common/mlx5: add Direct Verbs constants for Windows

[dpdk.git] / drivers / net / hns3 / hns3_ethdev.h

diff --git a/drivers/net/hns3/hns3_ethdev.h b/drivers/net/hns3/hns3_ethdev.h
index fa08fad..f3cc88f 100644 (file)
--- a/drivers/net/hns3/hns3_ethdev.h
+++ b/drivers/net/hns3/hns3_ethdev.h
@@ -190,10 +190,10 @@ struct hns3_mac {
        uint8_t mac_addr[RTE_ETHER_ADDR_LEN];
        uint8_t media_type;
        uint8_t phy_addr;
-       uint8_t link_duplex  : 1; /* ETH_LINK_[HALF/FULL]_DUPLEX */
-       uint8_t link_autoneg : 1; /* ETH_LINK_[AUTONEG/FIXED] */
-       uint8_t link_status  : 1; /* ETH_LINK_[DOWN/UP] */
-       uint32_t link_speed;      /* ETH_SPEED_NUM_ */
+       uint8_t link_duplex  : 1; /* RTE_ETH_LINK_[HALF/FULL]_DUPLEX */
+       uint8_t link_autoneg : 1; /* RTE_ETH_LINK_[AUTONEG/FIXED] */
+       uint8_t link_status  : 1; /* RTE_ETH_LINK_[DOWN/UP] */
+       uint32_t link_speed;      /* RTE_ETH_SPEED_NUM_ */
        /*
         * Some firmware versions support only the SFP speed query. In addition
         * to the SFP speed query, some firmware supports the query of the speed
@@ -428,6 +428,17 @@ struct hns3_reset_data {
        struct hns3_wait_data *wait_data;
 };
 
+struct hns3_hw_ops {
+       int (*add_mc_mac_addr)(struct hns3_hw *hw,
+                               struct rte_ether_addr *mac_addr);
+       int (*del_mc_mac_addr)(struct hns3_hw *hw,
+                               struct rte_ether_addr *mac_addr);
+       int (*add_uc_mac_addr)(struct hns3_hw *hw,
+                               struct rte_ether_addr *mac_addr);
+       int (*del_uc_mac_addr)(struct hns3_hw *hw,
+                               struct rte_ether_addr *mac_addr);
+};
+
 #define HNS3_INTR_MAPPING_VEC_RSV_ONE          0
 #define HNS3_INTR_MAPPING_VEC_ALL              1
 
@@ -622,7 +633,7 @@ struct hns3_hw {
         *  - HNS3_SPECIAL_PORT_SW_CKSUM_MODE
         *     In this mode, HW can not do checksum for special UDP port like
         *     4789, 4790, 6081 for non-tunnel UDP packets and UDP tunnel
-        *     packets without the PKT_TX_TUNEL_MASK in the mbuf. So, PMD need
+        *     packets without the RTE_MBUF_F_TX_TUNEL_MASK in the mbuf. So, PMD need
         *     do the checksum for these packets to avoid a checksum error.
         *
         *  - HNS3_SPECIAL_PORT_HW_CKSUM_MODE
@@ -638,6 +649,8 @@ struct hns3_hw {
        struct hns3_rss_filter_list flow_rss_list; /* flow RSS rule list */
        struct hns3_flow_mem_list flow_list;
 
+       struct hns3_hw_ops ops;
+
        /*
         * PMD setup and configuration is not thread safe. Since it is not
         * performance sensitive, it is better to guarantee thread-safety
@@ -1048,6 +1061,14 @@ void hns3vf_update_link_status(struct hns3_hw *hw, uint8_t link_status,
                          uint32_t link_speed, uint8_t link_duplex);
 void hns3_parse_devargs(struct rte_eth_dev *dev);
 void hns3vf_update_push_lsc_cap(struct hns3_hw *hw, bool supported);
+int hns3_configure_all_mc_mac_addr(struct hns3_adapter *hns, bool del);
+int hns3_configure_all_mac_addr(struct hns3_adapter *hns, bool del);
+int hns3_add_mac_addr(struct rte_eth_dev *dev, struct rte_ether_addr *mac_addr,
+               __rte_unused uint32_t idx, __rte_unused uint32_t pool);
+void hns3_remove_mac_addr(struct rte_eth_dev *dev, uint32_t idx);
+int hns3_set_mc_mac_addr_list(struct rte_eth_dev *dev,
+                       struct rte_ether_addr *mc_addr_set,
+                                                       uint32_t nb_mc_addr);
 int hns3_restore_ptp(struct hns3_adapter *hns);
 int hns3_mbuf_dyn_rx_timestamp_register(struct rte_eth_dev *dev,
                                    struct rte_eth_conf *conf);
@@ -1079,9 +1100,9 @@ static inline uint64_t
 hns3_txvlan_cap_get(struct hns3_hw *hw)
 {
        if (hw->port_base_vlan_cfg.state)
-               return DEV_TX_OFFLOAD_VLAN_INSERT;
+               return RTE_ETH_TX_OFFLOAD_VLAN_INSERT;
        else
-               return DEV_TX_OFFLOAD_VLAN_INSERT | DEV_TX_OFFLOAD_QINQ_INSERT;
+               return RTE_ETH_TX_OFFLOAD_VLAN_INSERT | RTE_ETH_TX_OFFLOAD_QINQ_INSERT;
 }
 
 #endif /* _HNS3_ETHDEV_H_ */