STAT_CNTRS];
/**< Total number of successfully transmitted queue bytes. */
uint64_t q_errors[RTE_ETHDEV_QUEUE_STAT_CNTRS];
/**< Total number of queue packets received that are dropped. */
- uint64_t ilbpackets;
- /**< Total number of good packets received from loopback,VF Only */
- uint64_t olbpackets;
- /**< Total number of good packets transmitted to loopback,VF Only */
- uint64_t ilbbytes;
- /**< Total number of good bytes received from loopback,VF Only */
- uint64_t olbbytes;
- /**< Total number of good bytes transmitted to loopback,VF Only */
};
+/**
+ * Device supported speeds bitmap flags
+ */
+#define ETH_LINK_SPEED_AUTONEG (0 << 0) /**< Autonegotiate (all speeds) */
+#define ETH_LINK_SPEED_FIXED (1 << 0) /**< Disable autoneg (fixed speed) */
+#define ETH_LINK_SPEED_10M_HD (1 << 1) /**< 10 Mbps half-duplex */
+#define ETH_LINK_SPEED_10M (1 << 2) /**< 10 Mbps full-duplex */
+#define ETH_LINK_SPEED_100M_HD (1 << 3) /**< 100 Mbps half-duplex */
+#define ETH_LINK_SPEED_100M (1 << 4) /**< 100 Mbps full-duplex */
+#define ETH_LINK_SPEED_1G (1 << 5) /**< 1 Gbps */
+#define ETH_LINK_SPEED_2_5G (1 << 6) /**< 2.5 Gbps */
+#define ETH_LINK_SPEED_5G (1 << 7) /**< 5 Gbps */
+#define ETH_LINK_SPEED_10G (1 << 8) /**< 10 Gbps */
+#define ETH_LINK_SPEED_20G (1 << 9) /**< 20 Gbps */
+#define ETH_LINK_SPEED_25G (1 << 10) /**< 25 Gbps */
+#define ETH_LINK_SPEED_40G (1 << 11) /**< 40 Gbps */
+#define ETH_LINK_SPEED_50G (1 << 12) /**< 50 Gbps */
+#define ETH_LINK_SPEED_56G (1 << 13) /**< 56 Gbps */
+#define ETH_LINK_SPEED_100G (1 << 14) /**< 100 Gbps */
+
+/**
+ * Ethernet numeric link speeds in Mbps
+ */
+#define ETH_SPEED_NUM_NONE 0 /**< Not defined */
+#define ETH_SPEED_NUM_10M 10 /**< 10 Mbps */
+#define ETH_SPEED_NUM_100M 100 /**< 100 Mbps */
+#define ETH_SPEED_NUM_1G 1000 /**< 1 Gbps */
+#define ETH_SPEED_NUM_2_5G 2500 /**< 2.5 Gbps */
+#define ETH_SPEED_NUM_5G 5000 /**< 5 Gbps */
+#define ETH_SPEED_NUM_10G 10000 /**< 10 Gbps */
+#define ETH_SPEED_NUM_20G 20000 /**< 20 Gbps */
+#define ETH_SPEED_NUM_25G 25000 /**< 25 Gbps */
+#define ETH_SPEED_NUM_40G 40000 /**< 40 Gbps */
+#define ETH_SPEED_NUM_50G 50000 /**< 50 Gbps */
+#define ETH_SPEED_NUM_56G 56000 /**< 56 Gbps */
+#define ETH_SPEED_NUM_100G 100000 /**< 100 Gbps */
+
/**
* A structure used to retrieve link-level information of an Ethernet port.
*/
struct rte_eth_link {
- uint16_t link_speed; /**< ETH_LINK_SPEED_[10, 100, 1000, 10000] */
- uint16_t link_duplex; /**< ETH_LINK_[HALF_DUPLEX, FULL_DUPLEX] */
- uint8_t link_status : 1; /**< 1 -> link up, 0 -> link down */
-}__attribute__((aligned(8))); /**< aligned for atomic64 read/write */
-
-#define ETH_LINK_SPEED_AUTONEG 0 /**< Auto-negotiate link speed. */
-#define ETH_LINK_SPEED_10 10 /**< 10 megabits/second. */
-#define ETH_LINK_SPEED_100 100 /**< 100 megabits/second. */
-#define ETH_LINK_SPEED_1000 1000 /**< 1 gigabits/second. */
-#define ETH_LINK_SPEED_10000 10000 /**< 10 gigabits/second. */
-#define ETH_LINK_SPEED_10G 10000 /**< alias of 10 gigabits/second. */
-#define ETH_LINK_SPEED_20G 20000 /**< 20 gigabits/second. */
-#define ETH_LINK_SPEED_40G 40000 /**< 40 gigabits/second. */
+ uint32_t link_speed; /**< ETH_SPEED_NUM_ */
+ uint16_t link_duplex : 1; /**< ETH_LINK_[HALF/FULL]_DUPLEX */
+ uint16_t link_autoneg : 1; /**< ETH_LINK_SPEED_[AUTONEG/FIXED] */
+ uint16_t link_status : 1; /**< ETH_LINK_[DOWN/UP] */
+} __attribute__((aligned(8))); /**< aligned for atomic64 read/write */
-#define ETH_LINK_AUTONEG_DUPLEX 0 /**< Auto-negotiate duplex. */
-#define ETH_LINK_HALF_DUPLEX 1 /**< Half-duplex connection. */
-#define ETH_LINK_FULL_DUPLEX 2 /**< Full-duplex connection. */
+/* Utility constants */
+#define ETH_LINK_HALF_DUPLEX 0 /**< Half-duplex connection. */
+#define ETH_LINK_FULL_DUPLEX 1 /**< Full-duplex connection. */
+#define ETH_LINK_DOWN 0 /**< Link is down. */
+#define ETH_LINK_UP 1 /**< Link is up. */
+#define ETH_LINK_FIXED 0 /**< No autonegotiation. */
+#define ETH_LINK_AUTONEG 1 /**< Autonegotiated. */
/**
* A structure used to configure the ring threshold registers of an RX/TX
* configuration settings may be needed.
*/
struct rte_eth_conf {
- uint16_t link_speed;
- /**< ETH_LINK_SPEED_10[0|00|000], or 0 for autonegotation */
- uint16_t link_duplex;
- /**< ETH_LINK_[HALF_DUPLEX|FULL_DUPLEX], or 0 for autonegotation */
+ uint32_t link_speeds; /**< bitmap of ETH_LINK_SPEED_XXX of speeds to be
+ used. ETH_LINK_SPEED_FIXED disables link
+ autonegotiation, and a unique speed shall be
+ set. Otherwise, the bitmap defines the set of
+ speeds to be advertised. If the special value
+ ETH_LINK_SPEED_AUTONEG (0) is used, all speeds
+ supported are advertised. */
struct rte_eth_rxmode rxmode; /**< Port RX configuration. */
struct rte_eth_txmode txmode; /**< Port TX configuration. */
uint32_t lpbk_mode; /**< Loopback operation mode. By default the value
#define DEV_TX_OFFLOAD_OUTER_IPV4_CKSUM 0x00000080 /**< Used for tunneling packet. */
#define DEV_TX_OFFLOAD_QINQ_INSERT 0x00000100
+/**
+ * Ethernet device information
+ */
struct rte_eth_dev_info {
struct rte_pci_device *pci_dev; /**< Device PCI information. */
const char *driver_name; /**< Device Driver name. */
uint16_t vmdq_pool_base; /**< First ID of VMDQ pools. */
struct rte_eth_desc_lim rx_desc_lim; /**< RX descriptors limits */
struct rte_eth_desc_lim tx_desc_lim; /**< TX descriptors limits */
+ uint32_t speed_capa; /**< Supported speeds bitmap (ETH_LINK_SPEED_). */
};
/**
*/
void rte_eth_driver_register(struct eth_driver *eth_drv);
+/**
+ * Convert a numerical speed in Mbps to a bitmap flag that can be used in
+ * the bitmap link_speeds of the struct rte_eth_conf
+ *
+ * @param speed
+ * Numerical speed value in Mbps
+ * @param duplex
+ * ETH_LINK_[HALF/FULL]_DUPLEX (only for 10/100M speeds)
+ * @return
+ * 0 if the speed cannot be mapped
+ */
+uint32_t rte_eth_speed_bitflag(uint32_t speed, int duplex);
+
/**
* Configure an Ethernet device.
* This function must be invoked first before any other function in the
* @note
* Better to invoke this API after the device is already started or rx burst
* function is decided, to obtain correct supported ptypes.
+ * @note
+ * if a given PMD does not report what ptypes it supports, then the supported
+ * ptype count is reported as 0.
* @param port_id
* The port identifier of the Ethernet device.
* @param ptype_mask
* @param num
* Size of the array pointed by param ptypes.
* @return
- * - (>0) Number of supported ptypes. If it exceeds param num, exceeding
- * packet types will not be filled in the given array.
- * - (0 or -ENOTSUP) if PMD does not fill the specified ptype.
+ * - (>=0) Number of supported ptypes. If the number of types exceeds num,
+ * only num entries will be filled into the ptypes array, but the full
+ * count of supported ptypes will be returned.
* - (-ENODEV) if *port_id* invalid.
*/
int rte_eth_dev_get_supported_ptypes(uint8_t port_id, uint32_t ptype_mask,
git.droids-corp.org / dpdk.git / blobdiff