doc: remove reference to make from tools guide

[dpdk.git] / doc / guides / nics / enic.rst

diff --git a/doc/guides/nics/enic.rst b/doc/guides/nics/enic.rst
index 65e536d..c624487 100644 (file)
--- a/doc/guides/nics/enic.rst
+++ b/doc/guides/nics/enic.rst
@@ -14,19 +14,12 @@ How to obtain ENIC PMD integrated DPDK
 --------------------------------------
 
 ENIC PMD support is integrated into the DPDK suite. dpdk-<version>.tar.gz
-should be downloaded from http://core.dpdk.org/download/
+should be downloaded from https://core.dpdk.org/download/
 
 
 Configuration information
 -------------------------
 
-- **DPDK Configuration Parameters**
-
-  The following configuration options are available for the ENIC PMD:
-
-  - **CONFIG_RTE_LIBRTE_ENIC_PMD** (default y): Enables or disables inclusion
-    of the ENIC PMD driver in the DPDK compilation.
-
 - **vNIC Configuration Parameters**
 
   - **Number of Queues**
@@ -459,6 +452,10 @@ PKT_RX_VLAN_STRIPPED mbuf flags would not be set. This mode is enabled with the
     packets and then receive them normally. These require 1400 series VIC adapters
     and latest firmware.
   - RAW items are limited to matching UDP tunnel headers like VXLAN.
+  - For 1400 VICs, all flows using the RSS action on a port use same hash
+    configuration. The RETA is ignored. The queues used in the RSS group must be
+    sequential. There is a performance hit if the number of queues is not a power of 2.
+    Only level 0 (outer header) RSS is allowed.
 
 - **Statistics**
 
@@ -579,11 +576,6 @@ The value depends on the memory configuration of the application, DPDK and
 PMD.  Typically, the limit has to be raised to higher than 2GB.
 e.g., 2621440
 
-The compilation of any unused drivers can be disabled using the
-configuration file in config/ directory (e.g., config/common_linux).
-This would help in bringing down the time taken for building the
-libraries and the initialization time of the application.
-
 Additional Reference
 --------------------