#include <rte_ether.h>
#include <rte_ethdev.h>
#include <rte_string_fns.h>
-#ifdef RTE_LIBRTE_CMDLINE
-#include <cmdline_parse.h>
-#include <cmdline_parse_etheraddr.h>
-#endif
#ifdef RTE_LIBRTE_PMD_BOND
#include <rte_eth_bond.h>
#endif
"--rss-ip | --rss-udp | "
"--rxpt= | --rxht= | --rxwt= | --rxfreet= | "
"--txpt= | --txht= | --txwt= | --txfreet= | "
- "--txrst= | --tx-offloads= | --vxlan-gpe-port= ]\n",
+ "--txrst= | --tx-offloads= | | --rx-offloads= | "
+ "--vxlan-gpe-port= ]\n",
progname);
#ifdef RTE_LIBRTE_CMDLINE
printf(" --interactive: run in interactive mode.\n");
printf(" --total-num-mbufs=N: set the number of mbufs to be allocated "
"in mbuf pools.\n");
printf(" --max-pkt-len=N: set the maximum size of packet to N bytes.\n");
+ printf(" --max-lro-pkt-size=N: set the maximum LRO aggregated packet "
+ "size to N bytes.\n");
#ifdef RTE_LIBRTE_CMDLINE
printf(" --eth-peers-configfile=name: config file with ethernet addresses "
"of peer ports.\n");
printf(" --enable-hw-vlan-filter: enable hardware vlan filter.\n");
printf(" --enable-hw-vlan-strip: enable hardware vlan strip.\n");
printf(" --enable-hw-vlan-extend: enable hardware vlan extend.\n");
+ printf(" --enable-hw-qinq-strip: enable hardware qinq strip.\n");
printf(" --enable-drop-en: enable per queue packet drop.\n");
printf(" --disable-rss: disable rss.\n");
- printf(" --port-topology=N: set port topology (N: paired (default) or "
- "chained).\n");
+ printf(" --port-topology=<paired|chained|loop>: set port topology (paired "
+ "is default).\n");
printf(" --forward-mode=N: set forwarding mode (N: %s).\n",
list_pkt_forwarding_modes());
printf(" --rss-ip: set RSS functions to IPv4/IPv6 only .\n");
printf(" --rxd=N: set the number of descriptors in RX rings to N.\n");
printf(" --txq=N: set the number of TX queues per port to N.\n");
printf(" --txd=N: set the number of descriptors in TX rings to N.\n");
+ printf(" --hairpinq=N: set the number of hairpin queues per port to "
+ "N.\n");
printf(" --burst=N: set the number of packets per burst to N.\n");
printf(" --mbcache=N: set the cache of mbuf memory pool to N.\n");
printf(" --rxpt=N: set prefetch threshold register of RX rings to N.\n");
printf(" --txonly-multi-flow: generate multiple flows in txonly mode\n");
printf(" --disable-link-check: disable check on link status when "
"starting/stopping ports.\n");
+ printf(" --disable-device-start: do not automatically start port\n");
printf(" --no-lsc-interrupt: disable link status change interrupt.\n");
printf(" --no-rmv-interrupt: disable device removal interrupt.\n");
printf(" --bitrate-stats=N: set the logical core N to perform "
printf(" --flow-isolate-all: "
"requests flow API isolated mode on all ports at initialization time.\n");
printf(" --tx-offloads=0xXXXXXXXX: hexadecimal bitmask of TX queue offloads\n");
+ printf(" --rx-offloads=0xXXXXXXXX: hexadecimal bitmask of RX queue offloads\n");
printf(" --hot-plug: enable hot plug for device.\n");
printf(" --vxlan-gpe-port=N: UPD port of tunnel VXLAN-GPE\n");
printf(" --mlockall: lock all memory\n");
if (fgets(buf, sizeof(buf), config_file) == NULL)
break;
- if (cmdline_parse_etheraddr(NULL, buf, &peer_eth_addrs[i],
- sizeof(peer_eth_addrs[i])) < 0) {
+ if (rte_ether_unformat_addr(buf, &peer_eth_addrs[i]) < 0) {
printf("Bad MAC address format on line %d\n", i+1);
fclose(config_file);
return -1;
uint64_t tx_offloads = tx_mode.offloads;
struct rte_eth_dev_info dev_info;
uint16_t rec_nb_pkts;
+ int ret;
static struct option lgopts[] = {
{ "help", 0, 0, 0 },
{ "mbuf-size", 1, 0, 0 },
{ "total-num-mbufs", 1, 0, 0 },
{ "max-pkt-len", 1, 0, 0 },
+ { "max-lro-pkt-size", 1, 0, 0 },
{ "pkt-filter-mode", 1, 0, 0 },
{ "pkt-filter-report-hash", 1, 0, 0 },
{ "pkt-filter-size", 1, 0, 0 },
{ "enable-hw-vlan-filter", 0, 0, 0 },
{ "enable-hw-vlan-strip", 0, 0, 0 },
{ "enable-hw-vlan-extend", 0, 0, 0 },
+ { "enable-hw-qinq-strip", 0, 0, 0 },
{ "enable-drop-en", 0, 0, 0 },
{ "disable-rss", 0, 0, 0 },
{ "port-topology", 1, 0, 0 },
{ "txq", 1, 0, 0 },
{ "rxd", 1, 0, 0 },
{ "txd", 1, 0, 0 },
+ { "hairpinq", 1, 0, 0 },
{ "burst", 1, 0, 0 },
{ "mbcache", 1, 0, 0 },
{ "txpt", 1, 0, 0 },
{ "txpkts", 1, 0, 0 },
{ "txonly-multi-flow", 0, 0, 0 },
{ "disable-link-check", 0, 0, 0 },
+ { "disable-device-start", 0, 0, 0 },
{ "no-lsc-interrupt", 0, 0, 0 },
{ "no-rmv-interrupt", 0, 0, 0 },
{ "print-event", 1, 0, 0 },
{ "mask-event", 1, 0, 0 },
{ "tx-offloads", 1, 0, 0 },
+ { "rx-offloads", 1, 0, 0 },
{ "hot-plug", 0, 0, 0 },
{ "vxlan-gpe-port", 1, 0, 0 },
{ "mlockall", 0, 0, 0 },
}
if (!strcmp(lgopts[opt_idx].name, "eth-peer")) {
char *port_end;
- uint8_t c, peer_addr[6];
errno = 0;
n = strtoul(optarg, &port_end, 10);
"eth-peer: port %d >= RTE_MAX_ETHPORTS(%d)\n",
n, RTE_MAX_ETHPORTS);
- if (cmdline_parse_etheraddr(NULL, port_end,
- &peer_addr, sizeof(peer_addr)) < 0)
+ if (rte_ether_unformat_addr(port_end,
+ &peer_eth_addrs[n]) < 0)
rte_exit(EXIT_FAILURE,
"Invalid ethernet address: %s\n",
port_end);
- for (c = 0; c < 6; c++)
- peer_eth_addrs[n].addr_bytes[c] =
- peer_addr[c];
nb_peer_eth_addrs++;
}
#endif
"Invalid max-pkt-len=%d - should be > %d\n",
n, RTE_ETHER_MIN_LEN);
}
+ if (!strcmp(lgopts[opt_idx].name, "max-lro-pkt-size")) {
+ n = atoi(optarg);
+ rx_mode.max_lro_pkt_size = (uint32_t) n;
+ }
if (!strcmp(lgopts[opt_idx].name, "pkt-filter-mode")) {
if (!strcmp(optarg, "signature"))
fdir_conf.mode =
"enable-hw-vlan-extend"))
rx_offloads |= DEV_RX_OFFLOAD_VLAN_EXTEND;
+ if (!strcmp(lgopts[opt_idx].name,
+ "enable-hw-qinq-strip"))
+ rx_offloads |= DEV_RX_OFFLOAD_QINQ_STRIP;
+
if (!strcmp(lgopts[opt_idx].name, "enable-drop-en"))
rx_drop_en = 1;
" >= 0 && <= %u\n", n,
get_allowed_max_nb_txq(&pid));
}
+ if (!strcmp(lgopts[opt_idx].name, "hairpinq")) {
+ n = atoi(optarg);
+ if (n >= 0 &&
+ check_nb_hairpinq((queueid_t)n) == 0)
+ nb_hairpinq = (queueid_t) n;
+ else
+ rte_exit(EXIT_FAILURE, "txq %d invalid - must be"
+ " >= 0 && <= %u\n", n,
+ get_allowed_max_nb_hairpinq
+ (&pid));
+ if ((n + nb_txq) < 0 ||
+ check_nb_txq((queueid_t)(n + nb_txq)) != 0)
+ rte_exit(EXIT_FAILURE, "txq + hairpinq "
+ "%d invalid - must be"
+ " >= 0 && <= %u\n",
+ n + nb_txq,
+ get_allowed_max_nb_txq(&pid));
+ if ((n + nb_rxq) < 0 ||
+ check_nb_rxq((queueid_t)(n + nb_rxq)) != 0)
+ rte_exit(EXIT_FAILURE, "rxq + hairpinq "
+ "%d invalid - must be"
+ " >= 0 && <= %u\n",
+ n + nb_rxq,
+ get_allowed_max_nb_rxq(&pid));
+ }
if (!nb_rxq && !nb_txq) {
rte_exit(EXIT_FAILURE, "Either rx or tx queues should "
"be non-zero\n");
* value, on the assumption that all
* ports are of the same NIC model.
*/
- rte_eth_dev_info_get(0, &dev_info);
+ ret = eth_dev_info_get_print_err(
+ 0,
+ &dev_info);
+ if (ret != 0)
+ return;
+
rec_nb_pkts = dev_info
.default_rxportconf.burst_size;
no_flush_rx = 1;
if (!strcmp(lgopts[opt_idx].name, "disable-link-check"))
no_link_check = 1;
+ if (!strcmp(lgopts[opt_idx].name, "disable-device-start"))
+ no_device_start = 1;
if (!strcmp(lgopts[opt_idx].name, "no-lsc-interrupt"))
lsc_interrupt = 0;
if (!strcmp(lgopts[opt_idx].name, "no-rmv-interrupt"))
rte_exit(EXIT_FAILURE,
"tx-offloads must be >= 0\n");
}
+
+ if (!strcmp(lgopts[opt_idx].name, "rx-offloads")) {
+ char *end = NULL;
+ n = strtoull(optarg, &end, 16);
+ if (n >= 0)
+ rx_offloads = (uint64_t)n;
+ else
+ rte_exit(EXIT_FAILURE,
+ "rx-offloads must be >= 0\n");
+ }
+
if (!strcmp(lgopts[opt_idx].name, "vxlan-gpe-port")) {
n = atoi(optarg);
if (n >= 0)
break;
default:
usage(argv[0]);
+ printf("Invalid option: %s\n", argv[optind]);
rte_exit(EXIT_FAILURE,
"Command line is incomplete or incorrect\n");
break;
}
}
+ if (optind != argc) {
+ usage(argv[0]);
+ printf("Invalid parameter: %s\n", argv[optind]);
+ rte_exit(EXIT_FAILURE, "Command line is incorrect\n");
+ }
+
/* Set offload configuration from command line parameters. */
rx_mode.offloads = rx_offloads;
tx_mode.offloads = tx_offloads;
git.droids-corp.org / dpdk.git / blobdiff