fix PMD wording

[dpdk.git] / drivers / net / hns3 / hns3_ethdev.c

diff --git a/drivers/net/hns3/hns3_ethdev.c b/drivers/net/hns3/hns3_ethdev.c
index 847e660..0bd1290 100644 (file)
--- a/drivers/net/hns3/hns3_ethdev.c
+++ b/drivers/net/hns3/hns3_ethdev.c
@@ -1060,7 +1060,7 @@ hns3_vlan_pvid_set(struct rte_eth_dev *dev, uint16_t pvid, int on)
                return ret;
        /*
         * Only in HNS3_SW_SHIFT_AND_MODE the PVID related operation in Tx/Rx
-        * need be processed by PMD driver.
+        * need be processed by PMD.
         */
        if (pvid_en_state_change &&
            hw->vlan_mode == HNS3_SW_SHIFT_AND_DISCARD_MODE)
@@ -2592,7 +2592,7 @@ hns3_parse_cfg(struct hns3_cfg *cfg, struct hns3_cmd_desc *desc)
         * Field ext_rss_size_max obtained from firmware will be more flexible
         * for future changes and expansions, which is an exponent of 2, instead
         * of reading out directly. If this field is not zero, hns3 PF PMD
-        * driver uses it as rss_size_max under one TC. Device, whose revision
+        * uses it as rss_size_max under one TC. Device, whose revision
         * id is greater than or equal to PCI_REVISION_ID_HIP09_A, obtains the
         * maximum number of queues supported under a TC through this field.
         */
@@ -6311,7 +6311,7 @@ hns3_fec_set(struct rte_eth_dev *dev, uint32_t mode)
        if (ret < 0)
                return ret;
 
-       /* HNS3 PMD driver only support one bit set mode, e.g. 0x1, 0x4 */
+       /* HNS3 PMD only support one bit set mode, e.g. 0x1, 0x4 */
        if (!is_fec_mode_one_bit_set(mode)) {
                hns3_err(hw, "FEC mode(0x%x) not supported in HNS3 PMD, "
                             "FEC mode should be only one bit set", mode);