printf("Done\n");
}
+void
+reset_port(portid_t pid)
+{
+ int diag;
+ portid_t pi;
+ struct rte_port *port;
+
+ if (port_id_is_invalid(pid, ENABLED_WARN))
+ return;
+
+ printf("Resetting ports...\n");
+
+ RTE_ETH_FOREACH_DEV(pi) {
+ if (pid != pi && pid != (portid_t)RTE_PORT_ALL)
+ continue;
+
+ if (port_is_forwarding(pi) != 0 && test_done == 0) {
+ printf("Please remove port %d from forwarding "
+ "configuration.\n", pi);
+ continue;
+ }
+
+ if (port_is_bonding_slave(pi)) {
+ printf("Please remove port %d from bonded device.\n",
+ pi);
+ continue;
+ }
+
+ diag = rte_eth_dev_reset(pi);
+ if (diag == 0) {
+ port = &ports[pi];
+ port->need_reconfig = 1;
+ port->need_reconfig_queues = 1;
+ } else {
+ printf("Failed to reset port %d. diag=%d\n", pi, diag);
+ }
+ }
+
+ printf("Done\n");
+}
+
void
attach_port(char *identifier)
{
if (ports[port_id].flow_list)
port_flow_flush(port_id);
- if (rte_eth_dev_detach(port_id, name))
+ if (rte_eth_dev_detach(port_id, name)) {
+ RTE_LOG(ERR, USER1, "Failed to detach port '%s'\n", name);
return;
+ }
nb_ports = rte_eth_dev_count();
stop_port(port_id);
close_port(port_id);
printf("removing device %s\n", dev->device->name);
- rte_eal_dev_detach(dev->device);
- dev->state = RTE_ETH_DEV_UNUSED;
+ if (rte_eal_dev_detach(dev->device))
+ RTE_LOG(ERR, USER1, "Failed to detach device %s\n",
+ dev->device->name);
}
/* This function is used by the interrupt thread */
* Set the numbers of RX & TX queues to 0, so
* the RX & TX queues will not be setup.
*/
- (void)rte_eth_dev_configure(pid, 0, 0, &port_conf);
+ rte_eth_dev_configure(pid, 0, 0, &port_conf);
rte_eth_dev_info_get(pid, &rte_port->dev_info);
if (tx_first && interactive)
rte_exit(EXIT_FAILURE, "--tx-first cannot be used on "
"interactive mode.\n");
+
+ if (tx_first && lsc_interrupt) {
+ printf("Warning: lsc_interrupt needs to be off when "
+ " using tx_first. Disabling.\n");
+ lsc_interrupt = 0;
+ }
+
if (!nb_rxq && !nb_txq)
printf("Warning: Either rx or tx queues should be non-zero\n");