-/*-
- * BSD LICENSE
- *
- * Copyright 2015 6WIND S.A.
- * Copyright 2015 Mellanox.
- *
- * Redistribution and use in source and binary forms, with or without
- * modification, are permitted provided that the following conditions
- * are met:
- *
- * * Redistributions of source code must retain the above copyright
- * notice, this list of conditions and the following disclaimer.
- * * Redistributions in binary form must reproduce the above copyright
- * notice, this list of conditions and the following disclaimer in
- * the documentation and/or other materials provided with the
- * distribution.
- * * Neither the name of 6WIND S.A. nor the names of its
- * contributors may be used to endorse or promote products derived
- * from this software without specific prior written permission.
- *
- * THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND CONTRIBUTORS
- * "AS IS" AND ANY EXPRESS OR IMPLIED WARRANTIES, INCLUDING, BUT NOT
- * LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR
- * A PARTICULAR PURPOSE ARE DISCLAIMED. IN NO EVENT SHALL THE COPYRIGHT
- * OWNER OR CONTRIBUTORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL,
- * SPECIAL, EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
- * LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF USE,
- * DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED AND ON ANY
- * THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT LIABILITY, OR TORT
- * (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN ANY WAY OUT OF THE USE
- * OF THIS SOFTWARE, EVEN IF ADVISED OF THE POSSIBILITY OF SUCH DAMAGE.
+/* SPDX-License-Identifier: BSD-3-Clause
+ * Copyright 2015 6WIND S.A.
+ * Copyright 2015 Mellanox Technologies, Ltd
*/
#ifndef RTE_PMD_MLX5_DEFS_H_
#define RTE_PMD_MLX5_DEFS_H_
+#include <rte_ethdev_driver.h>
+#include <rte_vxlan.h>
+
#include "mlx5_autoconf.h"
/* Reported driver name. */
#define MLX5_DRIVER_NAME "net_mlx5"
-/* Maximum number of simultaneous MAC addresses. */
-#define MLX5_MAX_MAC_ADDRESSES 128
-
/* Maximum number of simultaneous VLAN filters. */
#define MLX5_MAX_VLAN_IDS 128
-/* Maximum number of special flows. */
-#define MLX5_MAX_SPECIAL_FLOWS 4
-
/*
* Request TX completion every time descriptors reach this threshold since
* the previous request. Must be a power of two for performance reasons.
*/
-#define MLX5_TX_COMP_THRESH 32
+#define MLX5_TX_COMP_THRESH 32u
-/* RSS Indirection table size. */
-#define RSS_INDIRECTION_TABLE_SIZE 256
+/*
+ * Request TX completion every time the total number of WQEBBs used for inlining
+ * packets exceeds the size of WQ divided by this divisor. Better to be power of
+ * two for performance.
+ */
+#define MLX5_TX_COMP_THRESH_INLINE_DIV (1 << 3)
/*
- * Maximum number of cached Memory Pools (MPs) per TX queue. Each RTE MP
- * from which buffers are to be transmitted will have to be mapped by this
- * driver to their own Memory Region (MR). This is a slow operation.
- *
- * This value is always 1 for RX queues.
+ * Maximal amount of normal completion CQEs
+ * processed in one call of tx_burst() routine.
*/
-#ifndef MLX5_PMD_TX_MP_CACHE
-#define MLX5_PMD_TX_MP_CACHE 8
-#endif
+#define MLX5_TX_COMP_MAX_CQE 2u
+
+
+/* Size of per-queue MR cache array for linear search. */
+#define MLX5_MR_CACHE_N 8
+
+/* Size of MR cache table for binary search. */
+#define MLX5_MR_BTREE_CACHE_N 256
/*
* If defined, only use software counters. The PMD will never ask the hardware
#define MLX5_PMD_SOFT_COUNTERS 1
#endif
+/* Switch port ID parameters for bonding configurations. */
+#define MLX5_PORT_ID_BONDING_PF_MASK 0xf
+#define MLX5_PORT_ID_BONDING_PF_SHIFT 0xf
+
/* Alarm timeout. */
#define MLX5_ALARM_TIMEOUT_US 100000
+/* Maximum number of extended statistics counters. */
+#define MLX5_MAX_XSTATS 32
+
+/* Maximum Packet headers size (L2+L3+L4) for TSO. */
+#define MLX5_MAX_TSO_HEADER (128u + 34u)
+
+/* Inline data size required by NICs. */
+#define MLX5_INLINE_HSIZE_NONE 0
+#define MLX5_INLINE_HSIZE_L2 (sizeof(struct rte_ether_hdr) + \
+ sizeof(struct rte_vlan_hdr))
+#define MLX5_INLINE_HSIZE_L3 (MLX5_INLINE_HSIZE_L2 + \
+ sizeof(struct rte_ipv6_hdr))
+#define MLX5_INLINE_HSIZE_L4 (MLX5_INLINE_HSIZE_L3 + \
+ sizeof(struct rte_tcp_hdr))
+#define MLX5_INLINE_HSIZE_INNER_L2 (MLX5_INLINE_HSIZE_L3 + \
+ sizeof(struct rte_udp_hdr) + \
+ sizeof(struct rte_vxlan_hdr) + \
+ sizeof(struct rte_ether_hdr) + \
+ sizeof(struct rte_vlan_hdr))
+#define MLX5_INLINE_HSIZE_INNER_L3 (MLX5_INLINE_HSIZE_INNER_L2 + \
+ sizeof(struct rte_ipv6_hdr))
+#define MLX5_INLINE_HSIZE_INNER_L4 (MLX5_INLINE_HSIZE_INNER_L3 + \
+ sizeof(struct rte_tcp_hdr))
+
+/* Threshold of buffer replenishment for vectorized Rx. */
+#define MLX5_VPMD_RXQ_RPLNSH_THRESH(n) \
+ (RTE_MIN(MLX5_VPMD_RX_MAX_BURST, (unsigned int)(n) >> 2))
+
+/* Maximum size of burst for vectorized Rx. */
+#define MLX5_VPMD_RX_MAX_BURST 64U
+
+/* Recommended optimal burst size. */
+#define MLX5_RX_DEFAULT_BURST 64U
+#define MLX5_TX_DEFAULT_BURST 64U
+
+/* Number of packets vectorized Rx can simultaneously process in a loop. */
+#define MLX5_VPMD_DESCS_PER_LOOP 4
+
+/* Mask of RSS on source only or destination only. */
+#define MLX5_RSS_SRC_DST_ONLY (ETH_RSS_L3_SRC_ONLY | ETH_RSS_L3_DST_ONLY | \
+ ETH_RSS_L4_SRC_ONLY | ETH_RSS_L4_DST_ONLY)
+
+/* Supported RSS */
+#define MLX5_RSS_HF_MASK (~(ETH_RSS_IP | ETH_RSS_UDP | ETH_RSS_TCP | \
+ MLX5_RSS_SRC_DST_ONLY))
+
+/* Timeout in seconds to get a valid link status. */
+#define MLX5_LINK_STATUS_TIMEOUT 10
+
+/* Number of times to retry retrieving the physical link information. */
+#define MLX5_GET_LINK_STATUS_RETRY_COUNT 3
+
+/* Maximum number of UAR pages used by a port,
+ * These are the size and mask for an array of mutexes used to synchronize
+ * the access to port's UARs on platforms that do not support 64 bit writes.
+ * In such systems it is possible to issue the 64 bits DoorBells through two
+ * consecutive writes, each write 32 bits. The access to a UAR page (which can
+ * be accessible by all threads in the process) must be synchronized
+ * (for example, using a semaphore). Such a synchronization is not required
+ * when ringing DoorBells on different UAR pages.
+ * A port with 512 Tx queues uses 8, 4kBytes, UAR pages which are shared
+ * among the ports.
+ */
+#define MLX5_UAR_PAGE_NUM_MAX 64
+#define MLX5_UAR_PAGE_NUM_MASK ((MLX5_UAR_PAGE_NUM_MAX) - 1)
+
+/* Fields of memory mapping type in offset parameter of mmap() */
+#define MLX5_UAR_MMAP_CMD_SHIFT 8
+#define MLX5_UAR_MMAP_CMD_MASK 0xff
+
+/* Environment variable to control the doorbell register mapping. */
+#define MLX5_SHUT_UP_BF "MLX5_SHUT_UP_BF"
+#if defined(RTE_ARCH_ARM64)
+#define MLX5_SHUT_UP_BF_DEFAULT "0"
+#else
+#define MLX5_SHUT_UP_BF_DEFAULT "1"
+#endif
+
+#ifndef HAVE_MLX5DV_MMAP_GET_NC_PAGES_CMD
+#define MLX5_MMAP_GET_NC_PAGES_CMD 3
+#endif
+
+/* Log 2 of the default number of strides per WQE for Multi-Packet RQ. */
+#define MLX5_MPRQ_STRIDE_NUM_N 6U
+
+/* Log 2 of the default size of a stride per WQE for Multi-Packet RQ. */
+#define MLX5_MPRQ_STRIDE_SIZE_N 11U
+
+/* Two-byte shift is disabled for Multi-Packet RQ. */
+#define MLX5_MPRQ_TWO_BYTE_SHIFT 0
+
+/*
+ * Minimum size of packet to be memcpy'd instead of being attached as an
+ * external buffer.
+ */
+#define MLX5_MPRQ_MEMCPY_DEFAULT_LEN 128
+
+/* Minimum number Rx queues to enable Multi-Packet RQ. */
+#define MLX5_MPRQ_MIN_RXQS 12
+
+/* Cache size of mempool for Multi-Packet RQ. */
+#define MLX5_MPRQ_MP_CACHE_SZ 32U
+
+/* MLX5_DV_XMETA_EN supported values. */
+#define MLX5_XMETA_MODE_LEGACY 0
+#define MLX5_XMETA_MODE_META16 1
+#define MLX5_XMETA_MODE_META32 2
+
+/* MLX5_TX_DB_NC supported values. */
+#define MLX5_TXDB_CACHED 0
+#define MLX5_TXDB_NCACHED 1
+#define MLX5_TXDB_HEURISTIC 2
+
+/* Tx accurate scheduling on timestamps parameters. */
+#define MLX5_TXPP_WAIT_INIT_TS 1000ul /* How long to wait timestamp. */
+#define MLX5_TXPP_CLKQ_SIZE 1
+#define MLX5_TXPP_REARM ((1UL << MLX5_WQ_INDEX_WIDTH) / 4)
+#define MLX5_TXPP_REARM_SQ_SIZE (((1UL << MLX5_CQ_INDEX_WIDTH) / \
+ MLX5_TXPP_REARM) * 2)
+#define MLX5_TXPP_REARM_CQ_SIZE (MLX5_TXPP_REARM_SQ_SIZE / 2)
+/* The minimal size test packet to put into one WQE, padded by HW. */
+#define MLX5_TXPP_TEST_PKT_SIZE (sizeof(struct rte_ether_hdr) + \
+ sizeof(struct rte_ipv4_hdr))
+
+/* Size of the simple hash table for metadata register table. */
+#define MLX5_FLOW_MREG_HTABLE_SZ 4096
+#define MLX5_FLOW_MREG_HNAME "MARK_COPY_TABLE"
+#define MLX5_DEFAULT_COPY_ID UINT32_MAX
+
+/* Hairpin TX/RX queue configuration parameters. */
+#define MLX5_HAIRPIN_QUEUE_STRIDE 6
+#define MLX5_HAIRPIN_JUMBO_LOG_SIZE (14 + 2)
+
+/* Definition of static_assert found in /usr/include/assert.h */
+#ifndef HAVE_STATIC_ASSERT
+#define static_assert _Static_assert
+#endif
+
+/*
+ * Defines the amount of retries to allocate the first UAR in the page.
+ * OFED 5.0.x and Upstream rdma_core before v29 returned the NULL as
+ * UAR base address if UAR was not the first object in the UAR page.
+ * It caused the PMD failure and we should try to get another UAR
+ * till we get the first one with non-NULL base address returned.
+ * Should follow the rdma_core internal (not exported) definition
+ * MLX5_NUM_NON_FP_BFREGS_PER_UAR.
+ */
+#define MLX5_ALLOC_UAR_RETRY 2
+
#endif /* RTE_PMD_MLX5_DEFS_H_ */
git.droids-corp.org / dpdk.git / blobdiff