XX:XX:XX:XX:XX:02
...
-
* ``--eth-peer=N,XX:XX:XX:XX:XX:XX``
Set the MAC address ``XX:XX:XX:XX:XX:XX`` of the peer port N,
where 0 <= N < ``CONFIG_RTE_MAX_ETHPORTS`` from the configuration file.
+* ``--tx-ip=SRC,DST``
+
+ Set the source and destination IP address used when doing transmit only test.
+ The defaults address values are source 192.18.0.1 and
+ destination 192.18.0.2. These are special purpose addresses
+ reserved for benchmarking (RFC 2544).
+
+* ``--tx-udp=SRC[,DST]``
+
+ Set the source and destination UDP port number for transmit test only test.
+ The default port is the port 9 which is defined for the discard protocol
+ (RFC 863).
+
* ``--pkt-filter-mode=mode``
Set Flow Director mode where mode is either ``none`` (the default), ``signature`` or ``perfect``.