XX:XX:XX:XX:XX:02
...
-
* ``--eth-peer=N,XX:XX:XX:XX:XX:XX``
Set the MAC address ``XX:XX:XX:XX:XX:XX`` of the peer port N,
where 0 <= N < ``CONFIG_RTE_MAX_ETHPORTS`` from the configuration file.
+* ``--tx-ip=SRC,DST``
+
+ Set the source and destination IP address used when doing transmit only test.
+ The defaults address values are source 192.18.0.1 and
+ destination 192.18.0.2. These are special purpose addresses
+ reserved for benchmarking (RFC 2544).
+
+* ``--tx-udp=SRC[,DST]``
+
+ Set the source and destination UDP port number for transmit test only test.
+ The default port is the port 9 which is defined for the discard protocol
+ (RFC 863).
+
* ``--pkt-filter-mode=mode``
Set Flow Director mode where mode is either ``none`` (the default), ``signature`` or ``perfect``.
Enable hardware VLAN extend.
+* ``--enable-hw-qinq-strip``
+
+ Enable hardware QINQ strip.
+
* ``--enable-drop-en``
Enable per-queue packet drop for packets with no descriptors.
Disable check on link status when starting/stopping ports.
+* ``--disable-device-start``
+
+ Do not automatically start all ports. This allows testing
+ configuration of rx and tx queues before device is started
+ for the first time.
+
* ``--no-lsc-interrupt``
Disable LSC interrupts for all ports, even those supporting it.
Set the hexadecimal bitmask of TX queue offloads.
The default value is 0.
+* ``--rx-offloads=0xXXXXXXXX``
+
+ Set the hexadecimal bitmask of RX queue offloads.
+ The default value is 0.
+
* ``--hot-plug``
- Enable device event monitor mechanism for hot plug.
+ Enable device event monitor mechanism for hotplug.
* ``--vxlan-gpe-port=N``
* ``--noisy-lkup-memory=N``
- Set the size of the noisy neighbour simulation memory buffer in MB to N.
+ Set the size of the noisy neighbor simulation memory buffer in MB to N.
Only available with the noisy forwarding mode. The default value is 0.
* ``--noisy-lkup-num-reads=N``
- Set the number of reads to be done in noisy neighbour simulation memory buffer to N.
+ Set the number of reads to be done in noisy neighbor simulation memory buffer to N.
Only available with the noisy forwarding mode. The default value is 0.
* ``--noisy-lkup-num-writes=N``
- Set the number of writes to be done in noisy neighbour simulation memory buffer to N.
+ Set the number of writes to be done in noisy neighbor simulation memory buffer to N.
Only available with the noisy forwarding mode. The default value is 0.
* ``--noisy-lkup-num-reads-writes=N``
- Set the number of r/w accesses to be done in noisy neighbour simulation memory buffer to N.
+ Set the number of r/w accesses to be done in noisy neighbor simulation memory buffer to N.
Only available with the noisy forwarding mode. The default value is 0.
* ``--no-iova-contig``