unify tools naming

[dpdk.git] / doc / guides / testpmd_app_ug / testpmd_funcs.rst

diff --git a/doc/guides/testpmd_app_ug/testpmd_funcs.rst b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
index d812989..f87e0c2 100644 (file)
--- a/doc/guides/testpmd_app_ug/testpmd_funcs.rst
+++ b/doc/guides/testpmd_app_ug/testpmd_funcs.rst
@@ -98,9 +98,11 @@ Start packet forwarding with current configuration::
 start tx_first
 ~~~~~~~~~~~~~~
 
-Start packet forwarding with current configuration after sending one burst of packets::
+Start packet forwarding with current configuration after sending specified number of bursts of packets::
 
-   testpmd> start tx_first
+   testpmd> start tx_first (""|burst_num)
+
+The default burst number is 1 when ``burst_num`` not presented.
 
 stop
 ~~~~
@@ -177,6 +179,10 @@ For example:
      ipv6-sctp
      ipv6-other
      l2_payload
+     port
+     vxlan
+     geneve
+     nvgre
 
 show port rss reta
 ~~~~~~~~~~~~~~~~~~
@@ -993,7 +999,7 @@ For example, to move a pci device using ixgbe under DPDK management:
 .. code-block:: console
 
    # Check the status of the available devices.
-   ./tools/dpdk_nic_bind.py --status
+   ./tools/dpdk-devbind.py --status
 
    Network devices using DPDK-compatible driver
    ============================================
@@ -1005,11 +1011,11 @@ For example, to move a pci device using ixgbe under DPDK management:
 
 
    # Bind the device to igb_uio.
-   sudo ./tools/dpdk_nic_bind.py -b igb_uio 0000:0a:00.0
+   sudo ./tools/dpdk-devbind.py -b igb_uio 0000:0a:00.0
 
 
    # Recheck the status of the devices.
-   ./tools/dpdk_nic_bind.py --status
+   ./tools/dpdk-devbind.py --status
    Network devices using DPDK-compatible driver
    ============================================
    0000:0a:00.0 '82599ES 10-Gigabit' drv=igb_uio unused=
@@ -1112,9 +1118,9 @@ For example, to move a pci device under kernel management:
 
 .. code-block:: console
 
-   sudo ./tools/dpdk_nic_bind.py -b ixgbe 0000:0a:00.0
+   sudo ./tools/dpdk-devbind.py -b ixgbe 0000:0a:00.0
 
-   ./tools/dpdk_nic_bind.py --status
+   ./tools/dpdk-devbind.py --status
 
    Network devices using DPDK-compatible driver
    ============================================
@@ -1284,7 +1290,7 @@ port config - RSS
 
 Set the RSS (Receive Side Scaling) mode on or off::
 
-   testpmd> port config all rss (all|ip|tcp|udp|sctp|ether|none)
+   testpmd> port config all rss (all|ip|tcp|udp|sctp|ether|port|vxlan|geneve|nvgre|none)
 
 RSS is on by default.