net/failsafe: fix reconfiguration
authorMatan Azrad <matan@mellanox.com>
Sun, 11 Feb 2018 17:27:34 +0000 (17:27 +0000)
committerThomas Monjalon <thomas@monjalon.net>
Tue, 13 Feb 2018 17:17:30 +0000 (18:17 +0100)
Fail-safe PMD manages the states of its sub-devices gradually:
DEV_UNDEFINED, DEV_PARSED, DEV_PROBED, DEV_ACTIVE, DEV_STARTED.

When the sub-device arguments successfully was parsed, the state is
raised from DEV_UNDEFINED to DEV_PARSED.
When the sub-device successfully was probed, the state is raised from
DEV_PARSED to DEV_PROBED.
When the sub-device successfully was configured by
rte_eth_dev_configure(), the state is raised from DEV_PROBED to
DEV_ACTIVE.
When the sub-device successfully was started by rte_eth_dev_start(), the
state is raised from DEV_ACTIVE to DEV_STARTED.

When the sub-device successfully was stopped by rte_eth_dev_stop(), the
state is degraded from DEV_STARTED to DEV_ACTIVE.
When the sub-device successfully was closed by rte_eth_dev_close(), the
state is degraded from DEV_ACTIVE to DEV_PROBED.
When the sub-device successfully was removed by
rte_eal_hotplug_remove(), the state is degraded from DEV_PROBED to
DEV_UNDEFINED.

Fail-safe dev_configure() operation calls to its sub-devices
dev_configure() operation, but only for sub-devices which are in
DEV_PROBED state, means that sub-devices which are in DEV_ACTIVE state
because the application triggered dev_stop() operation cannot be
reconfigured again by dev_configure() operation which is really
problematic when application wants to reconfigure its ports.
Actually, the application may get success report when some of the
sub-devices are not in the wanted configuration.

The current behavior of fail-safe dev_configure() is correct only for
the first time dev_configure() is triggered by the application or for
sub-device synchronization in plug-in event, but it ignores the option
for reconfiguration from application side.

Allow calling to sub-devices dev_configure() operations also in
DEV_ACTIVE state when the call was triggered by the application.

Fixes: a46f8d584eb8 ("net/failsafe: add fail-safe PMD")
Cc: stable@dpdk.org
Signed-off-by: Matan Azrad <matan@mellanox.com>
Acked-by: Gaetan Rivet <gaetan.rivet@6wind.com>
drivers/net/failsafe/failsafe_ops.c

index fe64c68..057e435 100644 (file)
@@ -110,7 +110,8 @@ fs_dev_configure(struct rte_eth_dev *dev)
                int lsc_interrupt = 0;
                int lsc_enabled;
 
-               if (sdev->state != DEV_PROBED)
+               if (sdev->state != DEV_PROBED &&
+                   !(PRIV(dev)->alarm_lock == 0 && sdev->state == DEV_ACTIVE))
                        continue;
 
                rmv_interrupt = ETH(sdev)->data->dev_flags &