net/vmxnet3: generate link-state change notifications
authorRobert Shearman <rshearma@brocade.com>
Thu, 15 Jun 2017 12:16:10 +0000 (08:16 -0400)
committerFerruh Yigit <ferruh.yigit@intel.com>
Thu, 6 Jul 2017 13:00:57 +0000 (15:00 +0200)
Generate link-state change notifications by listening to interrupts
generated by the device. Make use of the existing
vmxnet3_process_events function that was compiled out, but change it
to call vmxnet3_dev_link_update on a VMXNET3_ECR_LINK event and to not
be so noisy in its log messages.

Enable interrupts on starting the device, using a new helper function,
vmxnet3_enable_intr, based on vmxnet3_disable_intr and validated
against the FreeBSD driver.

Keep track of the number of interrupts registered for to avoid
hardcoding these in vmxnet3_enable/disable_intr and to provision for
any future rxq intr support.

Factor out the guts of vmxnet3_dev_link_update minus the started check
to allow the new function to be called from vmxnet3_dev_start in the
lsc-enabled case to ensure that the link state is correctly set from
the actual state at that point.

Signed-off-by: Robert Shearman <rshearma@brocade.com>
drivers/net/vmxnet3/vmxnet3_ethdev.c
drivers/net/vmxnet3/vmxnet3_ethdev.h

index f5a9832..6ef72b1 100644 (file)
@@ -83,6 +83,8 @@ static void vmxnet3_dev_promiscuous_enable(struct rte_eth_dev *dev);
 static void vmxnet3_dev_promiscuous_disable(struct rte_eth_dev *dev);
 static void vmxnet3_dev_allmulticast_enable(struct rte_eth_dev *dev);
 static void vmxnet3_dev_allmulticast_disable(struct rte_eth_dev *dev);
+static int __vmxnet3_dev_link_update(struct rte_eth_dev *dev,
+                                    int wait_to_complete);
 static int vmxnet3_dev_link_update(struct rte_eth_dev *dev,
                                   int wait_to_complete);
 static void vmxnet3_hw_stats_save(struct vmxnet3_hw *hw);
@@ -102,10 +104,8 @@ static int vmxnet3_dev_vlan_filter_set(struct rte_eth_dev *dev,
 static void vmxnet3_dev_vlan_offload_set(struct rte_eth_dev *dev, int mask);
 static void vmxnet3_mac_addr_set(struct rte_eth_dev *dev,
                                 struct ether_addr *mac_addr);
+static void vmxnet3_interrupt_handler(void *param);
 
-#if PROCESS_SYS_EVENTS == 1
-static void vmxnet3_process_events(struct vmxnet3_hw *);
-#endif
 /*
  * The set of PCI devices this driver supports
  */
@@ -250,10 +250,22 @@ vmxnet3_disable_intr(struct vmxnet3_hw *hw)
        PMD_INIT_FUNC_TRACE();
 
        hw->shared->devRead.intrConf.intrCtrl |= VMXNET3_IC_DISABLE_ALL;
-       for (i = 0; i < VMXNET3_MAX_INTRS; i++)
+       for (i = 0; i < hw->num_intrs; i++)
                VMXNET3_WRITE_BAR0_REG(hw, VMXNET3_REG_IMR + i * 8, 1);
 }
 
+static void
+vmxnet3_enable_intr(struct vmxnet3_hw *hw)
+{
+       int i;
+
+       PMD_INIT_FUNC_TRACE();
+
+       hw->shared->devRead.intrConf.intrCtrl &= ~VMXNET3_IC_DISABLE_ALL;
+       for (i = 0; i < hw->num_intrs; i++)
+               VMXNET3_WRITE_BAR0_REG(hw, VMXNET3_REG_IMR + i * 8, 0);
+}
+
 /*
  * Gets tx data ring descriptor size.
  */
@@ -425,7 +437,7 @@ static int eth_vmxnet3_pci_remove(struct rte_pci_device *pci_dev)
 
 static struct rte_pci_driver rte_vmxnet3_pmd = {
        .id_table = pci_id_vmxnet3_map,
-       .drv_flags = RTE_PCI_DRV_NEED_MAPPING,
+       .drv_flags = RTE_PCI_DRV_NEED_MAPPING | RTE_PCI_DRV_INTR_LSC,
        .probe = eth_vmxnet3_pci_probe,
        .remove = eth_vmxnet3_pci_remove,
 };
@@ -648,11 +660,11 @@ vmxnet3_setup_driver_shared(struct rte_eth_dev *dev)
 
        /*
         * Set number of interrupts to 1
-        * PMD disables all the interrupts but this is MUST to activate device
-        * It needs at least one interrupt for link events to handle
-        * So we'll disable it later after device activation if needed
+        * PMD by default disables all the interrupts but this is MUST
+        * to activate device. It needs at least one interrupt for
+        * link events to handle
         */
-       devRead->intrConf.numIntrs = 1;
+       hw->num_intrs = devRead->intrConf.numIntrs = 1;
        devRead->intrConf.intrCtrl |= VMXNET3_IC_DISABLE_ALL;
 
        for (i = 0; i < hw->num_tx_queues; i++) {
@@ -747,6 +759,20 @@ vmxnet3_dev_start(struct rte_eth_dev *dev)
        if (ret != VMXNET3_SUCCESS)
                return ret;
 
+       /* check if lsc interrupt feature is enabled */
+       if (dev->data->dev_conf.intr_conf.lsc) {
+               struct rte_pci_device *pci_dev = RTE_DEV_TO_PCI(dev->device);
+
+               /* Setup interrupt callback  */
+               rte_intr_callback_register(&pci_dev->intr_handle,
+                                          vmxnet3_interrupt_handler, dev);
+
+               if (rte_intr_enable(&pci_dev->intr_handle) < 0) {
+                       PMD_INIT_LOG(ERR, "interrupt enable failed");
+                       return -EIO;
+               }
+       }
+
        /* Exchange shared data with device */
        VMXNET3_WRITE_BAR1_REG(hw, VMXNET3_REG_DSAL,
                               VMXNET3_GET_ADDR_LO(hw->sharedPA));
@@ -794,14 +820,19 @@ vmxnet3_dev_start(struct rte_eth_dev *dev)
        /* Setting proper Rx Mode and issue Rx Mode Update command */
        vmxnet3_dev_set_rxmode(hw, VMXNET3_RXM_UCAST | VMXNET3_RXM_BCAST, 1);
 
-       /*
-        * Don't need to handle events for now
-        */
-#if PROCESS_SYS_EVENTS == 1
-       events = VMXNET3_READ_BAR1_REG(hw, VMXNET3_REG_ECR);
-       PMD_INIT_LOG(DEBUG, "Reading events: 0x%X", events);
-       vmxnet3_process_events(hw);
-#endif
+       if (dev->data->dev_conf.intr_conf.lsc) {
+               vmxnet3_enable_intr(hw);
+
+               /*
+                * Update link state from device since this won't be
+                * done upon starting with lsc in use. This is done
+                * only after enabling interrupts to avoid any race
+                * where the link state could change without an
+                * interrupt being fired.
+                */
+               __vmxnet3_dev_link_update(dev, 0);
+       }
+
        return VMXNET3_SUCCESS;
 }
 
@@ -824,6 +855,15 @@ vmxnet3_dev_stop(struct rte_eth_dev *dev)
        /* disable interrupts */
        vmxnet3_disable_intr(hw);
 
+       if (dev->data->dev_conf.intr_conf.lsc) {
+               struct rte_pci_device *pci_dev = RTE_DEV_TO_PCI(dev->device);
+
+               rte_intr_disable(&pci_dev->intr_handle);
+
+               rte_intr_callback_unregister(&pci_dev->intr_handle,
+                                            vmxnet3_interrupt_handler, dev);
+       }
+
        /* quiesce the device first */
        VMXNET3_WRITE_BAR1_REG(hw, VMXNET3_REG_CMD, VMXNET3_CMD_QUIESCE_DEV);
        VMXNET3_WRITE_BAR1_REG(hw, VMXNET3_REG_DSAL, 0);
@@ -1110,17 +1150,13 @@ vmxnet3_mac_addr_set(struct rte_eth_dev *dev, struct ether_addr *mac_addr)
 
 /* return 0 means link status changed, -1 means not changed */
 static int
-vmxnet3_dev_link_update(struct rte_eth_dev *dev,
-                       __rte_unused int wait_to_complete)
+__vmxnet3_dev_link_update(struct rte_eth_dev *dev,
+                         __rte_unused int wait_to_complete)
 {
        struct vmxnet3_hw *hw = dev->data->dev_private;
        struct rte_eth_link old = { 0 }, link;
        uint32_t ret;
 
-       /* Link status doesn't change for stopped dev */
-       if (dev->data->dev_started == 0)
-               return -1;
-
        memset(&link, 0, sizeof(link));
        vmxnet3_dev_atomic_read_link_status(dev, &old);
 
@@ -1139,6 +1175,16 @@ vmxnet3_dev_link_update(struct rte_eth_dev *dev,
        return (old.link_status == link.link_status) ? -1 : 0;
 }
 
+static int
+vmxnet3_dev_link_update(struct rte_eth_dev *dev, int wait_to_complete)
+{
+       /* Link status doesn't change for stopped dev */
+       if (dev->data->dev_started == 0)
+               return -1;
+
+       return __vmxnet3_dev_link_update(dev, wait_to_complete);
+}
+
 /* Updating rxmode through Vmxnet3_DriverShared structure in adapter */
 static void
 vmxnet3_dev_set_rxmode(struct vmxnet3_hw *hw, uint32_t feature, int set)
@@ -1255,10 +1301,10 @@ vmxnet3_dev_vlan_offload_set(struct rte_eth_dev *dev, int mask)
        }
 }
 
-#if PROCESS_SYS_EVENTS == 1
 static void
-vmxnet3_process_events(struct vmxnet3_hw *hw)
+vmxnet3_process_events(struct rte_eth_dev *dev)
 {
+       struct vmxnet3_hw *hw = dev->data->dev_private;
        uint32_t events = hw->shared->ecr;
 
        if (!events) {
@@ -1273,10 +1319,15 @@ vmxnet3_process_events(struct vmxnet3_hw *hw)
        VMXNET3_WRITE_BAR1_REG(hw, VMXNET3_REG_ECR, events);
 
        /* Check if link state has changed */
-       if (events & VMXNET3_ECR_LINK)
+       if (events & VMXNET3_ECR_LINK) {
                PMD_INIT_LOG(ERR,
                             "Process events in %s(): VMXNET3_ECR_LINK event",
                             __func__);
+               if (vmxnet3_dev_link_update(dev, 0) == 0)
+                       _rte_eth_dev_callback_process(dev,
+                                                     RTE_ETH_EVENT_INTR_LSC,
+                                                     NULL, NULL);
+       }
 
        /* Check if there is an error on xmit/recv queues */
        if (events & (VMXNET3_ECR_TQERR | VMXNET3_ECR_RQERR)) {
@@ -1301,7 +1352,18 @@ vmxnet3_process_events(struct vmxnet3_hw *hw)
        if (events & VMXNET3_ECR_DEBUG)
                PMD_INIT_LOG(ERR, "Debug event generated by device.");
 }
-#endif
+
+static void
+vmxnet3_interrupt_handler(void *param)
+{
+       struct rte_eth_dev *dev = param;
+       struct rte_pci_device *pci_dev = RTE_DEV_TO_PCI(dev->device);
+
+       vmxnet3_process_events(dev);
+
+       if (rte_intr_enable(&pci_dev->intr_handle) < 0)
+               PMD_DRV_LOG(ERR, "interrupt enable failed");
+}
 
 RTE_PMD_REGISTER_PCI(net_vmxnet3, rte_vmxnet3_pmd);
 RTE_PMD_REGISTER_PCI_TABLE(net_vmxnet3, pci_id_vmxnet3_map);
index e93e4a7..b48058a 100644 (file)
@@ -106,6 +106,8 @@ struct vmxnet3_hw {
        uint16_t txdata_desc_size; /* tx data ring buffer size */
        uint16_t rxdata_desc_size; /* rx data ring buffer size */
 
+       uint8_t num_intrs;
+
        Vmxnet3_TxQueueDesc   *tqd_start;       /* start address of all tx queue desc */
        Vmxnet3_RxQueueDesc   *rqd_start;       /* start address of all rx queue desc */