#ifndef _HNS3_RXTX_H_
#define _HNS3_RXTX_H_
-#define HNS3_MIN_RING_DESC 32
+#define HNS3_MIN_RING_DESC 64
#define HNS3_MAX_RING_DESC 32768
#define HNS3_DEFAULT_RING_DESC 1024
#define HNS3_ALIGN_RING_DESC 32
bool rx_deferred_start; /* don't start this queue in dev start */
bool configured; /* indicate if rx queue has been configured */
- uint64_t non_vld_descs; /* num of non valid rx descriptors */
uint64_t l2_errors;
uint64_t pkt_len_errors;
uint64_t l3_csum_erros;
bool tx_deferred_start; /* don't start this queue in dev start */
bool configured; /* indicate if tx queue has been configured */
+
+ /*
+ * The following items are used for the abnormal errors statistics in
+ * the Tx datapath. When upper level application calls the
+ * rte_eth_tx_burst API function to send multiple packets at a time with
+ * burst mode based on hns3 network engine, there are some abnormal
+ * conditions that cause the driver to fail to operate the hardware to
+ * send packets correctly.
+ * Note: When using burst mode to call the rte_eth_tx_burst API function
+ * to send multiple packets at a time. When the first abnormal error is
+ * detected, add one to the relevant error statistics item, and then
+ * exit the loop of sending multiple packets of the function. That is to
+ * say, even if there are multiple packets in which abnormal errors may
+ * be detected in the burst, the relevant error statistics in the driver
+ * will only be increased by one.
+ * The detail description of the Tx abnormal errors statistic items as
+ * below:
+ * - over_length_pkt_cnt
+ * Total number of greater than HNS3_MAX_FRAME_LEN the driver
+ * supported.
+ *
+ * - exceed_limit_bd_pkt_cnt
+ * Total number of exceeding the hardware limited bd which process
+ * a packet needed bd numbers.
+ *
+ * - exceed_limit_bd_reassem_fail
+ * Total number of exceeding the hardware limited bd fail which
+ * process a packet needed bd numbers and reassemble fail.
+ *
+ * - unsupported_tunnel_pkt_cnt
+ * Total number of unsupported tunnel packet. The unsupported tunnel
+ * type: vxlan_gpe, gtp, ipip and MPLSINUDP, MPLSINUDP is a packet
+ * with MPLS-in-UDP RFC 7510 header.
+ *
+ * - queue_full_cnt
+ * Total count which the available bd numbers in current bd queue is
+ * less than the bd numbers with the pkt process needed.
+ *
+ * - pkt_padding_fail_cnt
+ * Total count which the packet length is less than minimum packet
+ * size HNS3_MIN_PKT_SIZE and fail to be appended with 0.
+ */
+ uint64_t over_length_pkt_cnt;
+ uint64_t exceed_limit_bd_pkt_cnt;
+ uint64_t exceed_limit_bd_reassem_fail;
+ uint64_t unsupported_tunnel_pkt_cnt;
+ uint64_t queue_full_cnt;
+ uint64_t pkt_padding_fail_cnt;
};
struct hns3_queue_info {
void hns3_dev_tx_queue_release(void *queue);
void hns3_free_all_queues(struct rte_eth_dev *dev);
int hns3_reset_all_queues(struct hns3_adapter *hns);
+void hns3_dev_all_rx_queue_intr_enable(struct hns3_hw *hw, bool en);
int hns3_dev_rx_queue_intr_enable(struct rte_eth_dev *dev, uint16_t queue_id);
int hns3_dev_rx_queue_intr_disable(struct rte_eth_dev *dev, uint16_t queue_id);
+void hns3_enable_all_queues(struct hns3_hw *hw, bool en);
int hns3_start_queues(struct hns3_adapter *hns, bool reset_queue);
int hns3_stop_queues(struct hns3_adapter *hns, bool reset_queue);
void hns3_dev_release_mbufs(struct hns3_adapter *hns);
uint16_t nb_pkts);
const uint32_t *hns3_dev_supported_ptypes_get(struct rte_eth_dev *dev);
void hns3_set_rxtx_function(struct rte_eth_dev *eth_dev);
-void hns3_tqp_intr_enable(struct hns3_hw *hw, uint16_t tpq_int_num, bool en);
+void hns3_set_queue_intr_gl(struct hns3_hw *hw, uint16_t queue_id,
+ uint8_t gl_idx, uint16_t gl_value);
+void hns3_set_queue_intr_rl(struct hns3_hw *hw, uint16_t queue_id,
+ uint16_t rl_value);
int hns3_set_fake_rx_or_tx_queues(struct rte_eth_dev *dev, uint16_t nb_rx_q,
uint16_t nb_tx_q);