net/hns3: support SVE Rx

[dpdk.git] / drivers / net / mlx5 / mlx5_rxq.c

diff --git a/drivers/net/mlx5/mlx5_rxq.c b/drivers/net/mlx5/mlx5_rxq.c
index 9f68a5c..f1d8373 100644 (file)
--- a/drivers/net/mlx5/mlx5_rxq.c
+++ b/drivers/net/mlx5/mlx5_rxq.c
@@ -513,7 +513,7 @@ mlx5_rx_queue_stop_primary(struct rte_eth_dev *dev, uint16_t idx)
        int ret;
 
        MLX5_ASSERT(rte_eal_process_type() == RTE_PROC_PRIMARY);
-       ret = priv->obj_ops.rxq_obj_modify(rxq_ctrl->obj, false);
+       ret = priv->obj_ops.rxq_obj_modify(rxq_ctrl->obj, MLX5_RXQ_MOD_RDY2RST);
        if (ret) {
                DRV_LOG(ERR, "Cannot change Rx WQ state to RESET:  %s",
                        strerror(errno));
@@ -562,7 +562,7 @@ mlx5_rx_queue_stop(struct rte_eth_dev *dev, uint16_t idx)
         * The routine pointer depends on the process
         * type, should perform check there.
         */
-       if (pkt_burst == mlx5_rx_burst) {
+       if (pkt_burst == mlx5_rx_burst_vec) {
                DRV_LOG(ERR, "Rx queue stop is not supported "
                        "for vectorized Rx");
                rte_errno = EINVAL;
@@ -612,7 +612,7 @@ mlx5_rx_queue_start_primary(struct rte_eth_dev *dev, uint16_t idx)
        /* Reset RQ consumer before moving queue ro READY state. */
        *rxq->rq_db = rte_cpu_to_be_32(0);
        rte_io_wmb();
-       ret = priv->obj_ops.rxq_obj_modify(rxq_ctrl->obj, true);
+       ret = priv->obj_ops.rxq_obj_modify(rxq_ctrl->obj, MLX5_RXQ_MOD_RST2RDY);
        if (ret) {
                DRV_LOG(ERR, "Cannot change Rx WQ state to READY:  %s",
                        strerror(errno));
@@ -1090,7 +1090,7 @@ mlx5_mprq_buf_init(struct rte_mempool *mp, void *opaque_arg,
 
        memset(_m, 0, sizeof(*buf));
        buf->mp = mp;
-       rte_atomic16_set(&buf->refcnt, 1);
+       __atomic_store_n(&buf->refcnt, 1, __ATOMIC_RELAXED);
        for (j = 0; j != strd_n; ++j) {
                shinfo = &buf->shinfos[j];
                shinfo->free_cb = mlx5_mprq_buf_free_cb;