| | ``index`` | field is ignored |
+----------+-----------+---------------------------------------+
-ata matching item types
-~~~~~~~~~~~~~~~~~~~~~~~
+Item: ``META``
+^^^^^^^^^^^^^^^^^
+
+Matches 32 bit metadata item set.
+
+On egress, metadata can be set either by mbuf metadata field with
+PKT_TX_DYNF_METADATA flag or ``SET_META`` action. On ingress, ``SET_META``
+action sets metadata for a packet and the metadata will be reported via
+``metadata`` dynamic field of ``rte_mbuf`` with PKT_RX_DYNF_METADATA flag.
+
+- Default ``mask`` matches the specified Rx metadata value.
+
+.. _table_rte_flow_item_meta:
+
+.. table:: META
+
+ +----------+----------+---------------------------------------+
+ | Field | Subfield | Value |
+ +==========+==========+=======================================+
+ | ``spec`` | ``data`` | 32 bit metadata value |
+ +----------+----------+---------------------------------------+
+ | ``last`` | ``data`` | upper range value |
+ +----------+----------+---------------------------------------+
+ | ``mask`` | ``data`` | bit-mask applies to "spec" and "last" |
+ +----------+----------+---------------------------------------+
+
+Data matching item types
+~~~~~~~~~~~~~~~~~~~~~~~~
Most of these are basically protocol header definitions with associated
bit-masks. They must be specified (stacked) from lowest to highest protocol
- ``proto_id``: PPP protocol identifier.
- Default ``mask`` matches proto_id only.
-
-.. _table_rte_flow_item_meta:
-
-.. table:: META
-
- +----------+----------+---------------------------------------+
- | Field | Subfield | Value |
- +==========+==========+=======================================+
- | ``spec`` | ``data`` | 32 bit metadata value |
- +----------+--------------------------------------------------+
- | ``last`` | ``data`` | upper range value |
- +----------+----------+---------------------------------------+
- | ``mask`` | ``data`` | bit-mask applies to "spec" and "last" |
- +----------+----------+---------------------------------------+
-
Item: ``NSH``
^^^^^^^^^^^^^
- Default ``mask`` matches classification and vlan.
+Item: ``L2TPV3OIP``
+^^^^^^^^^^^^^^^^^^^
+
+Matches a L2TPv3 over IP header.
+
+- ``session_id``: L2TPv3 over IP session identifier.
+- Default ``mask`` matches session_id only.
+
+Item: ``PFCP``
+^^^^^^^^^^^^^^
+
+Matches a PFCP Header.
+
+- ``s_field``: S field.
+- ``msg_type``: message type.
+- ``msg_len``: message length.
+- ``seid``: session endpoint identifier.
+- Default ``mask`` matches s_field and seid.
Actions
~~~~~~~
The shared flag indicates whether the counter is unique to the flow rule the
action is specified with, or whether it is a shared counter.
-For a count action with the shared flag set, then then a global device
+For a count action with the shared flag set, then a global device
namespace is assumed for the counter id, so that any matched flow rules using
a count action with the same counter id on the same port will contribute to
that counter.
| ``index`` | index of tag to set |
+-----------+----------------------------+
+Action: ``SET_META``
+^^^^^^^^^^^^^^^^^^^^^^^
+
+Set metadata. Item ``META`` matches metadata.
+
+Metadata set by mbuf metadata field with PKT_TX_DYNF_METADATA flag on egress
+will be overridden by this action. On ingress, the metadata will be carried by
+``metadata`` dynamic field of ``rte_mbuf`` which can be accessed by
+``RTE_FLOW_DYNF_METADATA()``. PKT_RX_DYNF_METADATA flag will be set along
+with the data.
+
+The mbuf dynamic field must be registered by calling
+``rte_flow_dynf_metadata_register()`` prior to use ``SET_META`` action.
+
+Altering partial bits is supported with ``mask``. For bits which have never been
+set, unpredictable value will be seen depending on driver implementation. For
+loopback/hairpin packet, metadata set on Rx/Tx may or may not be propagated to
+the other path depending on HW capability.
+
+.. _table_rte_flow_action_set_meta:
+
+.. table:: SET_META
+
+ +----------+----------------------------+
+ | Field | Value |
+ +==========+============================+
+ | ``data`` | 32 bit metadata value |
+ +----------+----------------------------+
+ | ``mask`` | bit-mask applies to "data" |
+ +----------+----------------------------+
+
+Action: ``SET_IPV4_DSCP``
+^^^^^^^^^^^^^^^^^^^^^^^^^
+
+Set IPv4 DSCP.
+
+Modify DSCP in IPv4 header.
+
+It must be used with RTE_FLOW_ITEM_TYPE_IPV4 in pattern.
+Otherwise, RTE_FLOW_ERROR_TYPE_ACTION error will be returned.
+
+.. _table_rte_flow_action_set_ipv4_dscp:
+
+.. table:: SET_IPV4_DSCP
+
+ +-----------+---------------------------------+
+ | Field | Value |
+ +===========+=================================+
+ | ``dscp`` | DSCP in low 6 bits, rest ignore |
+ +-----------+---------------------------------+
+
+Action: ``SET_IPV6_DSCP``
+^^^^^^^^^^^^^^^^^^^^^^^^^
+
+Set IPv6 DSCP.
+
+Modify DSCP in IPv6 header.
+
+It must be used with RTE_FLOW_ITEM_TYPE_IPV6 in pattern.
+Otherwise, RTE_FLOW_ERROR_TYPE_ACTION error will be returned.
+
+.. _table_rte_flow_action_set_ipv6_dscp:
+
+.. table:: SET_IPV6_DSCP
+
+ +-----------+---------------------------------+
+ | Field | Value |
+ +===========+=================================+
+ | ``dscp`` | DSCP in low 6 bits, rest ignore |
+ +-----------+---------------------------------+
+
+Action: ``AGE``
+^^^^^^^^^^^^^^^
+
+Set ageing timeout configuration to a flow.
+
+Event RTE_ETH_EVENT_FLOW_AGED will be reported if
+timeout passed without any matching on the flow.
+
+.. _table_rte_flow_action_age:
+
+.. table:: AGE
+
+ +--------------+---------------------------------+
+ | Field | Value |
+ +==============+=================================+
+ | ``timeout`` | 24 bits timeout value |
+ +--------------+---------------------------------+
+ | ``reserved`` | 8 bits reserved, must be zero |
+ +--------------+---------------------------------+
+ | ``context`` | user input flow context |
+ +--------------+---------------------------------+
+
Negative types
~~~~~~~~~~~~~~
git.droids-corp.org / dpdk.git / blobdiff