net: add rte prefix to ether defines

[dpdk.git] / doc / guides / sample_app_ug / skeleton.rst

diff --git a/doc/guides/sample_app_ug/skeleton.rst b/doc/guides/sample_app_ug/skeleton.rst
index d3a3712..59ca511 100644 (file)
--- a/doc/guides/sample_app_ug/skeleton.rst
+++ b/doc/guides/sample_app_ug/skeleton.rst
@@ -21,7 +21,7 @@ The application is located in the ``skeleton`` sub-directory.
 Running the Application
 -----------------------
 
-To run the example in a ``linuxapp`` environment:
+To run the example in a ``linux`` environment:
 
 .. code-block:: console
 
@@ -115,11 +115,11 @@ Forwarding application is shown below:
     {
         struct rte_eth_conf port_conf = port_conf_default;
         const uint16_t rx_rings = 1, tx_rings = 1;
-        struct ether_addr addr;
+        struct rte_ether_addr addr;
         int retval;
         uint16_t q;
 
-        if (port >= rte_eth_dev_count())
+        if (!rte_eth_dev_is_valid_port(port))
             return -1;
 
         /* Configure the Ethernet device. */
@@ -160,7 +160,7 @@ The Ethernet ports are configured with default settings using the
 .. code-block:: c
 
     static const struct rte_eth_conf port_conf_default = {
-        .rxmode = { .max_rx_pkt_len = ETHER_MAX_LEN }
+        .rxmode = { .max_rx_pkt_len = RTE_ETHER_MAX_LEN }
     };
 
 For this example the ports are set up with 1 RX and 1 TX queue using the
@@ -192,7 +192,6 @@ looks like the following:
     static __attribute__((noreturn)) void
     lcore_main(void)
     {
-        const uint16_t nb_ports = rte_eth_dev_count();
         uint16_t port;
 
         /*