/*-
* BSD LICENSE
*
- * Copyright(c) 2010-2016 Intel Corporation. All rights reserved.
+ * Copyright(c) 2010-2017 Intel Corporation. All rights reserved.
* All rights reserved.
*
* Redistribution and use in source and binary forms, with or without
#include <rte_lcore.h>
#include <rte_atomic.h>
#include <rte_branch_prediction.h>
-#include <rte_ring.h>
#include <rte_mempool.h>
#include <rte_interrupts.h>
#include <rte_pci.h>
#ifdef RTE_LIBRTE_PMD_BOND
#include <rte_eth_bond.h>
#endif
+#include <rte_flow.h>
#include "testpmd.h"
printf("usage: %s "
#ifdef RTE_LIBRTE_CMDLINE
"[--interactive|-i] "
+ "[--cmdline-file=FILENAME] "
#endif
"[--help|-h] | [--auto-start|-a] | ["
"--coremask=COREMASK --portmask=PORTMASK --numa "
progname);
#ifdef RTE_LIBRTE_CMDLINE
printf(" --interactive: run in interactive mode.\n");
+ printf(" --cmdline-file: execute cli commands before startup.\n");
#endif
printf(" --auto-start: start forwarding on init "
"[always when non-interactive].\n");
"the packet will be enqueued into the rx drop-queue. "
"If the drop-queue doesn't exist, the packet is dropped. "
"By default drop-queue=127.\n");
- printf(" --crc-strip: enable CRC stripping by hardware.\n");
+#ifdef RTE_LIBRTE_LATENCY_STATS
+ printf(" --latencystats=N: enable latency and jitter statistcs "
+ "monitoring on forwarding lcore id N.\n");
+#endif
+ printf(" --disable-crc-strip: disable CRC stripping by hardware.\n");
+ printf(" --enable-lro: enable large receive offload.\n");
printf(" --enable-rx-cksum: enable rx hardware checksum offload.\n");
printf(" --disable-hw-vlan: disable hardware vlan.\n");
printf(" --disable-hw-vlan-filter: disable hardware vlan filter.\n");
"(0 <= mapping <= %d).\n", RTE_ETHDEV_QUEUE_STAT_CNTRS - 1);
printf(" --no-flush-rx: Don't flush RX streams before forwarding."
" Used mainly with PCAP drivers.\n");
- printf(" --txpkts=X[,Y]*: set TX segment sizes.\n");
+ printf(" --txpkts=X[,Y]*: set TX segment sizes"
+ " or total packet length.\n");
printf(" --disable-link-check: disable check on link status when "
"starting/stopping ports.\n");
+ printf(" --no-lsc-interrupt: disable link status change interrupt.\n");
+ printf(" --no-rmv-interrupt: disable device removal interrupt.\n");
+ printf(" --bitrate-stats=N: set the logical core N to perform "
+ "bit-rate calculation.\n");
}
#ifdef RTE_LIBRTE_CMDLINE
port_id = (uint8_t)int_fld[FLD_PORT];
if (port_id_is_invalid(port_id, ENABLED_WARN)) {
printf("Valid port range is [0");
- FOREACH_PORT(pid, ports)
+ RTE_ETH_FOREACH_DEV(pid)
printf(", %d", pid);
printf("]\n");
return -1;
port_id = (uint8_t)int_fld[FLD_PORT];
if (port_id_is_invalid(port_id, ENABLED_WARN)) {
printf("Valid port range is [0");
- FOREACH_PORT(pid, ports)
+ RTE_ETH_FOREACH_DEV(pid)
printf(", %d", pid);
printf("]\n");
return -1;
{ "help", 0, 0, 0 },
#ifdef RTE_LIBRTE_CMDLINE
{ "interactive", 0, 0, 0 },
+ { "cmdline-file", 1, 0, 0 },
{ "auto-start", 0, 0, 0 },
{ "eth-peers-configfile", 1, 0, 0 },
{ "eth-peer", 1, 0, 0 },
{ "coremask", 1, 0, 0 },
{ "portmask", 1, 0, 0 },
{ "numa", 0, 0, 0 },
+ { "no-numa", 0, 0, 0 },
{ "mp-anon", 0, 0, 0 },
{ "port-numa-config", 1, 0, 0 },
{ "ring-numa-config", 1, 0, 0 },
{ "pkt-filter-report-hash", 1, 0, 0 },
{ "pkt-filter-size", 1, 0, 0 },
{ "pkt-filter-drop-queue", 1, 0, 0 },
- { "crc-strip", 0, 0, 0 },
+#ifdef RTE_LIBRTE_LATENCY_STATS
+ { "latencystats", 1, 0, 0 },
+#endif
+#ifdef RTE_LIBRTE_BITRATE
+ { "bitrate-stats", 1, 0, 0 },
+#endif
+ { "disable-crc-strip", 0, 0, 0 },
+ { "enable-lro", 0, 0, 0 },
{ "enable-rx-cksum", 0, 0, 0 },
{ "enable-scatter", 0, 0, 0 },
{ "disable-hw-vlan", 0, 0, 0 },
{ "no-flush-rx", 0, 0, 0 },
{ "txpkts", 1, 0, 0 },
{ "disable-link-check", 0, 0, 0 },
+ { "no-lsc-interrupt", 0, 0, 0 },
+ { "no-rmv-interrupt", 0, 0, 0 },
{ 0, 0, 0, 0 },
};
printf("Interactive-mode selected\n");
interactive = 1;
}
+ if (!strcmp(lgopts[opt_idx].name, "cmdline-file")) {
+ printf("CLI commands to be read from %s\n",
+ optarg);
+ snprintf(cmdline_filename,
+ sizeof(cmdline_filename), "%s",
+ optarg);
+ }
if (!strcmp(lgopts[opt_idx].name, "auto-start")) {
printf("Auto-start selected\n");
auto_start = 1;
parse_fwd_coremask(optarg);
if (!strcmp(lgopts[opt_idx].name, "portmask"))
parse_fwd_portmask(optarg);
- if (!strcmp(lgopts[opt_idx].name, "numa")) {
+ if (!strcmp(lgopts[opt_idx].name, "no-numa"))
+ numa_support = 0;
+ if (!strcmp(lgopts[opt_idx].name, "numa"))
numa_support = 1;
- memset(port_numa,NUMA_NO_CONFIG,RTE_MAX_ETHPORTS);
- memset(rxring_numa,NUMA_NO_CONFIG,RTE_MAX_ETHPORTS);
- memset(txring_numa,NUMA_NO_CONFIG,RTE_MAX_ETHPORTS);
- }
if (!strcmp(lgopts[opt_idx].name, "mp-anon")) {
mp_anon = 1;
}
"drop queue %d invalid - must"
"be >= 0 \n", n);
}
- if (!strcmp(lgopts[opt_idx].name, "crc-strip"))
- rx_mode.hw_strip_crc = 1;
+#ifdef RTE_LIBRTE_LATENCY_STATS
+ if (!strcmp(lgopts[opt_idx].name,
+ "latencystats")) {
+ n = atoi(optarg);
+ if (n >= 0) {
+ latencystats_lcore_id = (lcoreid_t) n;
+ latencystats_enabled = 1;
+ } else
+ rte_exit(EXIT_FAILURE,
+ "invalid lcore id %d for latencystats"
+ " must be >= 0\n", n);
+ }
+#endif
+#ifdef RTE_LIBRTE_BITRATE
+ if (!strcmp(lgopts[opt_idx].name, "bitrate-stats")) {
+ n = atoi(optarg);
+ if (n >= 0) {
+ bitrate_lcore_id = (lcoreid_t) n;
+ bitrate_enabled = 1;
+ } else
+ rte_exit(EXIT_FAILURE,
+ "invalid lcore id %d for bitrate stats"
+ " must be >= 0\n", n);
+ }
+#endif
+ if (!strcmp(lgopts[opt_idx].name, "disable-crc-strip"))
+ rx_mode.hw_strip_crc = 0;
+ if (!strcmp(lgopts[opt_idx].name, "enable-lro"))
+ rx_mode.enable_lro = 1;
if (!strcmp(lgopts[opt_idx].name, "enable-scatter"))
rx_mode.enable_scatter = 1;
if (!strcmp(lgopts[opt_idx].name, "enable-rx-cksum"))
no_flush_rx = 1;
if (!strcmp(lgopts[opt_idx].name, "disable-link-check"))
no_link_check = 1;
+ if (!strcmp(lgopts[opt_idx].name, "no-lsc-interrupt"))
+ lsc_interrupt = 0;
+ if (!strcmp(lgopts[opt_idx].name, "no-rmv-interrupt"))
+ rmv_interrupt = 0;
break;
case 'h':
git.droids-corp.org / dpdk.git / blobdiff