Unicast MAC filter
------------------
-Supports adding MAC addresses to enable whitelist filtering to accept packets.
+Supports adding MAC addresses to enable incoming filtering of packets.
* **[implements] eth_dev_ops**: ``mac_addr_set``, ``mac_addr_add``, ``mac_addr_remove``.
* **[implements] rte_eth_dev_data**: ``mac_addrs``.
``rte_eth_dev_priority_flow_ctrl_set()``.
-.. _nic_features_flow_api:
-
-Flow API
---------
-
-Supports the DPDK Flow API for generic filtering.
-
-* **[implements] eth_dev_ops**: ``filter_ctrl:RTE_ETH_FILTER_GENERIC``.
-* **[implements] rte_flow_ops**: ``All``.
-
-
.. _nic_features_rate_limitation:
Rate limitation
``tx_offload_capa,tx_queue_offload_capa:DEV_TX_OFFLOAD_QINQ_INSERT``.
+.. _nic_features_fec:
+
+FEC
+---
+
+Supports Forward error correction. Forward error correction (FEC) is a bit error correction mode.
+It adds error correction information to data packets at the transmit end, and uses the error correction
+information to correct the bit errors generated during data packet transmission at the receive end. This
+improves signal quality but also brings a delay to signals. This function can be enabled or disabled as required.
+
+* **[implements] eth_dev_ops**: ``fec_get_capability``, ``fec_get``, ``fec_set``.
+* **[provides] rte_eth_fec_capa**: ``speed:ETH_SPEED_NUM_*``, ``capa:RTE_ETH_FEC_MODE_TO_CAPA()``.
+* **[related] API**: ``rte_eth_fec_get_capability()``, ``rte_eth_fec_get()``, ``rte_eth_fec_set()``.
+
+
.. _nic_features_l3_checksum_offload:
L3 checksum offload
``mbuf.ol_flags:PKT_TX_OUTER_IP_CKSUM``,
``mbuf.ol_flags:PKT_TX_OUTER_IPV4`` | ``PKT_TX_OUTER_IPV6``.
* **[uses] mbuf**: ``mbuf.outer_l2_len``, ``mbuf.outer_l3_len``.
-* **[provides] mbuf**: ``mbuf.ol_flags:PKT_RX_EIP_CKSUM_BAD``.
+* **[provides] mbuf**: ``mbuf.ol_flags:PKT_RX_OUTER_IP_CKSUM_BAD``.
* **[provides] rte_eth_dev_info**: ``rx_offload_capa,rx_queue_offload_capa:DEV_RX_OFFLOAD_OUTER_IPV4_CKSUM``,
``tx_offload_capa,tx_queue_offload_capa:DEV_TX_OFFLOAD_OUTER_IPV4_CKSUM``.
Driver can be used for primary-secondary process model.
-.. _nic_features_bsd_nic_uio:
+.. _nic_features_freebsd:
-BSD nic_uio
------------
+FreeBSD
+-------
-BSD ``nic_uio`` module supported.
+Supports running on FreeBSD.
-.. _nic_features_linux_uio:
+.. _nic_features_linux:
-Linux UIO
----------
-
-Works with ``igb_uio`` kernel module.
-
-* **[provides] RTE_PMD_REGISTER_KMOD_DEP**: ``igb_uio``.
-
-.. _nic_features_linux_vfio:
-
-Linux VFIO
-----------
+Linux
+-----
-Works with ``vfio-pci`` kernel module.
+Supports running on Linux.
-* **[provides] RTE_PMD_REGISTER_KMOD_DEP**: ``vfio-pci``.
-.. _nic_features_other_kdrv:
+.. _nic_features_windows:
-Other kdrv
-----------
+Windows
+-------
-Kernel module other than above ones supported.
+Supports running on Windows.
.. _nic_features_armv7:
* **[implements] eth_dev_ops**: ``rx_burst_mode_get``, ``tx_burst_mode_get``.
* **[related] API**: ``rte_eth_rx_burst_mode_get()``, ``rte_eth_tx_burst_mode_get()``.
+.. _nic_features_get_monitor_addr:
+
+PMD power management using monitor addresses
+--------------------------------------------
+
+Supports getting a monitoring condition to use together with Ethernet PMD power
+management (see :doc:`../prog_guide/power_man` for more details).
+
+* **[implements] eth_dev_ops**: ``get_monitor_addr``
+
.. _nic_features_other:
Other dev ops not represented by a Feature
* ``vlan_strip_queue_set``
* ``vlan_pvid_set``
* ``rx_queue_count``
-* ``l2_tunnel_offload_set``
* ``uc_hash_table_set``
* ``uc_all_hash_table_set``
* ``udp_tunnel_port_add``
* ``udp_tunnel_port_del``
-* ``l2_tunnel_eth_type_conf``
-* ``l2_tunnel_offload_set``
* ``tx_pkt_prepare``