#include <inttypes.h>
-#include <rte_ethdev_pci.h>
+#include <ethdev_pci.h>
#include <rte_io.h>
#include <rte_malloc.h>
#include <rte_mbuf.h>
if (dev->npc_flow.switch_header_type == 0)
return 0;
- if (dev->npc_flow.switch_header_type == OTX2_PRIV_FLAGS_LEN_90B &&
- !otx2_dev_is_sdp(dev)) {
- otx2_err("chlen90b is not supported on non-SDP device");
- return -EINVAL;
- }
-
/* Notify AF about higig2 config */
req = otx2_mbox_alloc_msg_npc_set_pkind(mbox);
req->mode = dev->npc_flow.switch_header_type;
+ if (dev->npc_flow.switch_header_type == OTX2_PRIV_FLAGS_CH_LEN_90B) {
+ req->mode = OTX2_PRIV_FLAGS_CUSTOM;
+ req->pkind = NPC_RX_CHLEN90B_PKIND;
+ } else if (dev->npc_flow.switch_header_type ==
+ OTX2_PRIV_FLAGS_CH_LEN_24B) {
+ req->mode = OTX2_PRIV_FLAGS_CUSTOM;
+ req->pkind = NPC_RX_CHLEN24B_PKIND;
+ } else if (dev->npc_flow.switch_header_type ==
+ OTX2_PRIV_FLAGS_EXDSA) {
+ req->mode = OTX2_PRIV_FLAGS_CUSTOM;
+ req->pkind = NPC_RX_EXDSA_PKIND;
+ } else if (dev->npc_flow.switch_header_type ==
+ OTX2_PRIV_FLAGS_VLAN_EXDSA) {
+ req->mode = OTX2_PRIV_FLAGS_CUSTOM;
+ req->pkind = NPC_RX_VLAN_EXDSA_PKIND;
+ }
+
if (enable == 0)
req->mode = OTX2_PRIV_FLAGS_DEFAULT;
req->dir = PKIND_RX;
return rc;
req = otx2_mbox_alloc_msg_npc_set_pkind(mbox);
req->mode = dev->npc_flow.switch_header_type;
+ if (dev->npc_flow.switch_header_type == OTX2_PRIV_FLAGS_CH_LEN_90B ||
+ dev->npc_flow.switch_header_type == OTX2_PRIV_FLAGS_CH_LEN_24B)
+ req->mode = OTX2_PRIV_FLAGS_DEFAULT;
+
if (enable == 0)
req->mode = OTX2_PRIV_FLAGS_DEFAULT;
req->dir = PKIND_TX;
.tx_done_cleanup = otx2_nix_tx_done_cleanup,
.set_queue_rate_limit = otx2_nix_tm_set_queue_rate_limit,
.pool_ops_supported = otx2_nix_pool_ops_supported,
- .filter_ctrl = otx2_nix_dev_filter_ctrl,
+ .flow_ops_get = otx2_nix_dev_flow_ops_get,
.get_module_info = otx2_nix_get_module_info,
.get_module_eeprom = otx2_nix_get_module_eeprom,
.fw_version_get = otx2_nix_fw_version_get,