void *arg);
static int i40e_dev_get_dcb_info(struct rte_eth_dev *dev,
struct rte_eth_dcb_info *dcb_info);
+static int i40e_dev_sync_phy_type(struct i40e_hw *hw);
static void i40e_configure_registers(struct i40e_hw *hw);
static void i40e_hw_init(struct rte_eth_dev *dev);
static int i40e_config_qinq(struct i40e_hw *hw, struct i40e_vsi *vsi);
return 0;
}
-DRIVER_REGISTER_PCI(net_i40e, rte_i40e_pmd.pci_drv);
-DRIVER_REGISTER_PCI_TABLE(net_i40e, pci_id_i40e_map);
+RTE_PMD_REGISTER_PCI(net_i40e, rte_i40e_pmd.pci_drv);
+RTE_PMD_REGISTER_PCI_TABLE(net_i40e, pci_id_i40e_map);
#ifndef I40E_GLQF_ORT
#define I40E_GLQF_ORT(_i) (0x00268900 + ((_i) * 4))
config_floating_veb(dev);
/* Clear PXE mode */
i40e_clear_pxe_mode(hw);
-
+ ret = i40e_dev_sync_phy_type(hw);
+ if (ret) {
+ PMD_INIT_LOG(ERR, "Failed to sync phy type: %d", ret);
+ goto err_sync_phy_type;
+ }
/*
* On X710, performance number is far from the expectation on recent
* firmware versions. The fix for this issue may not be integrated in
err_qp_pool_init:
err_parameter_init:
err_get_capabilities:
+err_sync_phy_type:
(void)i40e_shutdown_adminq(hw);
return ret;
if (link_speeds & ETH_LINK_SPEED_40G)
link_speed |= I40E_LINK_SPEED_40GB;
+ if (link_speeds & ETH_LINK_SPEED_25G)
+ link_speed |= I40E_LINK_SPEED_25GB;
if (link_speeds & ETH_LINK_SPEED_20G)
link_speed |= I40E_LINK_SPEED_20GB;
if (link_speeds & ETH_LINK_SPEED_10G)
I40E_AQ_PHY_FLAG_PAUSE_RX |
I40E_AQ_PHY_FLAG_LOW_POWER;
const uint8_t advt = I40E_LINK_SPEED_40GB |
+ I40E_LINK_SPEED_25GB |
I40E_LINK_SPEED_10GB |
I40E_LINK_SPEED_1GB |
I40E_LINK_SPEED_100MB;
struct rte_eth_conf *conf = &dev->data->dev_conf;
speed = i40e_parse_link_speeds(conf->link_speeds);
- abilities |= I40E_AQ_PHY_ENABLE_ATOMIC_LINK;
+ if (!I40E_PHY_TYPE_SUPPORT_25G(hw->phy.phy_types))
+ abilities |= I40E_AQ_PHY_ENABLE_ATOMIC_LINK;
if (!(conf->link_speeds & ETH_LINK_SPEED_FIXED))
abilities |= I40E_AQ_PHY_AN_ENABLED;
abilities |= I40E_AQ_PHY_LINK_ENABLED;
/* Skip changing speed on 40G interfaces, FW does not support */
- if (i40e_is_40G_device(hw->device_id)) {
+ if (I40E_PHY_TYPE_SUPPORT_40G(hw->phy.phy_types)) {
speed = I40E_LINK_SPEED_UNKNOWN;
abilities |= I40E_AQ_PHY_AN_ENABLED;
}
/* Apply link configure */
if (dev->data->dev_conf.link_speeds & ~(ETH_LINK_SPEED_100M |
ETH_LINK_SPEED_1G | ETH_LINK_SPEED_10G |
- ETH_LINK_SPEED_20G | ETH_LINK_SPEED_40G)) {
+ ETH_LINK_SPEED_20G | ETH_LINK_SPEED_25G |
+ ETH_LINK_SPEED_40G)) {
PMD_DRV_LOG(ERR, "Invalid link setting");
goto err_up;
}
i40e_dev_set_link_down(struct rte_eth_dev *dev)
{
uint8_t speed = I40E_LINK_SPEED_UNKNOWN;
- uint8_t abilities = I40E_AQ_PHY_ENABLE_ATOMIC_LINK;
+ uint8_t abilities = 0;
struct i40e_hw *hw = I40E_DEV_PRIVATE_TO_HW(dev->data->dev_private);
+ if (!I40E_PHY_TYPE_SUPPORT_25G(hw->phy.phy_types))
+ abilities = I40E_AQ_PHY_ENABLE_ATOMIC_LINK;
return i40e_phy_conf_link(hw, abilities, speed);
}
case I40E_LINK_SPEED_20GB:
link.link_speed = ETH_SPEED_NUM_20G;
break;
+ case I40E_LINK_SPEED_25GB:
+ link.link_speed = ETH_SPEED_NUM_25G;
+ break;
case I40E_LINK_SPEED_40GB:
link.link_speed = ETH_SPEED_NUM_40G;
break;
DEV_TX_OFFLOAD_TCP_CKSUM |
DEV_TX_OFFLOAD_SCTP_CKSUM |
DEV_TX_OFFLOAD_OUTER_IPV4_CKSUM |
- DEV_TX_OFFLOAD_TCP_TSO;
+ DEV_TX_OFFLOAD_TCP_TSO |
+ DEV_TX_OFFLOAD_VXLAN_TNL_TSO |
+ DEV_TX_OFFLOAD_GRE_TNL_TSO |
+ DEV_TX_OFFLOAD_IPIP_TNL_TSO |
+ DEV_TX_OFFLOAD_GENEVE_TNL_TSO;
dev_info->hash_key_size = (I40E_PFQF_HKEY_MAX_INDEX + 1) *
sizeof(uint32_t);
dev_info->reta_size = pf->hash_lut_size;
dev_info->max_tx_queues += dev_info->vmdq_queue_num;
}
- if (i40e_is_40G_device(hw->device_id))
+ if (I40E_PHY_TYPE_SUPPORT_40G(hw->phy.phy_types))
/* For XL710 */
dev_info->speed_capa = ETH_LINK_SPEED_40G;
+ else if (I40E_PHY_TYPE_SUPPORT_25G(hw->phy.phy_types))
+ /* For XXV710 */
+ dev_info->speed_capa = ETH_LINK_SPEED_25G;
else
/* For X710 */
dev_info->speed_capa = ETH_LINK_SPEED_1G | ETH_LINK_SPEED_10G;
if (err < 0)
return -ENOSYS;
- if (i40e_is_40G_device(hw->device_id)) {
+ if (I40E_PHY_TYPE_SUPPORT_40G(hw->phy.phy_types)) {
/* Configure flow control refresh threshold,
* the value for stat_tx_pause_refresh_timer[8]
* is used for global pause operation.
void *temp;
int ret;
struct i40e_mac_filter *f;
- uint16_t user_param = vsi->user_param;
+ uint16_t user_param;
if (!vsi)
return I40E_SUCCESS;
+ user_param = vsi->user_param;
+
pf = I40E_VSI_TO_PF(vsi);
hw = I40E_VSI_TO_HW(vsi);
/* handle the link up interrupt in an alarm callback */
i40e_dev_link_update(dev, 0);
- _rte_eth_dev_callback_process(dev, RTE_ETH_EVENT_INTR_LSC);
+ _rte_eth_dev_callback_process(dev, RTE_ETH_EVENT_INTR_LSC, NULL);
i40e_pf_enable_irq0(hw);
rte_intr_enable(&(dev->pci_dev->intr_handle));
return;
else
_rte_eth_dev_callback_process(dev,
- RTE_ETH_EVENT_INTR_LSC);
+ RTE_ETH_EVENT_INTR_LSC, NULL);
}
done:
#define I40E_GL_SWR_PM_UP_THR_SF_VALUE 0x06060606
#define I40E_GL_SWR_PM_UP_THR 0x269FBC
+static int
+i40e_dev_sync_phy_type(struct i40e_hw *hw)
+{
+ enum i40e_status_code status;
+ struct i40e_aq_get_phy_abilities_resp phy_ab;
+ int ret = -ENOTSUP;
+
+ status = i40e_aq_get_phy_capabilities(hw, false, true, &phy_ab,
+ NULL);
+
+ if (status)
+ return ret;
+
+ return 0;
+}
+
+
static void
i40e_configure_registers(struct i40e_hw *hw)
{
for (i = 0; i < RTE_DIM(reg_table); i++) {
if (reg_table[i].addr == I40E_GL_SWR_PM_UP_THR) {
- if (i40e_is_40G_device(hw->device_id)) /* For XL710 */
+ if (I40E_PHY_TYPE_SUPPORT_40G(hw->phy.phy_types) || /* For XL710 */
+ I40E_PHY_TYPE_SUPPORT_25G(hw->phy.phy_types)) /* For XXV710 */
reg_table[i].val =
I40E_GL_SWR_PM_UP_THR_SF_VALUE;
else /* For X710 */
git.droids-corp.org / dpdk.git / blobdiff