#include <rte_dev.h>
#include <rte_devargs.h>
#include <rte_errno.h>
+#include <rte_common.h>
+
#include "rte_ether.h"
#include "rte_eth_ctrl.h"
#include "rte_dev_info.h"
hw_strip_crc : 1, /**< Enable CRC stripping by hardware. */
enable_scatter : 1, /**< Enable scatter packets rx handler */
enable_lro : 1, /**< Enable LRO */
+ hw_timestamp : 1, /**< Enable HW timestamp */
+ security : 1, /**< Enable rte_security offloads */
/**
* When set the offload bitfield should be ignored.
* Instead per-port Rx offloads should be set on offloads
#define DEV_RX_OFFLOAD_JUMBO_FRAME 0x00000800
#define DEV_RX_OFFLOAD_CRC_STRIP 0x00001000
#define DEV_RX_OFFLOAD_SCATTER 0x00002000
+#define DEV_RX_OFFLOAD_TIMESTAMP 0x00004000
+#define DEV_RX_OFFLOAD_SECURITY 0x00008000
#define DEV_RX_OFFLOAD_CHECKSUM (DEV_RX_OFFLOAD_IPV4_CKSUM | \
DEV_RX_OFFLOAD_UDP_CKSUM | \
DEV_RX_OFFLOAD_TCP_CKSUM)
* When set application must guarantee that per-queue all mbufs comes from
* the same mempool and has refcnt = 1.
*/
+#define DEV_TX_OFFLOAD_SECURITY 0x00020000
struct rte_pci_device;
/**
* Ethernet device TX queue information structure.
- * Used to retieve information about configured queue.
+ * Used to retrieve information about configured queue.
*/
struct rte_eth_txq_info {
struct rte_eth_txconf conf; /**< queue config parameters. */
} \
} while (0)
-#define RTE_ETH_DEV_TO_PCI(eth_dev) RTE_DEV_TO_PCI((eth_dev)->device)
-
/**
* l2 tunnel configuration.
*/
int wait_to_complete);
/**< @internal Get link speed, duplex mode and state (up/down) of an Ethernet device. */
-typedef void (*eth_stats_get_t)(struct rte_eth_dev *dev,
+typedef int (*eth_stats_get_t)(struct rte_eth_dev *dev,
struct rte_eth_stats *igb_stats);
/**< @internal Get global I/O statistics of an Ethernet device. */
enum rte_vlan_type type, uint16_t tpid);
/**< @internal set the outer/inner VLAN-TPID by an Ethernet device. */
-typedef void (*vlan_offload_set_t)(struct rte_eth_dev *dev, int mask);
+typedef int (*vlan_offload_set_t)(struct rte_eth_dev *dev, int mask);
/**< @internal set VLAN offload function by an Ethernet device. */
typedef int (*vlan_pvid_set_t)(struct rte_eth_dev *dev,
typedef int (*eth_tm_ops_get_t)(struct rte_eth_dev *dev, void *ops);
/**< @internal Get Traffic Management (TM) operations on an Ethernet device */
+typedef int (*eth_mtr_ops_get_t)(struct rte_eth_dev *dev, void *ops);
+/**< @internal Get Trafffic Metering and Policing (MTR) operations */
+
typedef int (*eth_get_dcb_info)(struct rte_eth_dev *dev,
struct rte_eth_dcb_info *dcb_info);
/**< @internal Get dcb information on an Ethernet device */
eth_tm_ops_get_t tm_ops_get;
/**< Get Traffic Management (TM) operations. */
+
+ eth_mtr_ops_get_t mtr_ops_get;
+ /**< Get Traffic Metering and Policing (MTR) operations. */
+
eth_pool_ops_supported_t pool_ops_supported;
/**< Test if a port supports specific mempool ops */
};
*/
struct rte_eth_rxtx_callback *pre_tx_burst_cbs[RTE_MAX_QUEUES_PER_PORT];
enum rte_eth_dev_state state; /**< Flag indicating the port state */
+ void *security_ctx; /**< Context for security ops */
} __rte_cache_aligned;
+void *
+rte_eth_dev_get_sec_ctx(uint8_t port_id);
+
struct rte_eth_dev_sriov {
uint8_t active; /**< SRIOV is active with 16, 32 or 64 pools */
uint8_t nb_q_per_pool; /**< rx queue number per pool */
/**< VLAN filter configuration. */
};
-/** Device supports hotplug detach */
-#define RTE_ETH_DEV_DETACHABLE 0x0001
/** Device supports link state interrupt */
#define RTE_ETH_DEV_INTR_LSC 0x0002
/** Device is a bonded slave */
*
* @param port_id
* The port identifier of the Ethernet device.
+ *
+ * @return
+ * - (0) if successful.
+ * - (-EINVAL) if port identifier is invalid.
+ * - (-ENOTSUP) if hardware doesn't support this function.
+ * - (-EPERM) if not ran from the primary process.
+ * - (-EIO) if re-initialisation failed.
+ * - (-ENOMEM) if the reset failed due to OOM.
+ * - (-EAGAIN) if the reset temporarily failed and should be retried later.
*/
int rte_eth_dev_reset(uint16_t port_id);
*
* @param port_id
* The port identifier of the Ethernet device.
+ * @return
+ * - (0) if device notified to reset stats.
+ * - (-ENOTSUP) if hardware doesn't support.
+ * - (-ENODEV) if *port_id* invalid.
*/
-void rte_eth_stats_reset(uint16_t port_id);
+int rte_eth_stats_reset(uint16_t port_id);
/**
* Retrieve names of extended statistics of an Ethernet device.
* @param ids
* A pointer to an ids array passed by application. This tells which
* statistics values function should retrieve. This parameter
- * can be set to NULL if n is 0. In this case function will retrieve
+ * can be set to NULL if size is 0. In this case function will retrieve
* all avalible statistics.
* @param values
* A pointer to a table to be filled with device statistics values.
- * @param n
+ * @param size
* The size of the ids array (number of elements).
* @return
- * - A positive value lower or equal to n: success. The return value
+ * - A positive value lower or equal to size: success. The return value
* is the number of entries filled in the stats table.
- * - A positive value higher than n: error, the given statistics table
+ * - A positive value higher than size: error, the given statistics table
* is too small. The return value corresponds to the size that should
* be given to succeed. The entries in the table are not valid and
* shall not be used by the caller.
* - A negative value on error (invalid port id).
*/
int rte_eth_xstats_get_by_id(uint16_t port_id, const uint64_t *ids,
- uint64_t *values, unsigned int n);
+ uint64_t *values, unsigned int size);
/**
* Gets the ID of a statistic from its name.
* - -EINVAL: Pool param is null.
*/
int
-rte_eth_dev_pool_ops_supported(uint8_t port_id, const char *pool);
+rte_eth_dev_pool_ops_supported(uint16_t port_id, const char *pool);
#ifdef __cplusplus
}
git.droids-corp.org / dpdk.git / blobdiff