#ifndef _HNS3_ETHDEV_H_
#define _HNS3_ETHDEV_H_
+#include <pthread.h>
#include <sys/time.h>
#include <ethdev_driver.h>
#include <rte_byteorder.h>
#define HNS3_PF_FUNC_ID 0
#define HNS3_1ST_VF_FUNC_ID 1
+#define HNS3_DEFAULT_PORT_CONF_BURST_SIZE 32
+#define HNS3_DEFAULT_PORT_CONF_QUEUES_NUM 1
+
#define HNS3_SW_SHIFT_AND_DISCARD_MODE 0
#define HNS3_HW_SHIFT_AND_DISCARD_MODE 1
};
struct hns3_cfg {
- uint8_t vmdq_vport_num;
uint8_t tc_num;
uint16_t tqp_desc_num;
uint16_t rx_buf_len;
struct hns3_mac {
uint8_t mac_addr[RTE_ETHER_ADDR_LEN];
- bool default_addr_setted; /* whether default addr(mac_addr) is set */
uint8_t media_type;
uint8_t phy_addr;
- uint8_t link_duplex : 1; /* ETH_LINK_[HALF/FULL]_DUPLEX */
- uint8_t link_autoneg : 1; /* ETH_LINK_[AUTONEG/FIXED] */
- uint8_t link_status : 1; /* ETH_LINK_[DOWN/UP] */
- uint32_t link_speed; /* ETH_SPEED_NUM_ */
+ uint8_t link_duplex : 1; /* RTE_ETH_LINK_[HALF/FULL]_DUPLEX */
+ uint8_t link_autoneg : 1; /* RTE_ETH_LINK_[AUTONEG/FIXED] */
+ uint8_t link_status : 1; /* RTE_ETH_LINK_[DOWN/UP] */
+ uint32_t link_speed; /* RTE_ETH_SPEED_NUM_ */
/*
* Some firmware versions support only the SFP speed query. In addition
* to the SFP speed query, some firmware supports the query of the speed
struct hns3_cmq cmq;
struct hns3_mbx_resp_status mbx_resp; /* mailbox response */
struct hns3_mac mac;
+ /*
+ * This flag indicates dev_set_link_down() API is called, and is cleared
+ * by dev_set_link_up() or dev_start().
+ */
+ bool set_link_down;
unsigned int secondary_cnt; /* Number of secondary processes init'd. */
struct hns3_tqp_stats tqp_stats;
/* Include Mac stats | Rx stats | Tx stats */
struct hns3_rx_missed_stats imissed_stats;
uint64_t oerror_stats;
uint32_t fw_version;
+ uint16_t pf_vf_if_version; /* version of communication interface */
uint16_t num_msi;
uint16_t total_tqps_num; /* total task queue pairs of this PF */
* - HNS3_SPECIAL_PORT_SW_CKSUM_MODE
* In this mode, HW can not do checksum for special UDP port like
* 4789, 4790, 6081 for non-tunnel UDP packets and UDP tunnel
- * packets without the PKT_TX_TUNEL_MASK in the mbuf. So, PMD need
+ * packets without the RTE_MBUF_F_TX_TUNEL_MASK in the mbuf. So, PMD need
* do the checksum for these packets to avoid a checksum error.
*
* - HNS3_SPECIAL_PORT_HW_CKSUM_MODE
uint8_t udp_cksum_mode;
struct hns3_port_base_vlan_config port_base_vlan_cfg;
+
+ pthread_mutex_t flows_lock; /* rte_flow ops lock */
+ struct hns3_fdir_rule_list flow_fdir_list; /* flow fdir rule list */
+ struct hns3_rss_filter_list flow_rss_list; /* flow RSS rule list */
+ struct hns3_flow_mem_list flow_list;
+
/*
* PMD setup and configuration is not thread safe. Since it is not
* performance sensitive, it is better to guarantee thread-safety
enum hns3_mp_req_type {
HNS3_MP_REQ_START_RXTX = 1,
HNS3_MP_REQ_STOP_RXTX,
+ HNS3_MP_REQ_START_TX,
+ HNS3_MP_REQ_STOP_TX,
HNS3_MP_REQ_MAX
};
* descriptor, it functions only when firmware report the capability of
* HNS3_CAPS_RXD_ADV_LAYOUT_B and driver enabled it.
*/
- uint32_t ptype[HNS3_PTYPE_NUM] __rte_cache_min_aligned;
+ uint32_t ptype[HNS3_PTYPE_NUM] __rte_cache_aligned;
};
#define HNS3_FIXED_MAX_TQP_NUM_MODE 0
uint8_t prio_tc[HNS3_MAX_USER_PRIO]; /* TC indexed by prio */
uint16_t pause_time;
bool support_fc_autoneg; /* support FC autonegotiate */
+ bool support_multi_tc_pause;
uint16_t wanted_umv_size;
uint16_t max_umv_size;
uint32_t tx_func_hint;
uint64_t dev_caps_mask;
+ uint16_t mbx_time_limit_ms; /* wait time for mbx message */
- struct hns3_ptype_table ptype_tbl __rte_cache_min_aligned;
+ struct hns3_ptype_table ptype_tbl __rte_cache_aligned;
};
enum {
#define HNS3_DEVARG_DEV_CAPS_MASK "dev_caps_mask"
-#define HNS3_DEV_SUPPORT_DCB_B 0x0
-#define HNS3_DEV_SUPPORT_COPPER_B 0x1
-#define HNS3_DEV_SUPPORT_UDP_GSO_B 0x2
-#define HNS3_DEV_SUPPORT_FD_QUEUE_REGION_B 0x3
-#define HNS3_DEV_SUPPORT_PTP_B 0x4
-#define HNS3_DEV_SUPPORT_TX_PUSH_B 0x5
-#define HNS3_DEV_SUPPORT_INDEP_TXRX_B 0x6
-#define HNS3_DEV_SUPPORT_STASH_B 0x7
-#define HNS3_DEV_SUPPORT_RXD_ADV_LAYOUT_B 0x9
-#define HNS3_DEV_SUPPORT_OUTER_UDP_CKSUM_B 0xA
-#define HNS3_DEV_SUPPORT_RAS_IMP_B 0xB
-
-#define hns3_dev_dcb_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_DCB_B)
-
-/* Support copper media type */
-#define hns3_dev_copper_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_COPPER_B)
-
-/* Support UDP GSO offload */
-#define hns3_dev_udp_gso_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_UDP_GSO_B)
-
-/* Support the queue region action rule of flow directory */
-#define hns3_dev_fd_queue_region_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_FD_QUEUE_REGION_B)
-
-/* Support PTP timestamp offload */
-#define hns3_dev_ptp_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_PTP_B)
-
-#define hns3_dev_tx_push_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_TX_PUSH_B)
+#define HNS3_DEVARG_MBX_TIME_LIMIT_MS "mbx_time_limit_ms"
-/* Support to Independently enable/disable/reset Tx or Rx queues */
-#define hns3_dev_indep_txrx_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_INDEP_TXRX_B)
-
-#define hns3_dev_stash_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_STASH_B)
-
-#define hns3_dev_rxd_adv_layout_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_RXD_ADV_LAYOUT_B)
-
-#define hns3_dev_outer_udp_cksum_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_OUTER_UDP_CKSUM_B)
+enum {
+ HNS3_DEV_SUPPORT_DCB_B,
+ HNS3_DEV_SUPPORT_COPPER_B,
+ HNS3_DEV_SUPPORT_FD_QUEUE_REGION_B,
+ HNS3_DEV_SUPPORT_PTP_B,
+ HNS3_DEV_SUPPORT_TX_PUSH_B,
+ HNS3_DEV_SUPPORT_INDEP_TXRX_B,
+ HNS3_DEV_SUPPORT_STASH_B,
+ HNS3_DEV_SUPPORT_RXD_ADV_LAYOUT_B,
+ HNS3_DEV_SUPPORT_OUTER_UDP_CKSUM_B,
+ HNS3_DEV_SUPPORT_RAS_IMP_B,
+ HNS3_DEV_SUPPORT_TM_B,
+ HNS3_DEV_SUPPORT_VF_VLAN_FLT_MOD_B,
+};
-#define hns3_dev_ras_imp_supported(hw) \
- hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_RAS_IMP_B)
+#define hns3_dev_get_support(hw, _name) \
+ hns3_get_bit((hw)->capability, HNS3_DEV_SUPPORT_##_name##_B)
#define HNS3_DEV_PRIVATE_TO_HW(adapter) \
(&((struct hns3_adapter *)adapter)->hw)
}
/*
- * The optimized function for writing registers used in the '.rx_pkt_burst' and
- * '.tx_pkt_burst' ops implementation function.
+ * The optimized function for writing registers reduces one address addition
+ * calculation, it was used in the '.rx_pkt_burst' and '.tx_pkt_burst' ops
+ * implementation function.
*/
static inline void hns3_write_reg_opt(volatile void *addr, uint32_t value)
{
- rte_io_wmb();
- rte_write32_relaxed(rte_cpu_to_le_32(value), addr);
+ rte_write32(rte_cpu_to_le_32(value), addr);
}
static inline uint32_t hns3_read_reg(void *base, uint32_t reg)
#define hns3_read_dev(a, reg) \
hns3_read_reg((a)->io_base, (reg))
-#define ARRAY_SIZE(x) RTE_DIM(x)
-
#define NEXT_ITEM_OF_ACTION(act, actions, index) \
do { \
act = (actions) + (index); \
#define MSEC_PER_SEC 1000L
#define USEC_PER_MSEC 1000L
-static inline uint64_t
-get_timeofday_ms(void)
-{
- struct timeval tv;
-
- (void)gettimeofday(&tv, NULL);
-
- return (uint64_t)tv.tv_sec * MSEC_PER_SEC + tv.tv_usec / USEC_PER_MSEC;
-}
+void hns3_clock_gettime(struct timeval *tv);
+uint64_t hns3_clock_calctime_ms(struct timeval *tv);
+uint64_t hns3_clock_gettime_ms(void);
static inline uint64_t
hns3_atomic_test_bit(unsigned int nr, volatile uint64_t *addr)
hns3_txvlan_cap_get(struct hns3_hw *hw)
{
if (hw->port_base_vlan_cfg.state)
- return DEV_TX_OFFLOAD_VLAN_INSERT;
+ return RTE_ETH_TX_OFFLOAD_VLAN_INSERT;
else
- return DEV_TX_OFFLOAD_VLAN_INSERT | DEV_TX_OFFLOAD_QINQ_INSERT;
+ return RTE_ETH_TX_OFFLOAD_VLAN_INSERT | RTE_ETH_TX_OFFLOAD_QINQ_INSERT;
}
#endif /* _HNS3_ETHDEV_H_ */
git.droids-corp.org / dpdk.git / blobdiff