bus/pci: support IOVA as VA in PowerVM LPARs

[dpdk.git] / doc / guides / testpmd_app_ug / run_app.rst

diff --git a/doc/guides/testpmd_app_ug/run_app.rst b/doc/guides/testpmd_app_ug/run_app.rst
index 6745072..eb48318 100644 (file)
--- a/doc/guides/testpmd_app_ug/run_app.rst
+++ b/doc/guides/testpmd_app_ug/run_app.rst
@@ -356,14 +356,6 @@ The command line options are:
     Set the transmit RS bit threshold of TX rings to N, where 0 <= N <= value of ``--txd``.
     The default value is 0.
 
     Set the transmit RS bit threshold of TX rings to N, where 0 <= N <= value of ``--txd``.
     The default value is 0.
 

-*   ``--rx-queue-stats-mapping=(port,queue,mapping)[,(port,queue,mapping)]``
-
-    Set the RX queues statistics counters mapping 0 <= mapping <= 15.
-
-*   ``--tx-queue-stats-mapping=(port,queue,mapping)[,(port,queue,mapping)]``
-
-    Set the TX queues statistics counters mapping 0 <= mapping <= 15.
-

 *   ``--no-flush-rx``
 
     Don't flush the RX streams before starting forwarding. Used mainly with the PCAP PMD.
 *   ``--no-flush-rx``
 
     Don't flush the RX streams before starting forwarding. Used mainly with the PCAP PMD.


@@ -392,6 +384,21 @@ The command line options are:
 
     Generate multiple flows in txonly mode.
 
 
     Generate multiple flows in txonly mode.
 

+*   ``--eth-link-speed``
+
+    Set a forced link speed to the ethernet port::
+
+       10 - 10Mbps (not supported)
+       100 - 100Mbps (not supported)
+       1000 - 1Gbps
+       10000 - 10Gbps
+       25000 - 25Gbps
+       40000 - 40Gbps
+       50000 - 50Gbps
+       100000 - 100Gbps
+       200000 - 200Gbps
+       ...
+

 *   ``--disable-link-check``
 
     Disable check on link status when starting/stopping ports.
 *   ``--disable-link-check``
 
     Disable check on link status when starting/stopping ports.


@@ -531,8 +538,10 @@ The command line options are:
 
 *   ``--hairpin-mode=0xXX``
 
 
 *   ``--hairpin-mode=0xXX``
 

-    Set the hairpin port mode with bitmask, only valid when hairpin queues number is set.
-    bit 4 - explicit Tx flow rule
-    bit 1 - two hairpin ports paired
-    bit 0 - two hairpin ports loop
+    Set the hairpin port mode with bitmask, only valid when hairpin queues number is set::
+
+       bit 4 - explicit Tx flow rule
+       bit 1 - two hairpin ports paired
+       bit 0 - two hairpin ports loop
+

     The default value is 0. Hairpin will use single port mode and implicit Tx flow mode.
     The default value is 0. Hairpin will use single port mode and implicit Tx flow mode.