bus/pci: support IOVA as VA in PowerVM LPARs

[dpdk.git] / doc / guides / testpmd_app_ug / run_app.rst

diff --git a/doc/guides/testpmd_app_ug/run_app.rst b/doc/guides/testpmd_app_ug/run_app.rst
index 6745072..eb48318 100644 (file)
--- a/doc/guides/testpmd_app_ug/run_app.rst
+++ b/doc/guides/testpmd_app_ug/run_app.rst
@@ -356,14 +356,6 @@ The command line options are:
     Set the transmit RS bit threshold of TX rings to N, where 0 <= N <= value of ``--txd``.
     The default value is 0.
 
-*   ``--rx-queue-stats-mapping=(port,queue,mapping)[,(port,queue,mapping)]``
-
-    Set the RX queues statistics counters mapping 0 <= mapping <= 15.
-
-*   ``--tx-queue-stats-mapping=(port,queue,mapping)[,(port,queue,mapping)]``
-
-    Set the TX queues statistics counters mapping 0 <= mapping <= 15.
-
 *   ``--no-flush-rx``
 
     Don't flush the RX streams before starting forwarding. Used mainly with the PCAP PMD.
@@ -392,6 +384,21 @@ The command line options are:
 
     Generate multiple flows in txonly mode.
 
+*   ``--eth-link-speed``
+
+    Set a forced link speed to the ethernet port::
+
+       10 - 10Mbps (not supported)
+       100 - 100Mbps (not supported)
+       1000 - 1Gbps
+       10000 - 10Gbps
+       25000 - 25Gbps
+       40000 - 40Gbps
+       50000 - 50Gbps
+       100000 - 100Gbps
+       200000 - 200Gbps
+       ...
+
 *   ``--disable-link-check``
 
     Disable check on link status when starting/stopping ports.
@@ -531,8 +538,10 @@ The command line options are:
 
 *   ``--hairpin-mode=0xXX``
 
-    Set the hairpin port mode with bitmask, only valid when hairpin queues number is set.
-    bit 4 - explicit Tx flow rule
-    bit 1 - two hairpin ports paired
-    bit 0 - two hairpin ports loop
+    Set the hairpin port mode with bitmask, only valid when hairpin queues number is set::
+
+       bit 4 - explicit Tx flow rule
+       bit 1 - two hairpin ports paired
+       bit 0 - two hairpin ports loop
+
     The default value is 0. Hairpin will use single port mode and implicit Tx flow mode.