+* **cxgbe: Fixed crash due to incorrect size allocated for RSS table.**
+
+ Fixed a segfault that occurs when accessing part of port 0's RSS
+ table that gets overwritten by subsequent port 1's part of the RSS
+ table due to incorrect size allocated for each entry in the table.
+
+* **cxgbe: Fixed setting wrong device MTU.**
+
+ Fixed an incorrect device MTU being set due to ethernet header and
+ CRC lengths being added twice.
+
+* **ixgbe: Fixed zeroed VF mac address.**
+
+ Resolved an issue where VF mac address is zeroed out in cases where the VF
+ driver is loaded while the PF interface is down.
+ The solution is to only set it when we get an ACK from the PF.
+
+* **ixgbe: Fixed setting flow director flag twice.**
+
+ Resolved an issue where packets were being dropped when switching to perfect
+ filters mode.
+
+* **ixgbe: Set MDIO speed after MAC reset.**
+
+ The MDIO clock speed must be reconfigured after the MAC reset. The MDIO clock
+ speed becomes invalid, therefore the driver reads invalid PHY register values.
+ The driver now set the MDIO clock speed prior to initializing PHY ops and
+ again after the MAC reset.
+
+* **ixgbe: Fixed maximum number of available TX queues.**
+
+ In IXGBE, the maximum number of TX queues varies depending on the NIC operating
+ mode. This was not being updated in the device information, providing
+ an incorrect number in some cases.
+
+* **i40e: Generated MAC address for each VFs.**
+
+ It generates a MAC address for each VFs during PF host initialization,
+ and keeps the VF MAC address the same among different VF launch.
+
+* **i40e: Fixed failure of reading/writing Rx control registers.**
+
+ Fixed i40e issue of failing to read/write rx control registers when
+ under stress with traffic, which might result in application launch
+ failure.
+
+* **i40e: Enabled vector driver by default.**
+
+ Previously, vector driver is disabled by default as it cannot fill packet type
+ info for l3fwd to work well. Now there is an option for l3fwd to analysis
+ packet type softly, so enable vector driver by default.
+
+* **i40e: Fixed link info of VF.**
+
+ Previously, the VF's link speed kept as 10G and status always was up.
+ It did not change even the physical link's status changed.
+ Now this issue is fixed to make VF's link info consistent with physical link.
+
+* **mlx5: Fixed possible crash during initialization.**
+
+ A crash could occur when failing to allocate private device context.
+
+* **mlx5: Added port type check.**
+
+ Done to prevent port initialization on non-Ethernet link layers and
+ to report an error.
+
+* **mlx5: Applied VLAN filtering to broadcast and IPv6 multicast flows.**
+
+ Prevented reception of multicast frames outside of configured VLANs.
+
+* **mlx5: Fixed RX checksum offload in non L3/L4 packets.**
+
+ Fixed report of bad checksum for packets of unknown type.
+