mac->ops.mdd_event = ixgbe_mdd_event_X550;
mac->ops.restore_mdd_vf = ixgbe_restore_mdd_vf_X550;
mac->ops.disable_rx = ixgbe_disable_rx_x550;
- if (hw->device_id == IXGBE_DEV_ID_X550EM_X_10G_T) {
+ switch (hw->device_id) {
+ case IXGBE_DEV_ID_X550EM_X_10G_T:
+ case IXGBE_DEV_ID_X550EM_A_10G_T:
hw->mac.ops.led_on = ixgbe_led_on_t_X550em;
hw->mac.ops.led_off = ixgbe_led_off_t_X550em;
+ break;
+ default:
+ break;
}
return ret_val;
}
STATIC s32 ixgbe_identify_phy_x550em(struct ixgbe_hw *hw)
{
switch (hw->device_id) {
+ case IXGBE_DEV_ID_X550EM_A_SFP:
+ hw->phy.phy_semaphore_mask = IXGBE_GSSR_TOKEN_SM;
+ if (hw->bus.lan_id)
+ hw->phy.phy_semaphore_mask |= IXGBE_GSSR_PHY1_SM;
+ else
+ hw->phy.phy_semaphore_mask |= IXGBE_GSSR_PHY0_SM;
+ return ixgbe_identify_module_generic(hw);
case IXGBE_DEV_ID_X550EM_X_SFP:
/* set up for CS4227 usage */
hw->phy.phy_semaphore_mask = IXGBE_GSSR_SHARED_I2C_SM;
ixgbe_setup_mux_ctl(hw);
ixgbe_check_cs4227(hw);
+ /* Fallthrough */
+ case IXGBE_DEV_ID_X550EM_A_SFP_N:
return ixgbe_identify_module_generic(hw);
break;
case IXGBE_DEV_ID_X550EM_X_KX4:
hw->phy.type = ixgbe_phy_x550em_kx4;
break;
case IXGBE_DEV_ID_X550EM_X_KR:
+ case IXGBE_DEV_ID_X550EM_A_KR:
+ case IXGBE_DEV_ID_X550EM_A_KR_L:
hw->phy.type = ixgbe_phy_x550em_kr;
break;
case IXGBE_DEV_ID_X550EM_X_1G_T:
case IXGBE_DEV_ID_X550EM_X_10G_T:
+ case IXGBE_DEV_ID_X550EM_A_1G_T:
+ case IXGBE_DEV_ID_X550EM_A_1G_T_L:
+ case IXGBE_DEV_ID_X550EM_A_10G_T:
return ixgbe_identify_phy_generic(hw);
default:
break;
mac->ops.acquire_swfw_sync = ixgbe_acquire_swfw_sync_X550em;
mac->ops.release_swfw_sync = ixgbe_release_swfw_sync_X550em;
}
+ if (hw->mac.type == ixgbe_mac_X550EM_a) {
+ mac->ops.read_iosf_sb_reg = ixgbe_read_iosf_sb_reg_x550a;
+ mac->ops.write_iosf_sb_reg = ixgbe_write_iosf_sb_reg_x550a;
+ }
mac->ops.get_media_type = ixgbe_get_media_type_X550em;
mac->ops.setup_sfp = ixgbe_setup_sfp_modules_X550em;
if (enable_eee) {
eeer |= (IXGBE_EEER_TX_LPI_EN | IXGBE_EEER_RX_LPI_EN);
- if (hw->device_id == IXGBE_DEV_ID_X550T) {
+ if (hw->mac.type == ixgbe_mac_X550) {
/* Advertise EEE capability */
hw->phy.ops.read_reg(hw, IXGBE_MDIO_AUTO_NEG_EEE_ADVT,
IXGBE_MDIO_AUTO_NEG_DEV_TYPE, &autoneg_eee_reg);
} else {
eeer &= ~(IXGBE_EEER_TX_LPI_EN | IXGBE_EEER_RX_LPI_EN);
- if (hw->device_id == IXGBE_DEV_ID_X550T) {
+ if (hw->mac.type == ixgbe_mac_X550) {
/* Disable advertised EEE capability */
hw->phy.ops.read_reg(hw, IXGBE_MDIO_AUTO_NEG_EEE_ADVT,
IXGBE_MDIO_AUTO_NEG_DEV_TYPE, &autoneg_eee_reg);
return ret;
}
+/**
+ * ixgbe_write_iosf_sb_reg_x550a - Writes a value to specified register
+ * of the IOSF device
+ * @hw: pointer to hardware structure
+ * @reg_addr: 32 bit PHY register to write
+ * @device_type: 3 bit device type
+ * @data: Data to write to the register
+ **/
+s32 ixgbe_write_iosf_sb_reg_x550a(struct ixgbe_hw *hw, u32 reg_addr,
+ u32 device_type, u32 data)
+{
+ struct ixgbe_hic_internal_phy_req write_cmd;
+ s32 status;
+ UNREFERENCED_1PARAMETER(device_type);
+
+ write_cmd.hdr.cmd = FW_INT_PHY_REQ_CMD;
+ write_cmd.hdr.buf_len = FW_INT_PHY_REQ_LEN;
+ write_cmd.port_number = hw->bus.lan_id;
+ write_cmd.command_type = FW_INT_PHY_REQ_WRITE;
+ write_cmd.address = (u16)reg_addr;
+ write_cmd.rsv1 = 0;
+ write_cmd.write_data = data;
+ write_cmd.pad = 0;
+
+ status = ixgbe_host_interface_command(hw, (u32 *)&write_cmd,
+ sizeof(write_cmd), IXGBE_HI_COMMAND_TIMEOUT, false);
+
+ return status;
+}
+
+/**
+ * ixgbe_read_iosf_sb_reg_x550a - Writes a value to specified register
+ * of the IOSF device.
+ * @hw: pointer to hardware structure
+ * @reg_addr: 32 bit PHY register to write
+ * @device_type: 3 bit device type
+ * @data: Pointer to read data from the register
+ **/
+s32 ixgbe_read_iosf_sb_reg_x550a(struct ixgbe_hw *hw, u32 reg_addr,
+ u32 device_type, u32 *data)
+{
+ struct ixgbe_hic_internal_phy_req read_cmd;
+ s32 status;
+ UNREFERENCED_1PARAMETER(device_type);
+
+ read_cmd.hdr.cmd = FW_INT_PHY_REQ_CMD;
+ read_cmd.hdr.buf_len = FW_INT_PHY_REQ_LEN;
+ read_cmd.port_number = hw->bus.lan_id;
+ read_cmd.command_type = FW_INT_PHY_REQ_READ;
+ read_cmd.address = (u16)reg_addr;
+ read_cmd.rsv1 = 0;
+ read_cmd.write_data = 0;
+ read_cmd.pad = 0;
+
+ status = ixgbe_host_interface_command(hw, (u32 *)&read_cmd,
+ sizeof(read_cmd), IXGBE_HI_COMMAND_TIMEOUT, true);
+
+ /* Extract the register value from the response. */
+ *data = ((struct ixgbe_hic_internal_phy_resp *)&read_cmd)->read_data;
+
+ return status;
+}
+
/**
* ixgbe_disable_mdd_X550
* @hw: pointer to hardware structure
switch (hw->device_id) {
case IXGBE_DEV_ID_X550EM_X_KR:
case IXGBE_DEV_ID_X550EM_X_KX4:
+ case IXGBE_DEV_ID_X550EM_A_KR:
+ case IXGBE_DEV_ID_X550EM_A_KR_L:
media_type = ixgbe_media_type_backplane;
break;
case IXGBE_DEV_ID_X550EM_X_SFP:
+ case IXGBE_DEV_ID_X550EM_A_SFP:
+ case IXGBE_DEV_ID_X550EM_A_SFP_N:
+ case IXGBE_DEV_ID_X550EM_A_QSFP:
+ case IXGBE_DEV_ID_X550EM_A_QSFP_N:
media_type = ixgbe_media_type_fiber;
break;
case IXGBE_DEV_ID_X550EM_X_1G_T:
case IXGBE_DEV_ID_X550EM_X_10G_T:
+ case IXGBE_DEV_ID_X550EM_A_1G_T:
+ case IXGBE_DEV_ID_X550EM_A_1G_T_L:
+ case IXGBE_DEV_ID_X550EM_A_10G_T:
media_type = ixgbe_media_type_copper;
break;
default:
IXGBE_MDIO_GLOBAL_ALARM_1_INT)))
return status;
- /* High temperature failure alarm triggered */
+ /* Global alarm triggered */
status = hw->phy.ops.read_reg(hw, IXGBE_MDIO_GLOBAL_ALARM_1,
IXGBE_MDIO_VENDOR_SPECIFIC_1_DEV_TYPE,
®);
/* power down the PHY in case the PHY FW didn't already */
ixgbe_set_copper_phy_power(hw, false);
return IXGBE_ERR_OVERTEMP;
+ } else if (reg & IXGBE_MDIO_GLOBAL_ALM_1_DEV_FAULT) {
+ /* device fault alarm triggered */
+ status = hw->phy.ops.read_reg(hw, IXGBE_MDIO_GLOBAL_FAULT_MSG,
+ IXGBE_MDIO_VENDOR_SPECIFIC_1_DEV_TYPE,
+ ®);
+
+ if (status != IXGBE_SUCCESS)
+ return status;
+
+ /* if device fault was due to high temp alarm handle and exit */
+ if (reg == IXGBE_MDIO_GLOBAL_FAULT_MSG_HI_TMP) {
+ /* power down the PHY in case the PHY FW didn't */
+ ixgbe_set_copper_phy_power(hw, false);
+ return IXGBE_ERR_OVERTEMP;
+ }
}
/* Vendor alarm 2 triggered */
if (status != IXGBE_SUCCESS)
return status;
- /* Enables high temperature failure alarm */
+ /* Enable high temperature failure and global fault alarms */
status = hw->phy.ops.read_reg(hw, IXGBE_MDIO_GLOBAL_INT_MASK,
IXGBE_MDIO_VENDOR_SPECIFIC_1_DEV_TYPE,
®);
if (status != IXGBE_SUCCESS)
return status;
- reg |= IXGBE_MDIO_GLOBAL_INT_HI_TEMP_EN;
+ reg |= (IXGBE_MDIO_GLOBAL_INT_HI_TEMP_EN |
+ IXGBE_MDIO_GLOBAL_INT_DEV_FAULT_EN);
status = hw->phy.ops.write_reg(hw, IXGBE_MDIO_GLOBAL_INT_MASK,
IXGBE_MDIO_VENDOR_SPECIFIC_1_DEV_TYPE,
git.droids-corp.org / dpdk.git / blobdiff