net/mlx5: enable secondary process to register DMA memory

[dpdk.git] / doc / guides / nics / enic.rst

diff --git a/doc/guides/nics/enic.rst b/doc/guides/nics/enic.rst
index 526e58c..726a69e 100644 (file)
--- a/doc/guides/nics/enic.rst
+++ b/doc/guides/nics/enic.rst
@@ -247,7 +247,7 @@ Generic Flow API is supported. The baseline support is:
   in the pattern.
 
   - Attributes: ingress
-  - Items: eth, ipv4, ipv6, udp, tcp, vxlan, inner eth, ipv4, ipv6, udp, tcp
+  - Items: eth, vlan, ipv4, ipv6, udp, tcp, vxlan, inner eth, vlan, ipv4, ipv6, udp, tcp
   - Actions: queue and void
   - Selectors: 'is', 'spec' and 'mask'. 'last' is not supported
   - In total, up to 64 bytes of mask is allowed across all headers
@@ -255,7 +255,7 @@ Generic Flow API is supported. The baseline support is:
 - **1300 and later series VICS with advanced filters enabled**
 
   - Attributes: ingress
-  - Items: eth, ipv4, ipv6, udp, tcp, vxlan, inner eth, ipv4, ipv6, udp, tcp
+  - Items: eth, vlan, ipv4, ipv6, udp, tcp, vxlan, raw, inner eth, vlan, ipv4, ipv6, udp, tcp
   - Actions: queue, mark, drop, flag, rss, passthru, and void
   - Selectors: 'is', 'spec' and 'mask'. 'last' is not supported
   - In total, up to 64 bytes of mask is allowed across all headers
@@ -266,6 +266,12 @@ Generic Flow API is supported. The baseline support is:
 
   - Action: count
 
+The VIC performs packet matching after applying VLAN strip. If VLAN
+stripping is enabled, EtherType in the ETH item corresponds to the
+stripped VLAN header's EtherType. Stripping does not affect the VLAN
+item. TCI and EtherType in the VLAN item are matched against those in
+the (stripped) VLAN header whether stripping is enabled or disabled.
+
 More features may be added in future firmware and new versions of the VIC.
 Please refer to the release notes.
 
@@ -455,6 +461,7 @@ PKT_RX_VLAN_STRIPPED mbuf flags would not be set. This mode is enabled with the
     to supporting MARK + RSS and PASSTHRU + MARK to allow the application to mark
     packets and then receive them normally. These require 1400 series VIC adapters
     and latest firmware.
+  - RAW items are limited to matching UDP tunnel headers like VXLAN.
 
 - **Statistics**
 
@@ -577,7 +584,7 @@ PMD.  Typically, the limit has to be raised to higher than 2GB.
 e.g., 2621440
 
 The compilation of any unused drivers can be disabled using the
-configuration file in config/ directory (e.g., config/common_linuxapp).
+configuration file in config/ directory (e.g., config/common_linux).
 This would help in bringing down the time taken for building the
 libraries and the initialization time of the application.