+/** Input Queue statistics. Each input queue has four stats fields. */
+struct lio_iq_stats {
+ uint64_t instr_posted; /**< Instructions posted to this queue. */
+ uint64_t instr_processed; /**< Instructions processed in this queue. */
+ uint64_t instr_dropped; /**< Instructions that could not be processed */
+ uint64_t bytes_sent; /**< Bytes sent through this queue. */
+ uint64_t tx_done; /**< Num of packets sent to network. */
+ uint64_t tx_iq_busy; /**< Num of times this iq was found to be full. */
+ uint64_t tx_dropped; /**< Num of pkts dropped due to xmitpath errors. */
+ uint64_t tx_tot_bytes; /**< Total count of bytes sent to network. */
+};
+
+/** Output Queue statistics. Each output queue has four stats fields. */
+struct lio_droq_stats {
+ /** Number of packets received in this queue. */
+ uint64_t pkts_received;
+
+ /** Bytes received by this queue. */
+ uint64_t bytes_received;
+
+ /** Packets dropped due to no memory available. */
+ uint64_t dropped_nomem;
+
+ /** Packets dropped due to large number of pkts to process. */
+ uint64_t dropped_toomany;
+
+ /** Number of packets sent to stack from this queue. */
+ uint64_t rx_pkts_received;
+
+ /** Number of Bytes sent to stack from this queue. */
+ uint64_t rx_bytes_received;
+
+ /** Num of Packets dropped due to receive path failures. */
+ uint64_t rx_dropped;
+
+ /** Num of vxlan packets received; */
+ uint64_t rx_vxlan;
+
+ /** Num of failures of rte_pktmbuf_alloc() */
+ uint64_t rx_alloc_failure;
+
+};
+
+/** The Descriptor Ring Output Queue structure.
+ * This structure has all the information required to implement a
+ * DROQ.
+ */
+struct lio_droq {
+ /** A spinlock to protect access to this ring. */
+ rte_spinlock_t lock;
+
+ uint32_t q_no;
+
+ uint32_t pkt_count;
+
+ struct lio_device *lio_dev;
+
+ /** The 8B aligned descriptor ring starts at this address. */
+ struct lio_droq_desc *desc_ring;
+
+ /** Index in the ring where the driver should read the next packet */
+ uint32_t read_idx;
+
+ /** Index in the ring where Octeon will write the next packet */
+ uint32_t write_idx;
+
+ /** Index in the ring where the driver will refill the descriptor's
+ * buffer
+ */
+ uint32_t refill_idx;
+
+ /** Packets pending to be processed */
+ rte_atomic64_t pkts_pending;
+
+ /** Number of descriptors in this ring. */
+ uint32_t nb_desc;
+
+ /** The number of descriptors pending refill. */
+ uint32_t refill_count;
+
+ uint32_t refill_threshold;
+
+ /** The 8B aligned info ptrs begin from this address. */
+ struct lio_droq_info *info_list;
+
+ /** The receive buffer list. This list has the virtual addresses of the
+ * buffers.
+ */
+ struct lio_recv_buffer *recv_buf_list;
+
+ /** The size of each buffer pointed by the buffer pointer. */
+ uint32_t buffer_size;
+
+ /** Pointer to the mapped packet credit register.
+ * Host writes number of info/buffer ptrs available to this register
+ */
+ void *pkts_credit_reg;
+
+ /** Pointer to the mapped packet sent register.
+ * Octeon writes the number of packets DMA'ed to host memory
+ * in this register.
+ */
+ void *pkts_sent_reg;
+
+ /** Statistics for this DROQ. */
+ struct lio_droq_stats stats;
+
+ /** DMA mapped address of the DROQ descriptor ring. */
+ size_t desc_ring_dma;
+
+ /** Info ptr list are allocated at this virtual address. */
+ size_t info_base_addr;
+
+ /** DMA mapped address of the info list */
+ size_t info_list_dma;
+
+ /** Allocated size of info list. */
+ uint32_t info_alloc_size;
+
+ /** Memory zone **/
+ const struct rte_memzone *desc_ring_mz;
+ const struct rte_memzone *info_mz;
+ struct rte_mempool *mpool;
+};
+
+/** Receive Header */
+union octeon_rh {
+#if RTE_BYTE_ORDER == RTE_BIG_ENDIAN
+ uint64_t rh64;
+ struct {
+ uint64_t opcode : 4;
+ uint64_t subcode : 8;
+ uint64_t len : 3; /** additional 64-bit words */
+ uint64_t reserved : 17;
+ uint64_t ossp : 32; /** opcode/subcode specific parameters */
+ } r;
+ struct {
+ uint64_t opcode : 4;
+ uint64_t subcode : 8;
+ uint64_t len : 3; /** additional 64-bit words */
+ uint64_t extra : 28;
+ uint64_t vlan : 12;
+ uint64_t priority : 3;
+ uint64_t csum_verified : 3; /** checksum verified. */
+ uint64_t has_hwtstamp : 1; /** Has hardware timestamp.1 = yes.*/
+ uint64_t encap_on : 1;
+ uint64_t has_hash : 1; /** Has hash (rth or rss). 1 = yes. */
+ } r_dh;
+ struct {
+ uint64_t opcode : 4;
+ uint64_t subcode : 8;
+ uint64_t len : 3; /** additional 64-bit words */
+ uint64_t reserved : 8;
+ uint64_t extra : 25;
+ uint64_t gmxport : 16;
+ } r_nic_info;
+#else
+ uint64_t rh64;
+ struct {
+ uint64_t ossp : 32; /** opcode/subcode specific parameters */
+ uint64_t reserved : 17;
+ uint64_t len : 3; /** additional 64-bit words */
+ uint64_t subcode : 8;
+ uint64_t opcode : 4;
+ } r;
+ struct {
+ uint64_t has_hash : 1; /** Has hash (rth or rss). 1 = yes. */
+ uint64_t encap_on : 1;
+ uint64_t has_hwtstamp : 1; /** 1 = has hwtstamp */
+ uint64_t csum_verified : 3; /** checksum verified. */
+ uint64_t priority : 3;
+ uint64_t vlan : 12;
+ uint64_t extra : 28;
+ uint64_t len : 3; /** additional 64-bit words */
+ uint64_t subcode : 8;
+ uint64_t opcode : 4;
+ } r_dh;
+ struct {
+ uint64_t gmxport : 16;
+ uint64_t extra : 25;
+ uint64_t reserved : 8;
+ uint64_t len : 3; /** additional 64-bit words */
+ uint64_t subcode : 8;
+ uint64_t opcode : 4;
+ } r_nic_info;
+#endif
+};
+
+#define OCTEON_RH_SIZE (sizeof(union octeon_rh))
+
+/** The txpciq info passed to host from the firmware */
+union octeon_txpciq {
+ uint64_t txpciq64;
+
+ struct {
+#if RTE_BYTE_ORDER == RTE_BIG_ENDIAN
+ uint64_t q_no : 8;
+ uint64_t port : 8;
+ uint64_t pkind : 6;
+ uint64_t use_qpg : 1;
+ uint64_t qpg : 11;
+ uint64_t aura_num : 10;
+ uint64_t reserved : 20;
+#else
+ uint64_t reserved : 20;
+ uint64_t aura_num : 10;
+ uint64_t qpg : 11;
+ uint64_t use_qpg : 1;
+ uint64_t pkind : 6;
+ uint64_t port : 8;
+ uint64_t q_no : 8;
+#endif
+ } s;
+};
+
+/** The instruction (input) queue.
+ * The input queue is used to post raw (instruction) mode data or packet
+ * data to Octeon device from the host. Each input queue for
+ * a LIO device has one such structure to represent it.
+ */
+struct lio_instr_queue {
+ /** A spinlock to protect access to the input ring. */
+ rte_spinlock_t lock;
+
+ rte_spinlock_t post_lock;
+
+ struct lio_device *lio_dev;
+
+ uint32_t pkt_in_done;
+
+ rte_atomic64_t iq_flush_running;
+
+ /** Flag that indicates if the queue uses 64 byte commands. */
+ uint32_t iqcmd_64B:1;
+
+ /** Queue info. */
+ union octeon_txpciq txpciq;
+
+ uint32_t rsvd:17;
+
+ uint32_t status:8;
+
+ /** Number of descriptors in this ring. */
+ uint32_t nb_desc;
+
+ /** Index in input ring where the driver should write the next packet */
+ uint32_t host_write_index;
+
+ /** Index in input ring where Octeon is expected to read the next
+ * packet.
+ */
+ uint32_t lio_read_index;
+
+ /** This index aids in finding the window in the queue where Octeon
+ * has read the commands.
+ */
+ uint32_t flush_index;
+
+ /** This field keeps track of the instructions pending in this queue. */
+ rte_atomic64_t instr_pending;
+
+ /** Pointer to the Virtual Base addr of the input ring. */
+ uint8_t *base_addr;
+
+ struct lio_request_list *request_list;
+
+ /** Octeon doorbell register for the ring. */
+ void *doorbell_reg;
+
+ /** Octeon instruction count register for this ring. */
+ void *inst_cnt_reg;
+
+ /** Number of instructions pending to be posted to Octeon. */
+ uint32_t fill_cnt;
+
+ /** Statistics for this input queue. */
+ struct lio_iq_stats stats;
+
+ /** DMA mapped base address of the input descriptor ring. */
+ uint64_t base_addr_dma;
+
+ /** Application context */
+ void *app_ctx;
+
+ /* network stack queue index */
+ int q_index;
+
+ /* Memory zone */
+ const struct rte_memzone *iq_mz;
+};
+
+/** This structure is used by driver to store information required
+ * to free the mbuff when the packet has been fetched by Octeon.
+ * Bytes offset below assume worst-case of a 64-bit system.
+ */
+struct lio_buf_free_info {
+ /** Bytes 1-8. Pointer to network device private structure. */
+ struct lio_device *lio_dev;
+
+ /** Bytes 9-16. Pointer to mbuff. */
+ struct rte_mbuf *mbuf;
+
+ /** Bytes 17-24. Pointer to gather list. */
+ struct lio_gather *g;
+
+ /** Bytes 25-32. Physical address of mbuf->data or gather list. */
+ uint64_t dptr;
+
+ /** Bytes 33-47. Piggybacked soft command, if any */
+ struct lio_soft_command *sc;
+
+ /** Bytes 48-63. iq no */
+ uint64_t iq_no;
+};
+
+/* The Scatter-Gather List Entry. The scatter or gather component used with
+ * input instruction has this format.
+ */
+struct lio_sg_entry {
+ /** The first 64 bit gives the size of data in each dptr. */
+ union {
+ uint16_t size[4];
+ uint64_t size64;
+ } u;
+
+ /** The 4 dptr pointers for this entry. */
+ uint64_t ptr[4];
+};
+
+#define LIO_SG_ENTRY_SIZE (sizeof(struct lio_sg_entry))
+
+/** Structure of a node in list of gather components maintained by
+ * driver for each network device.
+ */
+struct lio_gather {
+ /** List manipulation. Next and prev pointers. */
+ struct lio_stailq_node list;
+
+ /** Size of the gather component at sg in bytes. */
+ int sg_size;
+
+ /** Number of bytes that sg was adjusted to make it 8B-aligned. */
+ int adjust;
+
+ /** Gather component that can accommodate max sized fragment list
+ * received from the IP layer.
+ */
+ struct lio_sg_entry *sg;
+};
+
+struct lio_rss_ctx {
+ uint16_t hash_key_size;
+ uint8_t hash_key[LIO_RSS_MAX_KEY_SZ];
+ /* Ideally a factor of number of queues */
+ uint8_t itable[LIO_RSS_MAX_TABLE_SZ];
+ uint8_t itable_size;
+ uint8_t ip;
+ uint8_t tcp_hash;
+ uint8_t ipv6;
+ uint8_t ipv6_tcp_hash;
+ uint8_t ipv6_ex;
+ uint8_t ipv6_tcp_ex_hash;
+ uint8_t hash_disable;
+};
+
+struct lio_io_enable {
+ uint64_t iq;
+ uint64_t oq;
+ uint64_t iq64B;
+};
+