* 32K
+Checksum:
+
+ * CRC32
+ * ADLER32
+
+To enable a checksum in the driver, the compression and/or decompression xform
+structure, rte_comp_xform, must be filled with either of the CompressDev
+checksum flags supported. ::
+
+ compress_xform->compress.chksum = RTE_COMP_CHECKSUM_CRC32
+
+ decompress_xform->decompress.chksum = RTE_COMP_CHECKSUM_CRC32
+
+::
+
+ compress_xform->compress.chksum = RTE_COMP_CHECKSUM_ADLER32
+
+ decompress_xform->decompress.chksum = RTE_COMP_CHECKSUM_ADLER32
+
+If you request a checksum for compression or decompression,
+the checksum field in the operation structure, ``op->output_chksum``,
+will be filled with the checksum.
+
+.. Note::
+
+ For the compression case above, your output buffer will need to be large enough to hold the compressed data plus a scratchpad for the checksum at the end, the scratchpad is 8 bytes for CRC32 and 4 bytes for Adler32.
+
Level guide:
The ISA-L levels have been mapped to somewhat correspond to the same ZLIB level,
The above table only shows mapping when API calls for dynamic compression.
For fixed compression, regardless of API level, internally ISA-L level 0 is always used.
+
Limitations
-----------
-* Chained mbufs will not be supported until a future release, meaning max data size being passed to PMD through a single mbuf is 64K - 1. If data is larger than this it will need to be split up and sent as multiple operations.
-
* Compressdev level 0, no compression, is not supported.
-* Checksums will not be supported until future release.
-
Installation
------------