.. code-block:: console
- ./build/l2fwd-cat -c 2 -n 4 -- --l3ca="0x3@(0-2)"
+ ./build/l2fwd-cat -l 1 -n 4 -- --l3ca="0x3@(0-2)"
or to enable CAT and CDP on cpus 1,3:
.. code-block:: console
- ./build/l2fwd-cat -c 2 -n 4 -- --l3ca="(0x00C00,0x00300)@(1,3)"
+ ./build/l2fwd-cat -l 1 -n 4 -- --l3ca="(0x00C00,0x00300)@(1,3)"
If CDP is not supported it will fail with following error message:
``pqos_cap_get(...)`` and ``pqos_cap_get_type(..., PQOS_CAP_TYPE_L3CA, ...)``
calls. When all capability and topology information is collected, the requested
CAT configuration is validated. A check is then performed (on per socket basis)
-for a sufficient number of unassociated COS. COS are selected and
+for a sufficient number of un-associated COS. COS are selected and
configured via the ``pqos_l3ca_set(...)`` call. Finally, COS are associated to
relevant CPUs via ``pqos_l3ca_assoc_set(...)`` calls.
``atexit(...)`` is used to register ``cat_exit(...)`` to be called on
a clean exit. ``cat_exit(...)`` performs a simple CAT clean-up, by associating
-COS 0 to all involved CPUs via ``pqos_l3ca_assoc_set(...)`` calls.
\ No newline at end of file
+COS 0 to all involved CPUs via ``pqos_l3ca_assoc_set(...)`` calls.