#include <rte_bus_vdev.h>
#include <rte_alarm.h>
#include <rte_cycles.h>
+#include <rte_string_fns.h>
#include "rte_eth_bond.h"
#include "rte_eth_bond_private.h"
uint16_t offset = get_vlan_offset(eth_h, ðer_type);
#ifdef RTE_LIBRTE_BOND_DEBUG_ALB
- snprintf(buf, 16, "%s", info);
+ strlcpy(buf, info, 16);
#endif
if (ether_type == rte_cpu_to_be_16(ETHER_TYPE_IPv4)) {
hash = ether_hash(eth_hdr);
- slaves[i++] = (hash ^= hash >> 8) % slave_count;
+ slaves[i] = (hash ^= hash >> 8) % slave_count;
}
}
hash ^= hash >> 16;
hash ^= hash >> 8;
- slaves[i++] = hash % slave_count;
+ slaves[i] = hash % slave_count;
}
}
hash ^= hash >> 16;
hash ^= hash >> 8;
- slaves[i++] = hash % slave_count;
+ slaves[i] = hash % slave_count;
}
}
/* Number of mbufs for transmission on each slave */
uint16_t slave_nb_bufs[RTE_MAX_ETHPORTS] = { 0 };
/* Mapping array generated by hash function to map mbufs to slaves */
- uint16_t bufs_slave_port_idxs[RTE_MAX_ETHPORTS] = { 0 };
+ uint16_t bufs_slave_port_idxs[nb_bufs];
uint16_t slave_tx_count, slave_tx_fail_count[RTE_MAX_ETHPORTS] = { 0 };
uint16_t total_tx_count = 0, total_tx_fail_count = 0;
if (likely(rte_ring_empty(port->tx_ring)))
continue;
- rte_ring_dequeue(port->tx_ring, (void **)&ctrl_pkt);
-
- slave_tx_count = rte_eth_tx_burst(slave_port_ids[i],
+ if (rte_ring_dequeue(port->tx_ring,
+ (void **)&ctrl_pkt) != -ENOENT) {
+ slave_tx_count = rte_eth_tx_burst(slave_port_ids[i],
bd_tx_q->queue_id, &ctrl_pkt, 1);
-
- /*
- * re-enqueue LAG control plane packets to buffering
- * ring if transmission fails so the packet isn't lost.
- */
- if (slave_tx_count != 1)
- rte_ring_enqueue(port->tx_ring, ctrl_pkt);
+ /*
+ * re-enqueue LAG control plane packets to buffering
+ * ring if transmission fails so the packet isn't lost.
+ */
+ if (slave_tx_count != 1)
+ rte_ring_enqueue(port->tx_ring, ctrl_pkt);
+ }
}
return total_tx_count;
bonded_eth_dev->data->dev_conf.rxmode.mq_mode;
}
- slave_eth_dev->data->dev_conf.rxmode.hw_vlan_filter =
- bonded_eth_dev->data->dev_conf.rxmode.hw_vlan_filter;
+ if (bonded_eth_dev->data->dev_conf.rxmode.offloads &
+ DEV_RX_OFFLOAD_VLAN_FILTER)
+ slave_eth_dev->data->dev_conf.rxmode.offloads |=
+ DEV_RX_OFFLOAD_VLAN_FILTER;
+ else
+ slave_eth_dev->data->dev_conf.rxmode.offloads &=
+ ~DEV_RX_OFFLOAD_VLAN_FILTER;
nb_rx_queues = bonded_eth_dev->data->nb_rx_queues;
nb_tx_queues = bonded_eth_dev->data->nb_tx_queues;
}
}
+ errval = rte_eth_dev_set_mtu(slave_eth_dev->data->port_id,
+ bonded_eth_dev->data->mtu);
+ if (errval != 0 && errval != -ENOTSUP) {
+ RTE_BOND_LOG(ERR, "rte_eth_dev_set_mtu: port %u, err (%d)",
+ slave_eth_dev->data->port_id, errval);
+ return errval;
+ }
+
/* Configure device */
errval = rte_eth_dev_configure(slave_eth_dev->data->port_id,
nb_rx_queues, nb_tx_queues,
if (internals->slave_count == 0) {
RTE_BOND_LOG(ERR, "Cannot start port since there are no slave devices");
- return -1;
+ goto out_err;
}
if (internals->user_defined_mac == 0) {
new_mac_addr = &internals->slaves[i].persisted_mac_addr;
if (new_mac_addr == NULL)
- return -1;
+ goto out_err;
if (mac_address_set(eth_dev, new_mac_addr) != 0) {
RTE_BOND_LOG(ERR, "bonded port (%d) failed to update MAC address",
eth_dev->data->port_id);
- return -1;
+ goto out_err;
}
}
/* Update all slave devices MACs*/
if (mac_address_slaves_update(eth_dev) != 0)
- return -1;
+ goto out_err;
/* If bonded device is configure in promiscuous mode then re-apply config */
if (internals->promiscuous_en)
"bonded port (%d) failed to reconfigure slave device (%d)",
eth_dev->data->port_id,
internals->slaves[i].port_id);
- return -1;
+ goto out_err;
}
/* We will need to poll for link status if any slave doesn't
* support interrupts
if (internals->slaves[i].link_status_poll_enabled)
internals->link_status_polling_enabled = 1;
}
+
/* start polling if needed */
if (internals->link_status_polling_enabled) {
rte_eal_alarm_set(
bond_tlb_enable(internals);
return 0;
+
+out_err:
+ eth_dev->data->dev_started = 0;
+ return -1;
}
static void
dev_info->rx_offload_capa = internals->rx_offload_capa;
dev_info->tx_offload_capa = internals->tx_offload_capa;
+ dev_info->rx_queue_offload_capa = internals->rx_queue_offload_capa;
+ dev_info->tx_queue_offload_capa = internals->tx_queue_offload_capa;
dev_info->flow_type_rss_offloads = internals->flow_type_rss_offloads;
dev_info->reta_size = internals->reta_size;
return 0;
}
+static int
+bond_ethdev_mac_address_set(struct rte_eth_dev *dev, struct ether_addr *addr)
+{
+ if (mac_address_set(dev, addr)) {
+ RTE_BOND_LOG(ERR, "Failed to update MAC address");
+ return -EINVAL;
+ }
+
+ return 0;
+}
+
const struct eth_dev_ops default_dev_ops = {
.dev_start = bond_ethdev_start,
.dev_stop = bond_ethdev_stop,
.reta_query = bond_ethdev_rss_reta_query,
.rss_hash_update = bond_ethdev_rss_hash_update,
.rss_hash_conf_get = bond_ethdev_rss_hash_conf_get,
- .mtu_set = bond_ethdev_mtu_set
+ .mtu_set = bond_ethdev_mtu_set,
+ .mac_addr_set = bond_ethdev_mac_address_set
};
static int
internals->active_slave_count = 0;
internals->rx_offload_capa = 0;
internals->tx_offload_capa = 0;
+ internals->rx_queue_offload_capa = 0;
+ internals->tx_queue_offload_capa = 0;
internals->candidate_max_rx_pktlen = 0;
internals->max_rx_pktlen = 0;
/* Set mode 4 default configuration */
bond_mode_8023ad_setup(eth_dev, NULL);
if (bond_ethdev_mode_set(eth_dev, mode)) {
- RTE_BOND_LOG(ERR, "Failed to set bonded device %d mode too %d",
+ RTE_BOND_LOG(ERR, "Failed to set bonded device %d mode to %d\n",
eth_dev->data->port_id, mode);
goto err;
}
uint8_t bonding_mode, socket_id/*, agg_mode*/;
int arg_count, port_id;
uint8_t agg_mode;
+ struct rte_eth_dev *eth_dev;
if (!dev)
return -EINVAL;
name = rte_vdev_device_name(dev);
RTE_LOG(INFO, EAL, "Initializing pmd_bond for %s\n", name);
+ if (rte_eal_process_type() == RTE_PROC_SECONDARY &&
+ strlen(rte_vdev_device_args(dev)) == 0) {
+ eth_dev = rte_eth_dev_attach_secondary(name);
+ if (!eth_dev) {
+ RTE_LOG(ERR, PMD, "Failed to probe %s\n", name);
+ return -1;
+ }
+ /* TODO: request info from primary to set up Rx and Tx */
+ eth_dev->dev_ops = &default_dev_ops;
+ return 0;
+ }
+
kvlist = rte_kvargs_parse(rte_vdev_device_args(dev),
pmd_bond_init_valid_arguments);
if (kvlist == NULL)
eth_dev->tx_pkt_burst = NULL;
internals = eth_dev->data->dev_private;
+ /* Try to release mempool used in mode6. If the bond
+ * device is not mode6, free the NULL is not problem.
+ */
+ rte_mempool_free(internals->mode6.mempool);
rte_bitmap_free(internals->vlan_filter_bmp);
rte_free(internals->vlan_filter_bmpmem);
rte_free(eth_dev->data->dev_private);