+If you are running on a kernel which includes a driver for your device, see
+`Installation using kernel.org driver`_ below. Otherwise see
+`Installation using 01.org QAT driver`_.
+
+
+Installation using kernel.org driver
+------------------------------------
+
+The examples below are based on the C62x device, if you have a different device
+use the corresponding values in the above table.
+
+In BIOS ensure that SRIOV is enabled and either:
+
+* Disable VT-d or
+* Enable VT-d and set ``"intel_iommu=on iommu=pt"`` in the grub file.
+
+Check that the QAT driver is loaded on your system, by executing::
+
+ lsmod | grep qa
+
+You should see the kernel module for your device listed, e.g.::
+
+ qat_c62x 5626 0
+ intel_qat 82336 1 qat_c62x
+
+Next, you need to expose the Virtual Functions (VFs) using the sysfs file system.
+
+First find the BDFs (Bus-Device-Function) of the physical functions (PFs) of
+your device, e.g.::
+
+ lspci -d:37c8
+
+You should see output similar to::
+
+ 1a:00.0 Co-processor: Intel Corporation Device 37c8
+ 3d:00.0 Co-processor: Intel Corporation Device 37c8
+ 3f:00.0 Co-processor: Intel Corporation Device 37c8
+
+Enable the VFs for each PF by echoing the number of VFs per PF to the pci driver::
+
+ echo 16 > /sys/bus/pci/drivers/c6xx/0000:1a:00.0/sriov_numvfs
+ echo 16 > /sys/bus/pci/drivers/c6xx/0000:3d:00.0/sriov_numvfs
+ echo 16 > /sys/bus/pci/drivers/c6xx/0000:3f:00.0/sriov_numvfs
+
+Check that the VFs are available for use. For example ``lspci -d:37c9`` should
+list 48 VF devices available for a ``C62x`` device.
+
+To complete the installation follow the instructions in
+`Binding the available VFs to the DPDK UIO driver`_.
+
+.. Note::
+
+ If the QAT kernel modules are not loaded and you see an error like ``Failed
+ to load MMP firmware qat_895xcc_mmp.bin`` in kernel logs, this may be as a
+ result of not using a distribution, but just updating the kernel directly.
+
+ Download firmware from the `kernel firmware repo
+ <http://git.kernel.org/cgit/linux/kernel/git/firmware/linux-firmware.git/tree/>`_.
+
+ Copy qat binaries to ``/lib/firmware``::
+
+ cp qat_895xcc.bin /lib/firmware
+ cp qat_895xcc_mmp.bin /lib/firmware
+
+ Change to your linux source root directory and start the qat kernel modules::
+
+ insmod ./drivers/crypto/qat/qat_common/intel_qat.ko
+ insmod ./drivers/crypto/qat/qat_dh895xcc/qat_dh895xcc.ko
+
+
+.. Note::
+
+ If you see the following warning in ``/var/log/messages`` it can be ignored:
+ ``IOMMU should be enabled for SR-IOV to work correctly``.