* HW extend dual VLAN
-* Enabled by RX_OLFLAGS (RTE_IXGBE_RX_OLFLAGS_ENABLE=y)
-
-
To guarantee the constraint, configuration flags in dev_conf.rxmode will be checked:
* hw_vlan_strip
Sample Application Notes
------------------------
-testpmd
-~~~~~~~
-
-By default, using CONFIG_RTE_IXGBE_RX_OLFLAGS_ENABLE=y:
-
-.. code-block:: console
-
- ./x86_64-native-linuxapp-gcc/app/testpmd -c 300 -n 4 -- -i --burst=32 --rxfreet=32 --mbcache=250 --txpt=32 --rxht=8 --rxwt=0 --txfreet=32 --txrst=32 --txqflags=0xf01
-
-When CONFIG_RTE_IXGBE_RX_OLFLAGS_ENABLE=n, better performance can be achieved:
-
-.. code-block:: console
-
- ./x86_64-native-linuxapp-gcc/app/testpmd -c 300 -n 4 -- -i --burst=32 --rxfreet=32 --mbcache=250 --txpt=32 --rxht=8 --rxwt=0 --txfreet=32 --txrst=32 --txqflags=0xf01 --disable-hw-vlan
-
l3fwd
~~~~~
the advanced context descriptor should be set and set it. And DPDK has to ask
the info about the header length from the upper layer, because parsing the
packet itself is not acceptable. So, it's too expensive to support MDD.
-When using kernel PF + DPDK VF on x550, please make sure using the kernel
-driver that disables MDD or can disable MDD. (Some kernel driver can use
-this CLI 'insmod ixgbe.ko MDD=0,0' to disable MDD. Some kernel driver disables
-it by default.)
+When using kernel PF + DPDK VF on x550, please make sure to use a kernel
+PF driver that disables MDD or can disable MDD.
+
+Some kernel drivers already disable MDD by default while some kernels can use
+the command ``insmod ixgbe.ko MDD=0,0`` to disable MDD. Each "0" in the
+command refers to a port. For example, if there are 6 ixgbe ports, the command
+should be changed to ``insmod ixgbe.ko MDD=0,0,0,0,0,0``.
Statistics
In order to ensure valid results, it is recommended to poll every 4 minutes.
+MTU setting
+~~~~~~~~~~~
+
+Although the user can set the MTU separately on PF and VF ports, the ixgbe NIC
+only supports one global MTU per physical port.
+So when the user sets different MTUs on PF and VF ports in one physical port,
+the real MTU for all these PF and VF ports is the largest value set.
+This behavior is based on the kernel driver behavior.
+
Supported Chipsets and NICs
---------------------------