* controller's datasheet and supporting DPDK documentation for guidance
* on how these parameters should be set.
*/
-/* RX ring configuration */
-static const struct rte_eth_rxconf rx_conf = {
- .rx_thresh = {
- .pthresh = 8, /* Ring prefetch threshold */
- .hthresh = 8, /* Ring host threshold */
- .wthresh = 4, /* Ring writeback threshold */
- },
- .rx_free_thresh = 0, /* Immediately free RX descriptors */
-};
-
-/*
- * These default values are optimized for use with the Intel(R) 82599 10 GbE
- * Controller and the DPDK ixgbe PMD. Consider using other values for other
- * network controllers and/or network drivers.
- */
-/* TX ring configuration */
-static const struct rte_eth_txconf tx_conf = {
- .tx_thresh = {
- .pthresh = 36, /* Ring prefetch threshold */
- .hthresh = 0, /* Ring host threshold */
- .wthresh = 0, /* Ring writeback threshold */
- },
- .tx_free_thresh = 0, /* Use PMD default values */
- .tx_rs_thresh = 0, /* Use PMD default values */
-};
/* Options for configuring ethernet port */
static const struct rte_eth_conf port_conf = {
(unsigned)port, ret);
ret = rte_eth_rx_queue_setup(port, 0, NB_RXD, rte_eth_dev_socket_id(port),
- &rx_conf, pktmbuf_pool);
+ NULL,
+ pktmbuf_pool);
if (ret < 0)
FATAL_ERROR("Could not setup up RX queue for port%u (%d)",
(unsigned)port, ret);
ret = rte_eth_tx_queue_setup(port, 0, NB_TXD, rte_eth_dev_socket_id(port),
- &tx_conf);
+ NULL);
if (ret < 0)
FATAL_ERROR("Could not setup up TX queue for port%u (%d)",
(unsigned)port, ret);
/* Get number of ports found in scan */
nb_sys_ports = rte_eth_dev_count();
if (nb_sys_ports == 0)
- FATAL_ERROR("No supported Ethernet devices found - check that "
- "CONFIG_RTE_LIBRTE_IGB_PMD=y and/or "
- "CONFIG_RTE_LIBRTE_IXGBE_PMD=y in the config file");
+ FATAL_ERROR("No supported Ethernet device found");
/* Find highest port set in portmask */
for (high_port = (sizeof(ports_mask) * 8) - 1;
(high_port != 0) && !(ports_mask & (1 << high_port));