net/i40e/base: support switch parameters

[dpdk.git] / drivers / net / i40e / base / i40e_adminq_cmd.h

diff --git a/drivers/net/i40e/base/i40e_adminq_cmd.h b/drivers/net/i40e/base/i40e_adminq_cmd.h
index dd9fb55..c36da2a 100644 (file)
--- a/drivers/net/i40e/base/i40e_adminq_cmd.h
+++ b/drivers/net/i40e/base/i40e_adminq_cmd.h
@@ -787,7 +787,22 @@ struct i40e_aqc_set_switch_config {
 #define I40E_AQ_SET_SWITCH_CFG_L2_FILTER       0x0002
 #define I40E_AQ_SET_SWITCH_CFG_HW_ATR_EVICT    0x0004
        __le16  valid_flags;
-       u8      reserved[12];
+       /* The ethertype in switch_tag is dropped on ingress and used
+        * internally by the switch. Set this to zero for the default
+        * of 0x88a8 (802.1ad). Should be zero for firmware API
+        * versions lower than 1.7.
+        */
+       __le16  switch_tag;
+       /* The ethertypes in first_tag and second_tag are used to
+        * match the outer and inner VLAN tags (respectively) when HW
+        * double VLAN tagging is enabled via the set port parameters
+        * AQ command. Otherwise these are both ignored. Set them to
+        * zero for their defaults of 0x8100 (802.1Q). Should be zero
+        * for firmware API versions lower than 1.7.
+        */
+       __le16  first_tag;
+       __le16  second_tag;
+       u8      reserved[6];
 };
 
 I40E_CHECK_CMD_LENGTH(i40e_aqc_set_switch_config);