net/mlx5: add Tx/Rx burst function selection wrapper

[dpdk.git] / drivers / net / mlx5 / mlx5.h

diff --git a/drivers/net/mlx5/mlx5.h b/drivers/net/mlx5/mlx5.h
index fb4f95a..3dca03d 100644 (file)
--- a/drivers/net/mlx5/mlx5.h
+++ b/drivers/net/mlx5/mlx5.h
@@ -68,6 +68,11 @@
 #include "mlx5_autoconf.h"
 #include "mlx5_defs.h"
 
+#if !defined(HAVE_VERBS_IBV_EXP_CQ_COMPRESSED_CQE) || \
+       !defined(HAVE_VERBS_MLX5_ETH_VLAN_INLINE_HEADER_SIZE)
+#error Mellanox OFED >= 3.3 is required, please refer to the documentation.
+#endif
+
 enum {
        PCI_VENDOR_ID_MELLANOX = 0x15b3,
 };
@@ -104,7 +109,7 @@ struct priv {
        unsigned int hw_vlan_strip:1; /* VLAN stripping is supported. */
        unsigned int hw_fcs_strip:1; /* FCS stripping is supported. */
        unsigned int hw_padding:1; /* End alignment padding is supported. */
-       unsigned int vf:1; /* This is a VF device. */
+       unsigned int sriov:1; /* This is a VF or PF with VF devices. */
        unsigned int mps:1; /* Whether multi-packet send is supported. */
        unsigned int pending_alarm:1; /* An alarm is pending. */
        /* RX/TX queues. */
@@ -172,6 +177,7 @@ struct priv *mlx5_get_priv(struct rte_eth_dev *dev);
 int mlx5_is_secondary(void);
 int priv_get_ifname(const struct priv *, char (*)[IF_NAMESIZE]);
 int priv_ifreq(const struct priv *, int req, struct ifreq *);
+int priv_get_num_vfs(struct priv *, uint16_t *);
 int priv_get_mtu(struct priv *, uint16_t *);
 int priv_set_flags(struct priv *, unsigned int, unsigned int);
 int mlx5_dev_configure(struct rte_eth_dev *);
@@ -190,6 +196,8 @@ void priv_dev_interrupt_handler_install(struct priv *, struct rte_eth_dev *);
 int mlx5_set_link_down(struct rte_eth_dev *dev);
 int mlx5_set_link_up(struct rte_eth_dev *dev);
 struct priv *mlx5_secondary_data_setup(struct priv *priv);
+void priv_select_tx_function(struct priv *);
+void priv_select_rx_function(struct priv *);
 
 /* mlx5_mac.c */