* (MTU + Maximum L2 Header Size + 2) / ETH_RX_MAX_BUFF_PER_PKT
* 3) In regular mode - minimum rx_buf_size should be
* (MTU + Maximum L2 Header Size + 2)
- * In above cases +2 corrosponds to 2 bytes padding in front of L2
+ * In above cases +2 corresponds to 2 bytes padding in front of L2
* header.
* 4) rx_buf_size should be cacheline-size aligned. So considering
* criteria 1, we need to adjust the size to floor instead of ceil,
if (dev->data->scattered_rx) {
/* per HW limitation, only ETH_RX_MAX_BUFF_PER_PKT number of
- * bufferes can be used for single packet. So need to make sure
+ * buffers can be used for single packet. So need to make sure
* mbuf size is sufficient enough for this.
*/
if ((mbufsz * ETH_RX_MAX_BUFF_PER_PKT) <
/* Fix up RX buffer size */
bufsz = (uint16_t)rte_pktmbuf_data_room_size(mp) - RTE_PKTMBUF_HEADROOM;
- /* cache align the mbuf size to simplfy rx_buf_size calculation */
+ /* cache align the mbuf size to simplify rx_buf_size calculation */
bufsz = QEDE_FLOOR_TO_CACHE_LINE_SIZE(bufsz);
if ((rxmode->offloads & RTE_ETH_RX_OFFLOAD_SCATTER) ||
(max_rx_pktlen + QEDE_ETH_OVERHEAD) > bufsz) {
}
}
- /* Request number of bufferes to be allocated in next loop */
+ /* Request number of buffers to be allocated in next loop */
rxq->rx_alloc_count = rx_alloc_count;
rxq->rcv_pkts += rx_pkt;
}
}
- /* Request number of bufferes to be allocated in next loop */
+ /* Request number of buffers to be allocated in next loop */
rxq->rx_alloc_count = rx_alloc_count;
rxq->rcv_pkts += rx_pkt;
/* Inner L2 header size in two byte words */
inner_l2_hdr_size = (mbuf->l2_len -
MPLSINUDP_HDR_SIZE) / 2;
- /* Inner L4 header offset from the beggining
+ /* Inner L4 header offset from the beginning
* of inner packet in two byte words
*/
inner_l4_hdr_offset = (mbuf->l2_len -