+/**
+ * @warning
+ * @b EXPERIMENTAL: this API may change, or be removed, without prior notice
+ *
+ * Get Forward Error Correction(FEC) capability.
+ *
+ * @param port_id
+ * The port identifier of the Ethernet device.
+ * @param speed_fec_capa
+ * speed_fec_capa is out only with per-speed capabilities.
+ * If set to NULL, the function returns the required number
+ * of required array entries.
+ * @param num
+ * a number of elements in an speed_fec_capa array.
+ *
+ * @return
+ * - A non-negative value lower or equal to num: success. The return value
+ * is the number of entries filled in the fec capa array.
+ * - A non-negative value higher than num: error, the given fec capa array
+ * is too small. The return value corresponds to the num that should
+ * be given to succeed. The entries in fec capa array are not valid and
+ * shall not be used by the caller.
+ * - (-ENOTSUP) if underlying hardware OR driver doesn't support.
+ * that operation.
+ * - (-EIO) if device is removed.
+ * - (-ENODEV) if *port_id* invalid.
+ * - (-EINVAL) if *num* or *speed_fec_capa* invalid
+ */
+__rte_experimental
+int rte_eth_fec_get_capability(uint16_t port_id,
+ struct rte_eth_fec_capa *speed_fec_capa,
+ unsigned int num);
+
+/**
+ * @warning
+ * @b EXPERIMENTAL: this API may change, or be removed, without prior notice
+ *
+ * Get current Forward Error Correction(FEC) mode.
+ * If link is down and AUTO is enabled, AUTO is returned, otherwise,
+ * configured FEC mode is returned.
+ * If link is up, current FEC mode is returned.
+ *
+ * @param port_id
+ * The port identifier of the Ethernet device.
+ * @param fec_capa
+ * A bitmask of enabled FEC modes. If AUTO bit is set, other
+ * bits specify FEC modes which may be negotiated. If AUTO
+ * bit is clear, specify FEC modes to be used (only one valid
+ * mode per speed may be set).
+ * @return
+ * - (0) if successful.
+ * - (-ENOTSUP) if underlying hardware OR driver doesn't support.
+ * that operation.
+ * - (-EIO) if device is removed.
+ * - (-ENODEV) if *port_id* invalid.
+ */
+__rte_experimental
+int rte_eth_fec_get(uint16_t port_id, uint32_t *fec_capa);
+
+/**
+ * @warning
+ * @b EXPERIMENTAL: this API may change, or be removed, without prior notice
+ *
+ * Set Forward Error Correction(FEC) mode.
+ *
+ * @param port_id
+ * The port identifier of the Ethernet device.
+ * @param fec_capa
+ * A bitmask of allowed FEC modes. If AUTO bit is set, other
+ * bits specify FEC modes which may be negotiated. If AUTO
+ * bit is clear, specify FEC modes to be used (only one valid
+ * mode per speed may be set).
+ * @return
+ * - (0) if successful.
+ * - (-EINVAL) if the FEC mode is not valid.
+ * - (-ENOTSUP) if underlying hardware OR driver doesn't support.
+ * - (-EIO) if device is removed.
+ * - (-ENODEV) if *port_id* invalid.
+ */
+__rte_experimental
+int rte_eth_fec_set(uint16_t port_id, uint32_t fec_capa);
+