See :doc:`../platform/dpaa2` for setup information
-Currently supported by DPDK:
-
-- NXP LSDK **19.08+**.
-- MC Firmware version **10.18.0** and higher.
-- Supported architectures: **arm64 LE**.
-
- Follow the DPDK :ref:`Getting Started Guide for Linux <linux_gsg>` to setup the basic DPDK environment.
.. note::
In this mode tx conf queues need to be polled to free the buffers.
e.g. ``fslmc:dpni.1,drv_tx_conf=1``
+* Use dev arg option ``drv_error_queue=1`` to enable Packets in Error queue.
+ DPAA2 hardware drops the error packet in hardware. This option enables the
+ hardware to not drop the error packet and let the driver dump the error
+ packets, so that user can check what is wrong with those packets.
+ e.g. ``fslmc:dpni.1,drv_error_queue=1``
+
Enabling logs
-------------
~~~~~~~~~~~~~~~~~~~~~
The DPAA2 SoC family support a maximum of a 10240 jumbo frame. The value
-is fixed and cannot be changed. So, even when the ``rxmode.max_rx_pkt_len``
+is fixed and cannot be changed. So, even when the ``rxmode.mtu``
member of ``struct rte_eth_conf`` is set to a value lower than 10240, frames
up to 10240 bytes can still reach the host interface.