eventdev: introduce event vector Tx capability

[dpdk.git] / doc / guides / nics / sfc_efx.rst

diff --git a/doc/guides/nics/sfc_efx.rst b/doc/guides/nics/sfc_efx.rst
index f1489be..cf1269c 100644 (file)
--- a/doc/guides/nics/sfc_efx.rst
+++ b/doc/guides/nics/sfc_efx.rst
@@ -1,5 +1,5 @@
 ..  SPDX-License-Identifier: BSD-3-Clause
-    Copyright(c) 2019-2020 Xilinx, Inc.
+    Copyright(c) 2019-2021 Xilinx, Inc.
     Copyright(c) 2016-2019 Solarflare Communications Inc.
 
     This software was jointly developed between OKTET Labs (under contract
@@ -190,6 +190,8 @@ Supported actions (***non-transfer*** rules):
 
 Supported pattern items (***transfer*** rules):
 
+- PORT_ID (cannot repeat; conflicts with other traffic source items)
+
 - PHY_PORT (cannot repeat; conflicts with other traffic source items)
 
 - PF (cannot repeat; conflicts with other traffic source items)
@@ -198,6 +200,24 @@ Supported pattern items (***transfer*** rules):
 
 - ETH
 
+- VLAN (double-tagging is supported)
+
+- IPV4 (source/destination addresses, IP transport protocol,
+  type of service, time to live)
+
+- IPV6 (source/destination addresses, IP transport protocol,
+  traffic class, hop limit)
+
+- TCP (source/destination ports, TCP header length + TCP flags)
+
+- UDP (source/destination ports)
+
+- VXLAN (exact match of VXLAN network identifier)
+
+- GENEVE (exact match of virtual network identifier)
+
+- NVGRE (exact match of virtual subnet ID)
+
 Supported actions (***transfer*** rules):
 
 - OF_POP_VLAN
@@ -214,10 +234,20 @@ Supported actions (***transfer*** rules):
 
 - PHY_PORT
 
+- PF
+
+- VF
+
+- PORT_ID
+
+- DROP
+
 Validating flow rules depends on the firmware variant.
 
 The :ref:`flow_isolated_mode` is supported.
 
+The implementation is natively thread-safe.
+
 Ethernet destination individual/group match
 ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
 
@@ -322,11 +352,19 @@ Per-Device Parameters
 ~~~~~~~~~~~~~~~~~~~~~
 
 The following per-device parameters can be passed via EAL PCI device
-whitelist option like "-w 02:00.0,arg1=value1,...".
+allow option like "-a 02:00.0,arg1=value1,...".
 
 Case-insensitive 1/y/yes/on or 0/n/no/off may be used to specify
 boolean parameters value.
 
+- ``class`` [net|vdpa] (default **net**)
+
+  Choose the mode of operation of ef100 device.
+  **net** device will work as network device and will be probed by net/sfc driver.
+  **vdpa** device will work as vdpa device and will be probed by vdpa/sfc driver.
+  If this parameter is not specified then ef100 device will operate as
+  network device.
+
 - ``rx_datapath`` [auto|efx|ef10|ef10_essb] (default **auto**)
 
   Choose receive datapath implementation.